摘要
0 Introduction In reference [1], the author introduced the manufacturing model of front cutting face, and pointed out the cutting edge curve for's' shaped skew curve on the sphere. Apparently, the rear cutting face should go through cutting edge curve, and should have sufficient relief angle. On this basis, the article introduces the
出处
《哈尔滨工业大学学报》
EI
CAS
CSCD
北大核心
1992年第6期95-97,共3页
Journal of Harbin Institute of Technology
基金
The study is supported by science fund of Heilongjiang provine
关键词
磨削
铣刀
数学模型
Spherical cutter
mathematical model
machinery manufacturing
