摘要
根据制造重型液压旋回破碎机的生产经验,归纳总结出底架加工过程中的关键控制点,针对大直径小角度锥面的尺寸测量、粗加工护板孔位初定、传动轴孔加工偏移量控制,合理设计工艺流程,设计出简易测量工装,保证了底架加工精度,提高了生产效率。
According to the production experience of the heavy hydraulic gyratory crusher,key control points on machining its chassis were summarized.In view of dimensional measurement of taper surface with large diameter and small angle,preliminary positioning of protective board hole for rough machining,control of offset on machining drive shaft hole,reasonable process flow was designed.In addition,simple measurement fixture was designed,so as to guarantee the machining precision and enhance the productivity.
作者
祝兴华
刘延民
杨菲
ZHU Xinghua;LIU Yanmin;YANG Fei(Luoyang Mining Machinery Engineering Design Institute Co.,Ltd.,Luoyang 471039,Henan,China;State Key Laboratory of Mining Heavy Equipment,Luoyang 471039,Henan,China)
出处
《矿山机械》
2019年第5期24-27,共4页
Mining & Processing Equipment
关键词
旋回破碎机
架体
锥孔测量
工艺流程
gyratory crusher
chassis
measurement of taper hole
process flow