The structure and mechanical properties of a new type of Al-based discontinuous gradient composites prepared by using the ternary AI-19Si-5Mg alloys as the raw material adopting the centrifugal casting method were inv...The structure and mechanical properties of a new type of Al-based discontinuous gradient composites prepared by using the ternary AI-19Si-5Mg alloys as the raw material adopting the centrifugal casting method were investigated. Structurally, the composites are divided into two zones： a reinforced zone with the high volume fraction of primary Si and Mg2Si particles and an unreinforced zone with no or a few particles. In the reinforced zone, the primary particles are evenly distributed, with the sizes of the primary Si particles 80-120 μm, and that of primary Mg2Si particles 20-50 μm. The properties test results show the reinforced zone has higher Rockwell hardness and better wear resistance than the unreinforced zone, due to the complementary reinforcement relationship between the primary Si and Mg2Si particles and their high volume fraction.展开更多
The resin-sand mixture was proposed to be used as the surface course,and cement permeable concrete was used as the base course;such two kinds of materials were combined to prepare water-permeable brick with a composit...The resin-sand mixture was proposed to be used as the surface course,and cement permeable concrete was used as the base course;such two kinds of materials were combined to prepare water-permeable brick with a composite structure.The compressive strength,flexural strength,and permeability were studied by using adjusting the contents of carbon fiber,quartz powder,cement,sand,and surfactant.The study shows that the hydrophilicity of the resin-sand mixture can be improved after any amount of resin is replaced by quartz powder;by using the surfactant,the interface energy of the particles can be reduced so that the water permeability of the surface course can be promoted effectively.However,the mechanical properties of the surface course were negatively affected by the surfactant.With the optimal process consideration in the experiments,the properties about compressive strength,flexural strength,and permeability of the composite permeable brick can meet the requirements of the specifications of resin-sand based water permeable brick JGT 376-2012(compressive strength was higher than 35 MPa,the flexural strength exceeded 5.19 MPa,and the average permeability coefficient was higher than 2.3×10^(-2)cm/s).There are no obvious pores on the surface course and only water molecules can pass through it,therefore,the surface of the permeable brick cannot be blocked up by solid substances,and the permeability of such permeable brick can be improved effectively in this way.展开更多
Cement mortar with carbon fiber(CFc)and resin-cement mortar with carbon fiber(CFrc)were used as inner and outer cores of smart aggregate with Z shape,respectively,which was used as the basic perception units to prepar...Cement mortar with carbon fiber(CFc)and resin-cement mortar with carbon fiber(CFrc)were used as inner and outer cores of smart aggregate with Z shape,respectively,which was used as the basic perception units to prepare smart concrete aggregate with a mosaic structure(SAMS).The hydroxpropyl methylcellulose(HPMC)was taken into consideration to improve the properties of mortar;by using HPMC,the structure of SAMS was optimized and its mechanical and electrical properties were evaluated.The experimental results show that the toughness of mortar could be improved by the complex that formed by epoxy resin,and the effect of HPMC on the flexibility of CFc was greater than that on the flexibility of CFrc;the feasible designing indicates that the CFc-Z core and CFrc-Z core could be used as inner and outer cores of SAMS.When the proposed dosages of HPMC in inner and outer cores are 0.35wt%and 0.2wt%,respectively,it could give an effective prediction for the damage of concrete during the loading process.展开更多
By using redispersible polymer powder（RPP） and carbon fiber（CF） to adjust the flexibility and electrical properties of the smart aggregate, a new kind of smart aggregate with Z type structure was proposed. The stu...By using redispersible polymer powder（RPP） and carbon fiber（CF） to adjust the flexibility and electrical properties of the smart aggregate, a new kind of smart aggregate with Z type structure was proposed. The study shows that Z type aggregate is more sensitive to the feedback of external force than the prism aggregate in the same loading environment, and it indicates that Z type aggregate is more suitable for the research and application of concrete health monitoring. Although the incorporation of RPP would cause the compressive strength of the aggregates and the elastic modulus of hardened cement mortar to reduce slightly within the dosage of RPP by 2.25% because of the polymer film formed in the internal system, this would improve the deformability of the aggregates. In the early loading stage（in the first 60 seconds）, the intelligent concrete specimens implanted with Z type smart aggregate do not show higher sensitivity as expected, although the resistance change rate changes a little bit more, the overall of it is still in balance. Adding RPP could improve the flexibility of smart aggregates exactly, and it plays an active role in prolonging the life of the smart aggregates. By implanting Z type aggregates the damage and failure of the concrete structure could be predicted accurately in this study. The results of this paper will help to promote further research and application of intelligent concrete.展开更多
基金Funded by the National Natural Science Foundation of China(No.51201140)the Fundamental Research Funds for the Central Universities(No.XDJK2010C007)
文摘The structure and mechanical properties of a new type of Al-based discontinuous gradient composites prepared by using the ternary AI-19Si-5Mg alloys as the raw material adopting the centrifugal casting method were investigated. Structurally, the composites are divided into two zones： a reinforced zone with the high volume fraction of primary Si and Mg2Si particles and an unreinforced zone with no or a few particles. In the reinforced zone, the primary particles are evenly distributed, with the sizes of the primary Si particles 80-120 μm, and that of primary Mg2Si particles 20-50 μm. The properties test results show the reinforced zone has higher Rockwell hardness and better wear resistance than the unreinforced zone, due to the complementary reinforcement relationship between the primary Si and Mg2Si particles and their high volume fraction.
