Investigation on the fabrication of lightweight aggregate with acid-leaching tailings of vanadium-bearing stone coal minerals and red mud

Proper treatment of acidleaching tailings(ALTs)of vanadiumbearing stone coal minerals is of great urgency.One approach is adding it into the raw materials during the preparation of lightweight aggregate(LWA).But clay is always needed.In this paper,another solid waste,red mud,was mixed with ALTs as a source of flux components instead of clay.Evaluation of the physical characteristics,morphological structures,as well as crystal phases during the sintering process were investigated.When their mixtures with a proper ratio were sintered at 1080℃,a glassy phase with certain viscosity was formed,and the gases generated simultaneously were encapsulated by the melt.Finally,LWA with a onehour water absorption as low as 1.46%,a bulk density as low as 728.76 kgm 3 and a compressive strength as high as 10.77 MPa was fabricated.

Preparation of high nitrogen and nickel-free austenitic stainless steel by powder injection molding

High nitrogen and nickel-free austenitic stainless steel has received much recognition worldwide because it can solve the problem of ＂nickel-allergy＂ and has outstanding mechanical and physical properties. In this article, 0Cr17Mn11Mo3N was prepared by powder injection molding （PIM） technique accompanied with solid-nitriding. The results show that the critical solid loading can achieve up to 64vol% by use of gas-atomized powders with the average size of 17.4 μm. The optimized sintefing conditions are determined to be 1300℃,2 h in flowing nitrogen atmosphere, at which the relative density reaches to 99% and the N content is as high as 0.78wt%. After solution annealing at 1150℃for 90 rain and water quench, the 0.2% yield strength, ultimate tensile strength （UTS）, elongation, reduction in area, and hardness can reach as high as 580 MPa, 885 MPa, 26.0%, 29.1%, and Hv 222, respectively.

Investigation of Key Parameters for 3-D Dredging Plume Model Validation

Dredging plume dispersion studies, use dredging plume models to predict the fate of sediment plumes resulting from dredging activities and dredge spoil disposal. The model results are applied as input to environmental impact assessment of the proposed dredging, particularly those associated with suspended sediments and sedimentation. Model validation and performance are still not resolved because of the difficulty of site measurements and the understanding of the parameters used in the model. This paper presents a 3-D dredging plume model based on the MIKE3 software package to investigate parameters which affect the model performances. As a result of lack of site data for the public domain uses, the model scenarios are designed artificially for sensitive runs to identify the key parameters affecting plume behaviours. The factors include dredging spill rates using different dredging methods, equipment and sediment settling velocities. The influence of wave and wind effects combined with tidal forces on the sediment re-suspended rates and the advection/dispersion scales are also assessed.

石煤钒矿酸浸尾渣高温焙烧制备陶粒过程元素硫释放规律

以石煤钒矿酸浸提钒过程产生的尾渣为原料制备陶粒是实现尾渣资源化的重要途径之一。作为陶粒最主要用途的轻集料对硫含量有严格限制(以SO3计,硫酸盐和硫化物含量≤1.0wt%)。尾渣含硫量通常远高于1.0wt%,故需深入研究尾渣制备陶粒过程元素硫的释放规律。借助热重–红外联用分析了以尾渣为原料制备陶粒过程中的质量、热量变化以及气体释放规律,测试了不同温度焙烧所得样品的硫含量,表征了其物相,并结合热力学计算,讨论了尾渣中硫的释放机理。结果表明,随温度增加,尾渣中的含硫物质逐渐分解并释放出SO_(2)气体,样品的硫含量逐渐降低;1200℃下样品的硫含量可降低至0.44wt%,满足轻集料硫含量要求;尾渣中含有的SiO_(2),Fe_(2)O_(3),Al_(2)O_(3)等组分可促进硫的释放。

Geochemistry and Geochronology of the Gebunongba Iron Polymetallic Deposit in the Gangdese Belt, Tibet

The Gebunongba iron polymetallic deposit is a typical skarn deposit located at the westernmost end of the discovered iron polymetallic deposits in the Gangdese metallogenic belt. Major and trace elements of the monzonite granite related to mineralization show that these rocks are peraluminous(ACNK=1.15–1.21) and are rich in Si(76.63 wt.%–76.93 wt.% SiO2), K(K2 O/Na2 O ratio of 1.80–2.30), LREE and LILEs(Rb, Ba, Th, U, Pb), but is depleted in high field strength elements(Nb, Ta, Ti and HREE). In addition, these rocks show obviously negative Eu anomalies(δEu=0.48–0.55). The LA-ICPMS U-Pb age of zircons in monzonite granite is 59.72±0.55 Ma(MSWD=0.79), whereas the 40 Ar/39 Ar age of muscovite in iron ores is 59.22±0.61 Ma(MSWD=16.20). This indicates that the deposit formed at the syn-collision stage of Lhasa-India terrane is later than the northward subduction of the Yajiang crust. The monzonite granite has been probably derived from the partial melting of ancient lower crustal materials, which is probably resulted from the underplating of mantle-derived magmas. It is favorable for the formation of iron polymetallic deposit. Iron polymetallic mineralization is prevalent in Gangdese metallogenic belt at syn-collision stage. Therefore, syn-collision stage is an important mineralization stage for iron polymetallic deposits. The results of this study proved that iron polymetallic mineralization still took place in the western segment of Gangdese metallogenic belt and provided basis for further prospecting the deposits of the same type.

