摘要
大功率车载充电机V2G工作模式,进行并网时,会存在单相三相系统切换的应用场景。本文提出一种通用型三相系统锁相环控制方法,该方法将单相系统视为三相不平衡故障的一种特例,基于移相控制的方式实现电压信号的正负序分离,设计出通用型软件锁相环,使其不仅能够适用于三相系统,也能够实现单相系统的兼容。最后通过模型仿真,针对三相电压不平衡和单相三相系统切换的应用场景,仿真验证了该锁相环设计的正确性。
When the high-power onboard charger works as V2G mode, there will be an application scenario of single-phase three-phase system switching. In this paper, a general three-phase system phase- locked loop control method is proposed. This method regards the single-phase system as a special case of three-phase unbalanced fault, and realizes the positive and negative sequence separation of the voltage signal based on the phase-shift control method. The universal software phase- locked loop makes it not only suitable for three-phase systems, but also compatible with single- phase systems. Finally, through model simulation, for the application scenarios of three-phase voltage unbalance and single-phase three-phase system switching, the simulation verifies the correctness of the phase-locked loop design.
出处
《电气工程》
2022年第1期13-21,共9页
Journal of Electrical Engineering