摘要
基于PC-DAQ的机载武器自动测试系统由主控机、数据采集与控制、多路信号切换及调理模块、武器离位激励系统等组成。系统软件由主控模块、测点切换、信号采集、故障分析处理等模块组成。用KingVIEW6.01组态软件编制测控程序,通过编写命令语言、定义数据变量连接外设、驱动接口和外设交换数据。各种检测信号经继电器接点、信号调理电路送主控机进行数据采集、检测和分析处理。
The automatic testing system of certain airborne weapon based on PC-DAQ is composed of main control computer, data acquisition and control component, multi-channel signal switching and modulation component, weapon-off-line actuation system. The system software consists of main control module, measurement-point switching module, module of data acquisition, module of analyzing and treating fault. Test and control program was compiled with KingVIEW6.01 configuration software. Through the compiling of command statement and the definition of data variables, the connection of peripheral equipments was founded, and corresponding data switching was implemented. All the testing data are sent to the main control computer to follow data acquisition, measure, analyze and process By way of relay contact and signal modulating circuit.
出处
《兵工自动化》
2004年第3期13-14,共2页
Ordnance Industry Automation