Combined cooling and power(CCP)system driven by low-grade heat is promising for improving energy efficiency.This work proposes a CCP system that integrates a regenerative organic Rankine cycle(RORC)and an absorption c...Combined cooling and power(CCP)system driven by low-grade heat is promising for improving energy efficiency.This work proposes a CCP system that integrates a regenerative organic Rankine cycle(RORC)and an absorption chiller on both driving and cooling fluid sides.The system is modeled by using the heat current method to fully consider nonlinear heat transfer and heat-work conversion constraints and resolve its behavior accurately.The off-design system simulation is performed next,showing that the fluid inlet temperatures and flow rates of cooling water as well as RORC working fluid strongly affect system performance.The off-design operation even becomes infeasible when parameters deviate from nominal values largely due to limited heat transfer capability of components,highlighting the importance of considering heat transfer constraints via heat current method.Design optimization aiming to minimize the total thermal conductance is also conducted.RORC efficiency increases by 7.9%and decreases by 12.4%after optimization,with the hot fluid inlet temperature increase from 373.15 to 403.15 K and mass flow rate ranges from 10 to 30 kg/s,emphasizing the necessity of balancing system cost and performance.展开更多
The investigation of the melting behaviors of the molten salt at micron scale during the melting process is critical for explaining the solid-liquid phase transition mechanism.In this paper,a novel experimental system...The investigation of the melting behaviors of the molten salt at micron scale during the melting process is critical for explaining the solid-liquid phase transition mechanism.In this paper,a novel experimental system and analysis method were proposed to study the melting process with three heating rates in the range of1-10℃/min of the solar salt at micron scale.The solid-liquid boundary morphology and phase transition kinetics of molten salt particles were focused on.Meanwhile,the correlations between liquid fraction,temperature and time under different heating rates were studied.The solid-liquid boundary morphology was depicted by the visualized experimental set-up,and the instantaneous liquid volume fraction during the non-isothermal phase transition was obtained.Then,the correlation between temperature and liquid volume fraction was proposed to reveal the evolution of the solid-liquid boundary with temperature at different heating rates.Furthermore,the non-isothermal phase transition kinetic equation was established by introducing a constant parameter(V_(a,b)),and more kinetic parameters such as 1g V_(a,b) and-lg V_(a,b)/b were studied.The results showed that the exponent b is not sensitive to the heating rate with a range of 3-5 for solar salt particles.However,the heating rate influences the value of V_(a,b) and presents a positive relationship.Besides,the non-isothermal phase transition kinetic equations at different heating rates in the range of 1-10℃/min can be quickly predicted by the proposed improved experimental test method.This study could fill the research insufficiency and provide significant guidance for future research on the solid-liquid transition mechanism of molten salts at micron scale.展开更多
Due to the intermittency and indeterminacy of solar irradiance,balancing energy supply and load demand remains a challenge.This paper proposed a switchable hybrid system that combines concentrating photovoltaic/concen...Due to the intermittency and indeterminacy of solar irradiance,balancing energy supply and load demand remains a challenge.This paper proposed a switchable hybrid system that combines concentrating photovoltaic/concentrating solar power(CPV/CSP)technology with thermal energy storage(TES)to achieve flexible electricity and thermal generation by adjusting the incident solar flux of photovoltaic(PV).The hybrid system can directly transfer surplus solar energy into high-quality heat for storage using a rotatable PV/heat receiver.The simulated results demonstrated that the hybrid system effectively improves power generation,optimally utilizes TES capacity,and reduces the levelized cost of electricity(LCOE).Over a selected seven-day period,the single-junction(1J)Ga As solar cells used in the hybrid system sustainably satisfied the load demand for more than five days without grid supplement,outperforming the CSP plant by an additional two days.The hybrid system utilizing the 1J Ga As with the base configuration of solar multiple(SM)of 1.26 and TES capacity of 5 h improved the annual power production and renewable penetration(RP)by 20.8%and 24.8%compared with the conventional CSP plant,respectively.The hybrid plant with monosilicon and a configuration of SM(1.8),PV ratio(1),and TES capacity(6 h)achieved an optimal LCOE of11.52$ct/k Wh and RP of 75.5%,which is 8.8%lower and 12.1%higher than the CSP plant,respectively.展开更多
基金supported by National Natural Science Foundation of China(Grant No.52125604)。
文摘Combined cooling and power(CCP)system driven by low-grade heat is promising for improving energy efficiency.This work proposes a CCP system that integrates a regenerative organic Rankine cycle(RORC)and an absorption chiller on both driving and cooling fluid sides.The system is modeled by using the heat current method to fully consider nonlinear heat transfer and heat-work conversion constraints and resolve its behavior accurately.The off-design system simulation is performed next,showing that the fluid inlet temperatures and flow rates of cooling water as well as RORC working fluid strongly affect system performance.The off-design operation even becomes infeasible when parameters deviate from nominal values largely due to limited heat transfer capability of components,highlighting the importance of considering heat transfer constraints via heat current method.Design optimization aiming to minimize the total thermal conductance is also conducted.RORC efficiency increases by 7.9%and decreases by 12.4%after optimization,with the hot fluid inlet temperature increase from 373.15 to 403.15 K and mass flow rate ranges from 10 to 30 kg/s,emphasizing the necessity of balancing system cost and performance.
