Geochemical characteristics and exploration significance of ultra-deep Sinian oil and gas from Well Tashen 5,Tarim Basin,NW China

The Well Tashen 5(TS5),drilled and completed at a vertical depth of 9017 m in the Tabei Uplift of the Tarim Basin,NW China,is the deepest well in Asia.It has been producing both oil and gas from the Sinian at a depth of 8780e8840 m,also the deepest in Asia in terms of oil discovery.In this paper,the geochemical characteristics of Sinian oil and gas from the well were investigated and compared with those of Cambrian oil and gas discovered in the same basin.The oil samples,with Pr/Ph ratio of 0.78 and a whole oil carbon isotopic value of31.6‰,have geochemical characteristics similar to those of Ordovician oils from the No.1 fault in the North Shuntuoguole area(also named Shunbei area)and the Middle Cambrian oil from wells Zhongshen 1(ZS1)and Zhongshen 5(ZS5)of Tazhong Uplift.The maturity of light hydrocarbons,diamondoids and aromatic fractions all suggest an approximate maturity of 1.5%e1.7%Ro for the samples.The(4-+3-)methyldiamantane concentration of the samples is 113.5 mg/g,indicating intense cracking with a cracking degree of about 80%,which is consistent with the high bottom hole temperature(179℃).The Sinian gas samples are dry with a dryness coefficient of 0.97.The gas is a mixture of kerogen-cracking gas and oil-cracking gas and has Ro values ranging between 1.5%and 1.7%,and methane carbon isotopic values of41.6‰.Based on the equivalent vitrinite reflectance(R_(eqv)=1.51%e1.61%)and the thermal evolution of source rocks from the Cambrian Yu'ertusi Formation of the same well,it is proposed that the Sinian oil and gas be mainly sourced from the Cambrian Yu'ertusi Formation during the Himalayan period but probably also be joined by hydrocarbon of higher maturity that migrated from other source rocks in deeper formations.The discovery of Sinian oil and gas from Well TS5 suggests that the ancient ultra-deep strata in the northern Tarim Basin have the potential for finding volatile oil or condensate reservoirs.

Structural architecture of Neoproterozoic rifting depression groups in the Tarim Basin and their formation dynamics

The Tarim Basin is the largest, oil-bearing, superimposed basin in the northwest of China. The evolution and tectonic properties of the initial Tarim Basin have been hotly disputed and remain enigmatic. The Neoproterozoic basin is covered by a vast desert and a huge-thickness of sedimentary strata, has experienced multiple tectonic movements, had a low signal to noise ratios(SNRs) of deep seismic reflection data, all of which have posed critical obstacles to research. We analysed four field outcrops, 18 wells distributed throughout the basin, 27 reprocessed seismic reflection profiles with higher SNRs across the basin and many ancillary local 2D and 3D profiles and aeromagnetic data. We found about 20 normal fault-controlled rifting depressions of the Cryogenian and Ediacaran scattered throughout the basin, which developed on the Precambrian metamorphic and crystalline basement. The structural framework is clearly different from that of the overlying Phanerozoic. The rifting depressions consist of mainly half grabens, symmetrical troughs and horst-grabens. From the northeast to southwest of the basin,they are divided into three rifting depression groups with the WNW, ENE, and NW-trends that are mainly controlled by normal faults. The maximum thicknesses of the strata are up to 4100 m. From the Cryogenian to Ediacaran, most of the main inherited faults to active and eventually ceased at the end of the Ediacaran or Early Cambrian, while subsidence centres appeared and migrated eastward along the faults. They revealed that the different parts of the Tarim continental block were in NNE-SSWoriented and NNW-SSE-oriented extensional paleo-stress fields(relative to the present) during the Neoproterozoic, and were accompanied by clockwise shearing. According to the analysis of the activities of syn-sedimentary faults, filling sediments,magmatic events, and coordination with aeromagnetic anomalies, the tectonic properties of the fault depressions are different and are primarily continental rifts or intra-continental fault-controlled basins. The rifting phases mainly occurred from 0.8–0.61 Ga.The formation of the rifting depression was associated with the initial opening of the South Altun-West Kunlun Ocean and the South Tianshan Ocean, which were located at the northern and southern margins of the Tarim Block, respectively, in response to the break-up of the Supercontinent Rodinia and the initial opening of the Proto-Tethys Ocean.

A geometric model of faulted detachment folding with pure shear and its application in the Tarim Basin, NW China

We present an improved geometric model of faulted detachment folding with pure shear that is characterized by core thickening and a ramp-discordant backlimb. The model includes a two-stage evolution： 1） detachment folding involving pure shear with fixed hinges, and 2） faulted detachment folding, in which the core of anticline thrusts above a break-through fault in forelimb by limb rotation. The growth strata patterns of the model are also discussed with respect to factors such as limb rotation, tectonic uplift rate, and sedimentation rate. A thrust-related fold, called a TBE thrust fold, in the Tarim Basin in NW China, is analyzed as an example of the theoretical model. The result indicates that the TBE thrust fold has undergone a two-stage evolution with shortening of a few hundred meters. Both the theoretical model and the actual example indicate that the shortening in the detachment folding stage takes up a large proportion of the total shortening. The structural restoration of the TBE thrust fold also provides new evidence that the formation of a series of thin-skinned structures in the SE Tarim Basin initiated in the Late Ordovician. The model may be applicable to low-amplitude faulted detachment folds.