基于COM技术的开放式卷板数控系统的研究与开发

Research on the open architecture special bending CNC system based on COM

分析了基于COM技术的开放式数控系统的特点,将COM技术用于卷板数控系统,使用多轴控制器和工业控制计算机,用模块和组件对它的硬件和软件设计作了详细的论述,完成卷板数控系统实时多任务的要求,使系统具有开放性,并应用于工程实践。

In this paper, the characteristics of an open architecture CNC system based on COM is researched, The paper develops the special bending NC system based on COM . And applies PMAC and industrial PC , describes it hardware and software by modules . The practice proves that the real-time multi-task control of CNC system can be achieved, and tapped CNC system has open using methods and technology.