摘要
用电刷技术在不锈钢基体一侧表面上刷镀了Cu膜,用电镀技术在不锈钢基体一侧表面或双侧表面上制备Ni膜.用梁三点弯曲法在自制的设备上测量不锈钢基体以及不锈钢基体上不同厚度Cu膜和Ni膜的弹性模量E.研究表明:在测量的膜厚范围内(7μm～15 μm),Cu膜和Ni膜的弹性模量E不随膜厚变化,并且接近各自块材的弹性模量.
Cu and Ni films coated on one or both sides of stainless steel substrates were produced by brush plating and electroplating techniques, respectively. The elastic moduli of Cu and Ni films with various thickness on substrates were determined using three-point bending tests. The results showed that the elastic moduli of Cu and Ni films were almost independence of film thickness and approximately the same as those of corresponding bulk materials.
出处
《稀有金属材料与工程》
SCIE
EI
CAS
CSCD
北大核心
2004年第1期109-112,共4页
Rare Metal Materials and Engineering
基金
国家自然科学基金资助(59831040)
国家博士学科点基金资助项目
关键词
三点弯曲实验
薄膜
弹性模量
three-point bend test
film
elastic modulus
