期刊文献+

水煤膏压力泌水特性与可泵性分析 被引量:1

Coal-water Paste Water-seeping Properties under Pressure and Its Pumpability
下载PDF
导出
摘要 通过实验研究了水煤膏的压力泌水特性 ,分析了颗粒粒度分布、含水量等对水煤膏的泵送特性的影响 ,并结合水煤膏塌落度指标 ,提出了水煤膏可泵性的评价指标。结果表明 :水煤膏的可泵性可以用塌落度和压力泌水总量两个指标表征。可泵性好的水煤膏其塌落度范围为 8~ 2 4cm ,相应的相对泌水率和泌水总量分别为S10 ≤ 40 %,V =70~ 110ml。 Water-seeping properties of coal-water paste (CWP) under pressure are studied experimentally with the influence of particle size distribution and water content, etc on the pumping properties of CWP being analyzed. In conjunction with a CWP slump index proposed is a pumpability evaluation index of the CWP. It is found that the pumpability of the CWP can be featured by two indexes, namely, the slump and the total quantity of water seeping under pressure. The CWP with a good pumpability has a slump in the range of 8 - 24cm. The corresponding relative water seeping rate and water seeping quantity are respectively S10&le40% and V = 70 - 110 ml.
作者 卢平 章名耀
出处 《热能动力工程》 EI CAS CSCD 北大核心 2003年第1期78-81,共4页 Journal of Engineering for Thermal Energy and Power
关键词 水煤膏 压力泌水特性 可泵性 颗粒粒度 含水量 电厂 Particle size analysis Pressure effects Seepage
  • 相关文献

参考文献5

  • 1赵惠林,陈英燕.泥石流细颗粒浆体的有效浓度[J].泥沙研究,1992,18(2):20-25. 被引量:5
  • 2张晏清,黄士元.混凝土可泵性分析与评价指标[J].混凝土与水泥制品,1989(3):4-8. 被引量:8
  • 3蒋旭光.粗颗粒煤水混合物的稠度与析水特性[J].增压流化床联合循环发电技术,1993,(2):11-14.
  • 4吴忆峰.水煤浆粒度配比的研究及其对点火性能的影响[J].工程热物理学报,1984,5(2):192-198.
  • 5孟令杰.煤水混合物(水煤膏)稳定性评价研究[J].洁净煤燃烧与发电技术,1996,(3):5-8.

二级参考文献1

  • 1费祥俊,朱平一.泥石流的粘性及其确定方法[J]铁道工程学报,1986(04).

共引文献11

同被引文献25

  • 1卢平,章名耀.水煤膏喷嘴雾化机理及影响因素分析[J].南京师范大学学报(工程技术版),2002,2(2):61-65. 被引量:1
  • 2张荣增.水煤浆制浆技术[M].北京:科学出版社,1996..
  • 3章名耀.增压流化床联合循环发电技术[M].南京:东南大学出版社,1998..
  • 4蒋旭光 等.用作增压流化床燃料的粗颗粒煤水混合物的稳定性及流变性的研究[J].洁净煤燃烧与发电技术,1994,(3):13-17.
  • 5孟令杰.煤水混合物(水煤膏)稳定性评价研究[J].洁净煤燃烧与发电技术,1996,(3):5-8.
  • 6[6]Dinger, B.R. et al. stability of a coal-water slurry[A],Co-Al, Proc. of 4th Intern. Symp. on Coal Slurry Combustion[C], 1982.
  • 7[7]沈雅闲.水煤浆沉降稳定性评价研究,水煤浆技术译文集[M].北京:中国煤炭加工利用协会,1987.
  • 8[8]Batra S. K. , et al. Rheology and pumping characteristics of coal water slurry fuels prepared in Columbia Chase Integrator[A], Proc. of 5th Intern. Symp. on Coal Slurry Combustion[C], 1983.
  • 9[12]Takezaki H, Otani Y, Yoshioka S, et al. A method of state feeding coal-water paste into pressurized fluidized bed combustor [A]. In: Rubw L and Commonwealth G eds. Proc of 12th International Conference on FBC [C].San Diego, California, USA: ASME, 1993. 397-401.
  • 10[13]Antonini G, Francois O, et al. A direct rheological characterization of highly loaded coal-water slurries flowing through pipes[A]. Proc. of 6th Inter. Symp.on Coal Slurry Combustion Technology[C]. Orlando,1984: 266-288.

引证文献1

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部