摘要
随动系统通用数字控制器是以8098单片机为核心,按STD总线标准设计的.硬件配置和控制算法的设计充分考虑了火炮随动系统的特点.采用串行数据传递使其与火控计算机接口只需3根信号线,最后给出了系统调试结果。
Proposes a general purpose digital controller for servo systems, based on a single chip microcomputer--8098, and set up on a STD bus. Its hardware and controlalgorithms have been designed to meet the specific requirements of gun servo systems. Three wire interface with the fire control computer transmits data in a series communication mode, results of experimentation within a system are given.
出处
《北京理工大学学报》
EI
CAS
CSCD
1993年第3期386-392,共7页
Transactions of Beijing Institute of Technology
关键词
随动系统
数学控制系统
数学控制器
servosysteras
digital control systems/data transfer
digital controller
