摘要
In this study, aqueous extraction method is used because of its high extraction ratio, light fastness and also functional properties. In 1st phase, for dyeing S/J cotton knit fabric with green walnut power ferrous sulfate is considered as a mordant. In this study, three different mordanting methods such as pre-, meta-, and post-mordanting are conveyed the dyeing process with the state of metallic mordant and without metallic salt mordants. In 2nd phase, in dyeing for fixation ferrous sulfate was considered as mordants. Furthermore, the analysis and evaluation of each colour dyed material was done through following two terms for instance CIELAB (L*, a*, and b*) and K/S values. According to AATCC test methods, colour fastness to washing, crocking, perspiration of the dyed samples is determined whereas according to the ISO standard, the colour fastness to light was estimated and tested. When dyeing was carried out on S/J cotton knit fabric through considering optimum parameter like at 80°C for 60 min and at pH 4 which showed optimum results. From the results we can see, very good wash fastness was obtained while there is no fading of the colour, whereas the outstanding and moderate level of colour fastness to light and crocking is achieved.
In this study, aqueous extraction method is used because of its high extraction ratio, light fastness and also functional properties. In 1st phase, for dyeing S/J cotton knit fabric with green walnut power ferrous sulfate is considered as a mordant. In this study, three different mordanting methods such as pre-, meta-, and post-mordanting are conveyed the dyeing process with the state of metallic mordant and without metallic salt mordants. In 2nd phase, in dyeing for fixation ferrous sulfate was considered as mordants. Furthermore, the analysis and evaluation of each colour dyed material was done through following two terms for instance CIELAB (L*, a*, and b*) and K/S values. According to AATCC test methods, colour fastness to washing, crocking, perspiration of the dyed samples is determined whereas according to the ISO standard, the colour fastness to light was estimated and tested. When dyeing was carried out on S/J cotton knit fabric through considering optimum parameter like at 80°C for 60 min and at pH 4 which showed optimum results. From the results we can see, very good wash fastness was obtained while there is no fading of the colour, whereas the outstanding and moderate level of colour fastness to light and crocking is achieved.
