摘要
Two type zirconia (monoclinic and tetragonal phase ZrO2) carriers were synthesized via hydrothermal route, and nano-sized zirconia supported nickel catalysts were prepared by incipient impregnation then followed thermal treatment at 300?°C to 500?°C, for the CO2selective hydrogenation to synthetic natural gas (SNG). The catalysts were characterized by XRD, CO2-TPD-MS, XPS, TPSR (CH4, CO2) techniques. For comparison, the catalyst NZ-W-400 (monoclinic) synthesized in water solvent exhibited a better catalytic activity than the catalyst NZ-M-400 (tetragonal) prepared in methanol solvent. The catalyst NZ-W-400 displayed more H2absorbed sites, more basic sites and a lower temperature of initial CO2activation. Then, the thermal treatment of monoclinic ZrO2supported nickel precursor was manufactured at three temperature of 350, 400, 500?°C. The TPSR experiments displayed that there were the lower temperature for CO2activation and initial conversion (185?°C) as well as the lower peak temperature of CH4generation (318?°C), for the catalyst calcined at 500?°C. This sample contained the more basic sites and the higher catalytic activity, evidenced byCO2-TPD-MS and performance measurement. As for the NZ-W-350 sample, which exhibited the less basic sites and the lower catalytic activity, its initial temperature for CO2activation and conversion was higher (214?°C) as well as the higher peak temperature of CH4formation (382?°C). ? 2016 Science Press
Two type zirconia (monoclinic and tetragonal phase ZrO2) carriers were synthesized via hydrothermal route, and nano-sized zirconia supported nickel catalysts were prepared by incipient impregnation then followed thermal treatment at 300 °C to 500 °C, for the CO2selective hydrogenation to synthetic natural gas (SNG). The catalysts were characterized by XRD, CO2-TPD-MS, XPS, TPSR (CH4, CO2) techniques. For comparison, the catalyst NZ-W-400 (monoclinic) synthesized in water solvent exhibited a better catalytic activity than the catalyst NZ-M-400 (tetragonal) prepared in methanol solvent. The catalyst NZ-W-400 displayed more H2absorbed sites, more basic sites and a lower temperature of initial CO2activation. Then, the thermal treatment of monoclinic ZrO2supported nickel precursor was manufactured at three temperature of 350, 400, 500 °C. The TPSR experiments displayed that there were the lower temperature for CO2activation and initial conversion (185 °C) as well as the lower peak temperature of CH4generation (318 °C), for the catalyst calcined at 500 °C. This sample contained the more basic sites and the higher catalytic activity, evidenced byCO2-TPD-MS and performance measurement. As for the NZ-W-350 sample, which exhibited the less basic sites and the lower catalytic activity, its initial temperature for CO2activation and conversion was higher (214 °C) as well as the higher peak temperature of CH4formation (382 °C). © 2016 Science Press
基金
supported by National Natural Science Foundation of China (21476145)
