摘要
树脂充模是RTM工艺成型过程中的重要一环。研究了RTM工艺树脂流动过程的特点,建立了树脂渗流控制方程。采用贴体坐标/有限差分法模拟了树脂渗流过程,给出了不同时刻树脂流动前沿曲线及终止时刻压力场分布,计算结果与试验结果吻合良好。
The molding filling process is a very important phase in RTM. This paper studies the RTM process and its resin flow process. The governing equations of resin flow are built up. The boundary-fitted coordinate system and the finite difference method are employed for simulating the resin flow process. The successive resin flow front position and the pressure field distribution at the final stage are obtained, and a good agreement is found between the numerical simulation result and the experimental result.
出处
《复合材料学报》
EI
CAS
CSCD
北大核心
2003年第4期77-80,共4页
Acta Materiae Compositae Sinica
基金
国家自然科学基金重点资助项目(59833110)
关键词
RTM
树脂流动
数值模拟
贴体坐标
Computer simulation
Finite difference method
Flow of fluids
Pressure distribution
