摘要
The New Holland TT75 tractors currently in service in Chad use a tractor arm with three holes, the middle one of which has recurrent failures due to traction. The purpose of this work is to use a finite element model to provide an improvement by modifying the geometric parameters to avoid premature failure of the tractor arms of the New Holland TT75. The ultimate force formula of Eurocode 3 was used to determine the maximum pressure to be applied and. A comparative traction study between the current arm and the proposed arm was performed, taking into account the variation in hole size, arm width and applied pressure for the determination of the stress concentration factor Kt. With the determination of Kt and for the arm width (w) less than or equal to 85 mm;the results showed that the proposed arm geometry is better.
The New Holland TT75 tractors currently in service in Chad use a tractor arm with three holes, the middle one of which has recurrent failures due to traction. The purpose of this work is to use a finite element model to provide an improvement by modifying the geometric parameters to avoid premature failure of the tractor arms of the New Holland TT75. The ultimate force formula of Eurocode 3 was used to determine the maximum pressure to be applied and. A comparative traction study between the current arm and the proposed arm was performed, taking into account the variation in hole size, arm width and applied pressure for the determination of the stress concentration factor Kt. With the determination of Kt and for the arm width (w) less than or equal to 85 mm;the results showed that the proposed arm geometry is better.
作者
Sindang Djondang
Tikri Bianzeubé
Ngoidita Natebaye
Gamma Adjeffa
Sindang Djondang;Tikri Bianzeubé;Ngoidita Natebaye;Gamma Adjeffa(Laboratory of Study and Research in Industrial Technology, Faculty of Applied Sciences, University of N’Djamena, N’Djamena, Chad;Laboratory of Structural Mechanics and Resistance of Mateiraux, Polytechnic University of Mongo, Mongo, Chad)