基金Funded by the Natural Science Foundation of Fujian Province(No.2016J01241)the National Natural Science Foundation of China(No.51608212)the Education Department of Fujian Province(No.JA14024)。
文摘The resin-sand mixture was proposed to be used as the surface course,and cement permeable concrete was used as the base course;such two kinds of materials were combined to prepare water-permeable brick with a composite structure.The compressive strength,flexural strength,and permeability were studied by using adjusting the contents of carbon fiber,quartz powder,cement,sand,and surfactant.The study shows that the hydrophilicity of the resin-sand mixture can be improved after any amount of resin is replaced by quartz powder;by using the surfactant,the interface energy of the particles can be reduced so that the water permeability of the surface course can be promoted effectively.However,the mechanical properties of the surface course were negatively affected by the surfactant.With the optimal process consideration in the experiments,the properties about compressive strength,flexural strength,and permeability of the composite permeable brick can meet the requirements of the specifications of resin-sand based water permeable brick JGT 376-2012(compressive strength was higher than 35 MPa,the flexural strength exceeded 5.19 MPa,and the average permeability coefficient was higher than 2.3×10^(-2)cm/s).There are no obvious pores on the surface course and only water molecules can pass through it,therefore,the surface of the permeable brick cannot be blocked up by solid substances,and the permeability of such permeable brick can be improved effectively in this way.
基金Funded by the Natural Science Foundation of Fujian Province(No.2016J01241)the National Natural Science Foundation of China(No.51608212)。
文摘Cement mortar with carbon fiber(CFc)and resin-cement mortar with carbon fiber(CFrc)were used as inner and outer cores of smart aggregate with Z shape,respectively,which was used as the basic perception units to prepare smart concrete aggregate with a mosaic structure(SAMS).The hydroxpropyl methylcellulose(HPMC)was taken into consideration to improve the properties of mortar;by using HPMC,the structure of SAMS was optimized and its mechanical and electrical properties were evaluated.The experimental results show that the toughness of mortar could be improved by the complex that formed by epoxy resin,and the effect of HPMC on the flexibility of CFc was greater than that on the flexibility of CFrc;the feasible designing indicates that the CFc-Z core and CFrc-Z core could be used as inner and outer cores of SAMS.When the proposed dosages of HPMC in inner and outer cores are 0.35wt%and 0.2wt%,respectively,it could give an effective prediction for the damage of concrete during the loading process.
基金Funded by the Natural Science Foundation of Fujian Province(No.2016J01241)the National Natural Science Foundation of China(No.51608212)the Science&Technology Pillar Program of Fujian Provincial Education Department(No.JA14024)
文摘By using redispersible polymer powder（RPP） and carbon fiber（CF） to adjust the flexibility and electrical properties of the smart aggregate, a new kind of smart aggregate with Z type structure was proposed. The study shows that Z type aggregate is more sensitive to the feedback of external force than the prism aggregate in the same loading environment, and it indicates that Z type aggregate is more suitable for the research and application of concrete health monitoring. Although the incorporation of RPP would cause the compressive strength of the aggregates and the elastic modulus of hardened cement mortar to reduce slightly within the dosage of RPP by 2.25% because of the polymer film formed in the internal system, this would improve the deformability of the aggregates. In the early loading stage（in the first 60 seconds）, the intelligent concrete specimens implanted with Z type smart aggregate do not show higher sensitivity as expected, although the resistance change rate changes a little bit more, the overall of it is still in balance. Adding RPP could improve the flexibility of smart aggregates exactly, and it plays an active role in prolonging the life of the smart aggregates. By implanting Z type aggregates the damage and failure of the concrete structure could be predicted accurately in this study. The results of this paper will help to promote further research and application of intelligent concrete.
