期刊文献+

一种用于估计测量设备之间时间偏差的算法

An Algorithm to Estimate Time Offset between Measurement Devices
下载PDF
导出
摘要 该文分析了单向时延测量的必要性,并指出测量设备之间存在的时间偏差给时延测量带来了误差;该文提出一种算法用来估计测量设备间存在的时间偏差,利用算法估计的时间偏差来校正测量结果,达到准确测量单向时延的目的。仿真验证了估计算法的准确性。 This paper analyzes the necessity of the measurement of one-way delay,and it also points out the errors caused by the time offset existing between measurement devices.Then it proposes an algorithm to estimate time offset between measuring devices in network.With the estimated time offset,people can correct the measuring results.Simulation shows the effectiveness of the algorithm.
出处 《计算机工程与应用》 CSCD 北大核心 2004年第3期1-3,20,共4页 Computer Engineering and Applications
基金 国家重大自然科学基金项目资助(编号:69896240)
关键词 单向时延 时间偏差 测量设备 估计算法 Network transmission delay,Time offset,Measurement Devices
  • 相关文献

参考文献10

  • 1[1]G Almes,S Kalidindi,M Zekauskas. A one-way delay metric for ippm[S].RFC2679,1999-09
  • 2[2]S B Moon,P Skelly,D Towsley. Estimation and removal of clock skew from network delay measurements[C].In:Proc IEEE infocom,New York,1999-03
  • 3[3]Brynjar Viken,Eunice. Passive monitoring of internet traffic at supercomputing'98[C].In:Internet2 Member Meeting,1999-08
  • 4[4]S Shenker,J Wroclawski.General Characterization Parameters for Integrated Service Network Elements[S].RFC 2215,1997-09
  • 5[5]G Hooghiemstra,P V Mieghem. Delay Distributions on Fixed Internet Paths[R].Delt University of Technology,2001
  • 6[6]Tetsuya TAKINE.Estimation of clock offset from one-way delay measurement on asymmetric paths. IEEE Infocom 2002 IEEE Infocom 2002
  • 7[7]C J Bovy,H T Mertodimedjo,G Hooghiemstra et al. Analysis of endto-end delay measurements in Internet. PAM 2002
  • 8[8]K Papagiannaki,S Moon,C Fraleigh et al.Analysis of measured singlehop delay from an operational backbone network. IEEE Infocom 2002
  • 9[9]G Almes,S Kalidindi,M Zekauskas. A One-way Delay Metric for IPPM[S].RFC 2679,1999-09
  • 10[10]D Mills.Simple Network Time Protocol. 1995-03

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部