摘要
分析了通过调节辊缝获得期望的平均壁厚时钢管的横断面特性与辊缝调整量之间的关系,并由此推导出给定壁厚范围时满足某一附加公差率的芯棒直径计算公式。最后结合某Φ180mm连轧管机组提供的壁厚和芯棒直径系列,对芯棒直径系列的设计和选用方法进行了探讨。
The paper analyze the relations between the section characteristics of the tubes and the roll gap adjustment,and deduces the calculating equations for mandrel diameter under the conditions of a given wall thickness range and a certain additional deviationFinally,by considering an actual mandrel series in the production of a Φ180mm mandrel pipe mill,the paper further gives a beneficial discussion on the designing and selecting methods for mandrel diameter series
出处
《轧钢》
2003年第5期10-12,共3页
Steel Rolling
关键词
连轧管机
限动芯棒
直径
壁厚
mandrel pipe mill
retained mandrel
diameter
wall thickness