A New Discovery of Ag-Pb-Zn Mineralization via Modern Portable Analytical Technology and Stream Sediment Data Processing Methods in Dajiacuo Area, Western Tibet(China)

Tibet, which is rich in mineral resources, is a treasure trove for geological explorers. However, prospecting work has been slow, especially in the western part, due to the precipitous terrain, changeable climate and low access. Hence, modern advanced field analytical technology and effective data processing methods play significant roles in rapid and efficient exploration in Tibet. In this paper, spectrum-area fractal modeling and portable X-ray fluorescence analysis(pXRFA) were used to identify and verify geochemical anomalies associated with Ag-Pb-Zn mineralization based on a stream-sediment dataset of 39 elements in the Dajiacuo-Xurucuo region of western Tibet. First, staged factor analysis(SFA) was used to obtain the Ag-Pb-Zn-Cd geochemical assemblage. Second, the first-factor pattern obtained using SFA was dissociated by a spectrum-area(S-A) fractal model and a digital elevation model(DEM)-based geochemical model(DGM) was constructed. Finally, the sections of Ag, Cd, Pb, and Zn were obtained using pXRFA. The results show that Ag-Pb-Zn-Cd enrichment zones were mostly located around the contact belt of volcanic rocks and intrusions, or along SE-NW trending faults. Considering the variable terrain and catchment basin, the extension of long axes of Ag-Pb-Zn-Cd anomalies into higher elevation areas that are favorable for Ag-Pb-Zn mineralization should be investigated. Anomaly maps created with the aid of a DGM show promising potential for mineralization in the Dajiacuo-Xurucuo region, and abundant Ag-Pb-Zn mineralization was identified with the assistance of pXRFA in the source areas for the geochemical anomalies in the Dajiacuo. We conclude that SFA and the S-A fractal model constitute a valid tool to identify or verify geochemical anomalies in areas of low-density stream-sediment sampling. The pXRFA can accurately determine the source of geochemical anomalies and improve anomaly verification efficiency.

Petrogenesis and Tectonic Implications of the Tertiary Choke Shield Basalt and Continental Flood Basalt from the Central Ethiopian Plateau

The voluminous Choke Shield basalts and flood basalts are distributed in the central Ethiopian Plateau.They are tholeiitic in composition and have OIB-like geochemical features.The ca.23 Ma Choke Shield basalts have SiO_(2)(47.1 wt.%-59.6 wt.%),MgO(1.01 wt.%-7.8 wt.%),Na_(2)O+K_(2)O(2.7 wt.%-8.4 wt.%),and display right inclined REE patterns((La/Yb)N=21.4-24.2) with enrichment of Nb,Ta,Zr,Hf and Pb in the primitive mantle-normalized trace element diagrams.They show low initial ^(87)Sr/^(86)Sr ratios(0.703 47-0.703 77) and high ε_(Nd)(t) values(+4.4 to+5.0).In comparison,the 24Ma high-Ti(HT1) flood basalts have SiO_(2)(38.9 wt.%-50.8 wt.%),MgO(3.9 wt.%-11.4 wt.%),Na_(2)O+K_(2)O(1.6 wt.%-5.8 wt.%), and display right inclined REE patterns((La/Yb)N=24-130.3) with enrichment of Nb,Ta,Zr,Hf,and Pb.They also show low initial ^(87)Sr/^(86)Sr ratios(0.703 30-0.704 44) and highε_(Nd)(t) values(+2.2 to+5.3).Both types of basalts were contaminated by minor crustal materials and underwent fractional crystallization of clinopyroxene,plagioclase,olivine,and minor Fe-Ti oxide.The Choke Shield basalts were generated by 1%-5% melting of garnet-spinel to phlogopite-bearing spinel lherzolite in a shallow zone of the mantle plume,while the flood basalts were formed by <20% melting of amphibole-bearing garnet to garnet-spinel lherzolite in a deeper zone of the same mantle plume.The mantle source beneath the central Ethiopian Plateau was significantly heterogeneous during the Tertiary.It was characterized by EMI and EMII end-members that were formed by the metasomatism of the different components.