基金supported by the National Natural Science Foundation of China (No.51821004 and No. 51876061)。
文摘The investigation of the melting behaviors of the molten salt at micron scale during the melting process is critical for explaining the solid-liquid phase transition mechanism.In this paper,a novel experimental system and analysis method were proposed to study the melting process with three heating rates in the range of1-10℃/min of the solar salt at micron scale.The solid-liquid boundary morphology and phase transition kinetics of molten salt particles were focused on.Meanwhile,the correlations between liquid fraction,temperature and time under different heating rates were studied.The solid-liquid boundary morphology was depicted by the visualized experimental set-up,and the instantaneous liquid volume fraction during the non-isothermal phase transition was obtained.Then,the correlation between temperature and liquid volume fraction was proposed to reveal the evolution of the solid-liquid boundary with temperature at different heating rates.Furthermore,the non-isothermal phase transition kinetic equation was established by introducing a constant parameter(V_(a,b)),and more kinetic parameters such as 1g V_(a,b) and-lg V_(a,b)/b were studied.The results showed that the exponent b is not sensitive to the heating rate with a range of 3-5 for solar salt particles.However,the heating rate influences the value of V_(a,b) and presents a positive relationship.Besides,the non-isothermal phase transition kinetic equations at different heating rates in the range of 1-10℃/min can be quickly predicted by the proposed improved experimental test method.This study could fill the research insufficiency and provide significant guidance for future research on the solid-liquid transition mechanism of molten salts at micron scale.
基金supported by the National Natural Science Foundation of China(Grant No.51821004)。
文摘Due to the intermittency and indeterminacy of solar irradiance,balancing energy supply and load demand remains a challenge.This paper proposed a switchable hybrid system that combines concentrating photovoltaic/concentrating solar power(CPV/CSP)technology with thermal energy storage(TES)to achieve flexible electricity and thermal generation by adjusting the incident solar flux of photovoltaic(PV).The hybrid system can directly transfer surplus solar energy into high-quality heat for storage using a rotatable PV/heat receiver.The simulated results demonstrated that the hybrid system effectively improves power generation,optimally utilizes TES capacity,and reduces the levelized cost of electricity(LCOE).Over a selected seven-day period,the single-junction(1J)Ga As solar cells used in the hybrid system sustainably satisfied the load demand for more than five days without grid supplement,outperforming the CSP plant by an additional two days.The hybrid system utilizing the 1J Ga As with the base configuration of solar multiple(SM)of 1.26 and TES capacity of 5 h improved the annual power production and renewable penetration(RP)by 20.8%and 24.8%compared with the conventional CSP plant,respectively.The hybrid plant with monosilicon and a configuration of SM(1.8),PV ratio(1),and TES capacity(6 h)achieved an optimal LCOE of11.52$ct/k Wh and RP of 75.5%,which is 8.8%lower and 12.1%higher than the CSP plant,respectively.
