Co-pyrolysis of waste biomass and waste plastics(polystyrene and waste nitrile gloves)into renewable fuel and value-added chemicals

The present study addresses the influence of blending of waste plastics(i.e.,polystyrene,PS and waste nitrile gloves,WNG)with mahua seeds(MH)for co-pyrolytic liquid yield and its fuel properties.Various blends of waste plastics were mixed with biomass(10,20 and 30 wt%)and pyrolyzed in a semi-batch reactor at an optimized environment(550℃ temperature,80℃ min^(-1) heating rate,and 100 mL min^(-1) N_(2) flow rate).Physicochemical results displayed its ability to yield renewable fuel and valuable chemicals.Co-pyrolysis outcomes showed that blending of waste plastics at 20 wt%,yielded maximum liquid(44.18±1.2 wt%and 45.89±1.4 wt%for MH+WNG and MH+PS respectively)which was higher than thermal pyrolysis of individual MH(39.26±1.2 wt%).Further,characterization results revealed a substantial reduction in viscosity,oxygen content,moisture,and a positive increment in gross heating value,carbon content and acidity.FTIR examination exposed the attendance of mainly aromatics,acids,phenols,water,esters and ethers.Further,NMR analysis of pyrolytic oil confirmed an increase in aromaticity by blending of waste plastics(20 wt%)while there was a reduction in paraffinic compounds.GC-MS investigation revealed substantial improvement in hydrocarbons and minimization in the oxygen-rich products by blending of waste plastics at 20 wt%.

Bio-oil and biochar production using thermal and catalytic pyrolysis of low-value waste neem seeds over low-cost catalysts:effects of operating conditions on product yields and studies of physicochemical characteristics of bio-oil and biochar

This study addressed a comparative assessment of the effect of low-cost catalysts on the yield and physicochemical properties of bio-oil.Thermal and catalytic pyrolysis of neem seeds(NM)was conducted in a fixed bed semi-batch reactor at optimum conditions(550°C temperature,80°C min−1 heating rate,0.5 mm particle size,and 100 mL min−1 sweep gas flow rate).The produced bio-oil and biochar were characterized through thermal stability,elemental composition(CHNS),higher heating value(HHV),Nuclear Magnetic Resonance(NMR)spectroscopy,Field Emission Scanning Electron Microscopy(FESEM),Fourier-transform infrared spectroscopy(FTIR),Gas Chromatography-Mass Spectrometry(GC-MS),zeta potential,water-holding capacity(WHC),and BET(Brunauer,Emmett and Teller)surface area analyzer.Overall,it was noticed that the use of catalysts at optimized condition substantially boosted the quality and yield of bio-oil.Pyrolysis results established that thermal pyrolysis yielded 49.53 wt.%of bio-oil,while catalytic pyrolysis yielded(51.25 wt.%,53.12 wt.%,48.68 wt.%,and 50.65 wt.%for MgO,NaOH,Al_(2)O_(3),and ZSM-5,respectively)at 20 wt.%catalyst loading.The physicochemical study of bio-oil confirmed improved properties of bio-oil in terms of viscosity,heating value,pH and carbon content.Further,the FTIR study of bio-oil indicates the occurrence of phenolic products,aromatics,ketones,acidic compounds,esters,alcohol and aldehyde impurities,whereas 1H NMR study supported FTIR findings.GC-MS study demonstrated that the introduc-tion of catalysts significantly reduced the oxygenated substances,acidic products,phenolic compounds and substantially increased the hydrocarbons.Further,characterization results of neem seed biochar(NMC)established the existence of HHV(23.26 MJ kg^(−1)),carbon content(62.66%),zeta potential(31.68 mV),water holding capacity(41.50%)and lower BET surface area(4.60 m^(2)g^(−1)).