摘要
This study aimed to prepare and characterize itraconazole (ITCZ)- or miconazole (MCZ)-loaded poly (lactide-co-glycolide) (PLGA) microparticles (MP) using a co-grinding method with ball milling, which is a solvent-free and convenient procedure. PLGA MP was prepared by grinding for 60 min, and the fixed theoretical drug loading was set at 9.1% and 16.7% for both drugs. The obtained loading efficiency for both drugs was estimated to be approximately 100%. The average diameters of the drug-loaded PLGA MP were approximately 20 - 35 μm. Powder X-ray diffraction (PXRD) or differential scanning calorimetry (DSC) confirmed amorphization of ITCZ and MCZ in ITCZ- or MCZ-loaded PLGA MP in all formulations. The drug release percentage from 9.1%-loaded ITCZ-PLGA7505 MP at 24 h was almost 50%, which was higher than that of ITCZ powder. The drug release percentage from MCZ-loaded PLGA7505 MP at 4 h was over 80%, which was higher than that of MCZ powder. This enhancement of release rate is caused by the amorphization of ITCZ or MCZ in the PLGA matrix. MCZ-loaded PLGA7510 MP showed a sustained release profile up to 24 h, suggesting that MCZ exists in an amorphous form in the PLGA matrix;however, the release rate declined owing to the large molecular weight of PLGA. Therefore, the release enhancement of antifungal drugs loaded on PLGA MP could be achieved by their amorphization using a co-grinding method with ball milling.
This study aimed to prepare and characterize itraconazole (ITCZ)- or miconazole (MCZ)-loaded poly (lactide-co-glycolide) (PLGA) microparticles (MP) using a co-grinding method with ball milling, which is a solvent-free and convenient procedure. PLGA MP was prepared by grinding for 60 min, and the fixed theoretical drug loading was set at 9.1% and 16.7% for both drugs. The obtained loading efficiency for both drugs was estimated to be approximately 100%. The average diameters of the drug-loaded PLGA MP were approximately 20 - 35 μm. Powder X-ray diffraction (PXRD) or differential scanning calorimetry (DSC) confirmed amorphization of ITCZ and MCZ in ITCZ- or MCZ-loaded PLGA MP in all formulations. The drug release percentage from 9.1%-loaded ITCZ-PLGA7505 MP at 24 h was almost 50%, which was higher than that of ITCZ powder. The drug release percentage from MCZ-loaded PLGA7505 MP at 4 h was over 80%, which was higher than that of MCZ powder. This enhancement of release rate is caused by the amorphization of ITCZ or MCZ in the PLGA matrix. MCZ-loaded PLGA7510 MP showed a sustained release profile up to 24 h, suggesting that MCZ exists in an amorphous form in the PLGA matrix;however, the release rate declined owing to the large molecular weight of PLGA. Therefore, the release enhancement of antifungal drugs loaded on PLGA MP could be achieved by their amorphization using a co-grinding method with ball milling.
作者
Kazuhiro Matsuura
Honami Kojima
Miyako Yoshida
Takahiro Uchida
Kazuhiro Matsuura;Honami Kojima;Miyako Yoshida;Takahiro Uchida(Formulation Technology Research Laboratories, Daiichi Sankyo Co., Ltd., Hiratsuka, Japan;Faculty of Pharmaceutical Science, Mukogawa Women’s University, Nishinomiya, Japan)
