期刊文献+

两种典型双棒串接Nd∶YAG激光器谐振腔的分析 被引量:5

Analysis of two typical resonators for two-rod Nd∶YAG laser
下载PDF
导出
摘要 采用矩阵光学的方法对两种典型双棒串接Nd∶YAG激光器谐振腔进行了研究 ,分析了两种腔型的稳定区间和热焦距 f的关系 ,并推导出两种腔型的模体积计算公式 .在 f =0 .1 6m和 f =0 .5 0m两种情况下绘出了两种腔型的模体积与稳定区间的关系图 .结果表明 :谐振腔内棒的位置直接影响了腔的稳定范围和模体积 ,对两种典型谐振腔来说 ,等间距腔的稳定范围和模体积要大得多 ,在输入功率相同时 。 Two typical resonators for two rod Nd:YAG laser were investigated by matrix optics. The relation between stability zone and thermal lens focus f was analyzed, and the formula of mode volume for the two typical resonators was calculated. The relative figures of mode volume and stability zone were presented when f =0.16?m and f =0.50?m. It was shown that the stability zone and mode volume were affected by the position of rods. The stability zone and mode volume of equal interval resonator were larger than another resonator. And the equal interval resonator can get higher output power.
出处 《华中科技大学学报(自然科学版)》 EI CAS CSCD 北大核心 2003年第4期96-98,共3页 Journal of Huazhong University of Science and Technology(Natural Science Edition)
基金 国家自然科学基金资助项目 (6 0 1 780 0 4 )
关键词 ND:YAG激光器 热焦距 稳定区间 模体积 谐振腔 固体激光器 矩阵光学方法 Nd∶YAG laser thermal lens focus stability zone mode volume
  • 相关文献

同被引文献38

  • 1郑伟,余建华,谢武,祝强.高功率半导体侧向泵浦固体激光器热效应对光束质量的影响[J].激光杂志,2006,27(5):22-23. 被引量:7
  • 2翟华金,李宝其,陈聪.激光棒位置对热不灵敏凹凸腔运转特性的影响[J].光学学报,1994,14(10):1026-1030. 被引量:4
  • 3李世忱,倪文俊,杨巍,胡国绛,张润.低热敏激光谐振腔理论和实验[J].物理学报,1989,38(4):567-572. 被引量:8
  • 4吕百达.固体激光器[M].北京:北京邮电大学出版社,2002..
  • 5DRIEDGER K P,IFFLANDER R M,WEBER H.Multirod Resonators for High Power Solid-State Lasers with Improved Beam Quality[J].IEEE J Quant Electr,1988,24(4):665-667.
  • 6KORTZ H P,IFFLANDER R M,WESTER H,et al.Stability and Beam Divergence of Multim ode Lasers with Internal Variable Lenses[J].Appl Opt,1981,20(23):4124-4130.
  • 7IFFLANDER R.Solider-state Laser for Material Processing[M].Berlin:springerVerlag,2001.
  • 8吕百达.激光光学[M].成都:四川大学出版社,1992.53-57.
  • 9WANG W X,WANG L X,GUO N,Research and development of Nd:YAG laser engraving system[C].Proceedings of SPIE-The International Society for Optical Engineering,1996,2888:207-212.
  • 10ESTRELA R,JOES A.R C,C.SORIANO J.Laser beam characteristics related to the design of a system to improve engraving process[C].Proc.SPIE,1996,2870:410-416.

引证文献5

二级引证文献11

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部