摘要
针对YJ15型卷烟机二次定量供丝存在烟丝供给不均匀的问题,采取了3项改进措施:①采用交流伺服系统独立驱动粗、细钩子辊,缩短传动链;②将初次定量供丝传动与二次定量供丝传动分开;③将齿轮传动改为同步齿型带传动。改进后的YJ15型卷烟机定量供丝驱动系统,提高了供丝的均匀度,降低了烟支的空头率。
TO SOLVE THE PROBLEM OF UNEVEN CUT TOBACCO FEEDING IN YJ15 CIGARETTE MAKER, 3 MEASURES WERE TAKEN: 1) ADOPTING AC SERVO SYSTEMS TO DRIVE THE FINE AND COARSE CARDED DRUMS INDEPENDENTLY, TO SHORTEN TRANSMISSION CHAIN; 2) SEPARATING THE FIRST METERING FEED DRIVE FROM THE SECOND ONE; 3) CHANGING GEAR DRIVE INTO TIMING BELT DRIVE. AFTER IMPROVEMENT, THE UNIFORMITY OF CUT TOBACCO SUPPLY WAS INCREASED AND THE NUMBER OF LOOSE END CIGARETTE WAS REDUCED.
出处
《烟草科技》
EI
CAS
2004年第6期12-13,26,共3页
Tobacco Science & Technology
关键词
YJl5型卷烟机
供丝系统
初次定量
二次定量
均匀度
YJ15 CIGARETTE MAKER
FEED SYSTEM
FIRST METERING
SECOND METERING
DEGREE OF UNIFORMITY
