期刊文献+

Optimization Analysis of Correction Tape Box Compounding Cavity Runner Balance Based on Moldflow

Optimization Analysis of Correction Tape Box Compounding Cavity Runner Balance Based on Moldflow
下载PDF
导出
摘要 Aiming at the problem of runner unbalance in the compounding cavity of the upper and lower cover of the correction tape box, the plastic injection analysis software Moldflow was used to optimize runner balance. First, the 3D modeling software Proe was used to establish the geometric model of the upper and lower cover of the correction tape box, and introduced into the plastic injection analysis software Moldflow. Secondly, the upper and the lower cover of the correction tape box were meshed and the initial gating system was designed in Moldflow. Filling analysis of the initial scheme of the correction tape box combined cavity showed that the runner of the melt was not balanced in the mold cavity. Finally, the runner balance optimization analysis of the cavities was carried out. Through optimization, the time unbalance rate of the melt in the mold cavity decreased from 28.6% to 0.7%, the pressure unbalance rate decreased from 42.0% to 4.2%, and the pressure distribution in the cavity was more uniform in the whole injection process. Aiming at the problem of runner unbalance in the compounding cavity of the upper and lower cover of the correction tape box, the plastic injection analysis software Moldflow was used to optimize runner balance. First, the 3D modeling software Proe was used to establish the geometric model of the upper and lower cover of the correction tape box, and introduced into the plastic injection analysis software Moldflow. Secondly, the upper and the lower cover of the correction tape box were meshed and the initial gating system was designed in Moldflow. Filling analysis of the initial scheme of the correction tape box combined cavity showed that the runner of the melt was not balanced in the mold cavity. Finally, the runner balance optimization analysis of the cavities was carried out. Through optimization, the time unbalance rate of the melt in the mold cavity decreased from 28.6% to 0.7%, the pressure unbalance rate decreased from 42.0% to 4.2%, and the pressure distribution in the cavity was more uniform in the whole injection process.
出处 《World Journal of Engineering and Technology》 2020年第1期42-49,共8页 世界工程和技术(英文)
关键词 COMPOUNDING CAVITY RUNNER BALANCE Optimization Compounding Cavity Runner Balance Optimization
  • 相关文献

参考文献2

二级参考文献6

共引文献22

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部