摘要
Reduction of drag torque in disengaged wet clutches is essential for transmission research because it is one of the potentials of e ciency improvement. Aeration of oil film between two closely rotating plates promotes the decrease of drag torque at high speed region. The e ects of surface tension and static contact angles during aeration are nonnegligible showed by test results. The traditional lubrication model does not adequately predict the experimental results with di erent surface tension and contact angles during aeration. Hence, in this present paper, contact angles between Aluminum and Teflon materials were firstly measured, and the drag torques under two di erent contact angles were examined experimentally. An improved lubrication model of drag torque based on Navier–Stokes equations at the gas-liquid interface was built. The lubrication boundary condition was modified to introduce the e ects of surface tension and contact angle. The model shows that the e ects at the beginning of aeration of oil film are significant. These e ects almost occur at stationary plate due to low Reynolds number and Weber number. The model shows that an increase in the surface tension promotes aeration, but does not a ect the peak drag torque. Increasing contact angle also promotes the aeration, and accelerates the decrease of drag torque. The larger contact angle is, the smaller the peak drag torque will be. A computational fluid dynamics(CFD) model based on volume of fluid(VOF) method was presented to validate the interface shape when aeration occurs. The model prediction has a good agreement with experimental observations for Aluminum plates and Teflon plates. The modified lubrication model of drag torque gives a convenient description of the e ects of surface tension and contact angel, and lays down a frame to understand the beginning of aeration.
Reduction of drag torque in disengaged wet clutches is essential for transmission research because it is one of the potentials of e ciency improvement. Aeration of oil film between two closely rotating plates promotes the decrease of drag torque at high speed region. The e ects of surface tension and static contact angles during aeration are nonnegligible showed by test results. The traditional lubrication model does not adequately predict the experimental results with di erent surface tension and contact angles during aeration. Hence, in this present paper, contact angles between Aluminum and Teflon materials were firstly measured, and the drag torques under two di erent contact angles were examined experimentally. An improved lubrication model of drag torque based on Navier–Stokes equations at the gas-liquid interface was built. The lubrication boundary condition was modified to introduce the e ects of surface tension and contact angle. The model shows that the e ects at the beginning of aeration of oil film are significant. These e ects almost occur at stationary plate due to low Reynolds number and Weber number. The model shows that an increase in the surface tension promotes aeration, but does not a ect the peak drag torque. Increasing contact angle also promotes the aeration, and accelerates the decrease of drag torque. The larger contact angle is, the smaller the peak drag torque will be. A computational fluid dynamics(CFD) model based on volume of fluid(VOF) method was presented to validate the interface shape when aeration occurs. The model prediction has a good agreement with experimental observations for Aluminum plates and Teflon plates. The modified lubrication model of drag torque gives a convenient description of the e ects of surface tension and contact angel, and lays down a frame to understand the beginning of aeration.
基金
Supported by National Natural Science Foundation of China(Grant No.51305032)