期刊文献+

100kA微秒级气体火花开关电极材料熔蚀研究 被引量:17

Experimental study of suppressing green noise in a diode-pumped intracavity-frequency-doubled laser
下载PDF
导出
摘要  电极材料是影响气体火花开关性能和寿命的关键因素之一。基于热传导方程分析了电弧作用下电极表层的温度场分布,得出了电极材料以及电弧属性参数对温度场分布的影响,并对黄铜、不锈钢、钨铜合金和高密度石墨4种电极材料进行了电极熔蚀实验,其质量亏损率分别为:黄铜6.39mg/C,不锈钢6.38mg/C,WCu合金4.19mg/C,高密度石墨1.19mg/C,与理论计算基本一致。 Surface layer temperature distribution of electrode was analyzed based on the equation of heat conduction. The parameters of arc and electrode material that influence the temperature distribution were obtained. The electrode erosion experiment of brass, stainless steel, copper-tungsten and graphite was carried out under 100 kA microsecond arc for 300 pulses and 36 C charge transfer. The experimental results show that the mass loss rate of the four electrodes materials is 6.39 mg/C for brass, 6.38 mg/C for stainless steel, 4.19 mg/C for copper-tungsten and 1.19 mg/C for graphite respectively.
出处 《强激光与粒子束》 EI CAS CSCD 北大核心 2004年第2期239-242,共4页 High Power Laser and Particle Beams
基金 国家863计划项目资助课题
  • 相关文献

参考文献6

  • 1饭田修一 张质贤译.物理学常用数表[M].北京:科学出版社,1979.118.
  • 2Savage M E. Final results from the high-current, high-action closing switch test program at Sandia National Laboratories[A]. Proceedings of 12th IEEE International Pulsed Power Conference[C]. USA, 1999. 1238-1241.
  • 3Lehr F M, Smith B D, Donaldson A L, et al. The influence of arc motion on electrode erosion in high current, high energy switches[A].Proceedings of 6th IEEE International Pulsed Power Conference[C]. USA, 1987. 529-533.
  • 4Lehr F M,Kristiansen M. Electrode erosion from high current moving arcs[J]. IEEE Transactions on Plasma Science, 1989, 17(5) : 811-817.
  • 5陈维青,曾正中,邹丽丽,任书庆,黄建军,来定国,张永民.100kA微秒级气体火花开关电极喷射现象研究[J].强激光与粒子束,2004,16(1):98-100. 被引量:14
  • 6陈首燊 李丁九.重复频率脉冲功率技术.电工电能新技术,1988,7(3):14-19.

二级参考文献3

共引文献22

同被引文献170

引证文献17

二级引证文献100

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部