摘要
研究了微线段齿轮的创成方法,确定了“包络-旋切”两步加工法和加工刀具的选取方法,建立了旋切法数控加工微线段齿轮的运动控制模型,并通过计算机仿真进行了验证。
The generation of logix gear tooth profile is studied. 'Envelop-rotation tangency ' two-step method of NC generation of the logix gear is brought out and the selection principle of the machining cutter is developed. The movement control model of generation of the logix gear based on the rotation tangency machining method is set up. Then the simulation of the machining process is done.
出处
《机械工程学报》
EI
CAS
CSCD
北大核心
2003年第1期143-148,共6页
Journal of Mechanical Engineering
基金
国家自然科学基金资助项目(59905018)。
