摘要
设计了 4种浇注系统 ,并且采用Z CAST软件对铸件进行了充型和凝固的模拟分析 ,通过对模拟结果的分析来对浇注系统进行了优化和改进。发现加 3块冷铁 ,并改变冷铁加入的位置 ,冒口的补缩效果很好。
Simulation analysis of mold filling and solidificatio n of the casting was conducted in 4 varieties of gating system with Z-cast softwa re. The optimization and improvement of gating system were done based on analysi s of simulation results to obtain the optimized design sketch. It is found that the use of three chills and proper adjustment of the setting position ca n improve effectively poured quality.
出处
《特种铸造及有色合金》
CAS
CSCD
北大核心
2004年第2期36-37,共2页
Special Casting & Nonferrous Alloys
基金
云南省科委信息技术开发专项重点攻关资助项目(2002AT05)
