期刊文献+

PVA对钙长石–氧化铝多孔隔热材料的影响

Impact of PVA on the Heat-Insulation Performance of Anorthite-Alumina Porous Insulation Materials
下载PDF
导出
摘要 本文以聚乙烯醇(PVA)溶液作为粘结剂,研究其对钙长石–氧化铝多孔隔热材料性能及显微结构的影响,并确定聚乙烯醇(PVA)溶液的适宜掺量。研究结果表明:随着PVA量的增加,钙长石–氧化铝多孔隔热材料的体积密度在1.52 g/cm3~1.54 g/cm3,线收缩率在2.25%~2.50%,显气孔率由66.55%下降到58.51%;由显微结构SEM观察可知,随着PVA量的增加,晶粒间粘结作用增强,聚集体相互间粘结的颈部增大,聚集体有增大趋势,气孔逐渐清晰且均匀,但是晶粒的大小和形状并未发生明显变化;由材料的热震分析可知,加入PVA后,由于材料温度梯度的减小而使抗热震性次数有所提高,材料的热震性能良好。 Polyvinyl alcohol (PVA) solution as binder, study the influence of the anorthite-alumina insulation material properties and microstructure, and to determine the appropriate content of polyvinyl alcohol (PVA) solution. The results show that: with the increase in the amount of binder PVA, anorthite-alumina insulation material bulk density of 1.52 g/cm3,1.54 g/cm3 linear shrinkage of 2.25% to 2.50%, the apparent porosity decreased from 66.55% to 58.51%;SEM observation shows that, with the increase in the amount of binder PVA, the enhanced role of the inter-granular bonding while enhancing the role of bonding between the aggregates and aggregates between the neck increases aggregates increases gradually clear pores and homogenization, but the grain size and shape has not changed;anorthite-alumina thermal shock analysis shows that the material with PVA have well thermal shock resistance, due to lower temperature gradient improving the thermal shock.
出处 《材料科学》 2012年第3期128-132,共5页 Material Sciences
基金 山西省科技厅攻关项目(20091048) 太原科技局大学生创新创业计划项目(20111068) 太原科技大学UIT项目(XJ2010027)的资助。
  • 相关文献

参考文献3

二级参考文献22

  • 1韦中新,谢庆文,唐志平.改性聚乙烯醇自硬砂的研究[J].热加工工艺,1996(1):40-41. 被引量:4
  • 2昝和平,赵海晋,高建荣,孙素贞,芋艳梅.镁渣配料煅烧水泥熟料的动力学研究[J].武汉理工大学学报,2007,29(5):38-42. 被引量:11
  • 3昝和平,赵海晋,高建荣,孙素贞,芋艳梅.镁渣配料煅烧熟料形成过程的试验研究[J].水泥,2007(7):26-28. 被引量:12
  • 4郑修麟.材料的力学性能[M].西安:西北工业大学出版社,1994..
  • 5中国机械工程学会铸造专业学会.铸造手册 [M]. 北京 : 机械工业出版社 , 1999 113- 115.
  • 6H S Huang,Y C Lin,K S Hwang.Effect of Lubricant Addition on the Powder Properties and Compacting Performance of Spray-dried Molybdenum Powders.J.Refract.Mat.& Hard Mat.Int.,2002,(20):175-180
  • 7D M Liu,C T Fu.Compaction Behaviour of Spray-Dried Silicon Carbide Powders.Ceram.Int.,1996,(22):67-72.
  • 8S Begum,A Duff,R Puyane,M S J Hashmi.Evaluation of Latex Binder in the Processing of Electronic Ceramic Powder.J.Mater.Proc.Technol.,1998,(77):108-114
  • 9D B R Kumar,M R Reddy,V N Mulay,N Krishnamurti.Acrylic Co-polymer Emulsion Binders for Green Machining of Ceramics.J.Euro.Polym.,2000,(36):1503-1510
  • 10S Baklouti,T Chartier,J F Baumard.Mechanical Properties of Dry-pressed Ceramic Green Products:the Effect of the Binder.J.Am.Ceram.Soc.,1997,80 (8):1992-1995

共引文献21

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部