Recent results of High Nitrogen Pressure Solution (HNPS) growth of GaN crystals deposited on and separated from 2 inch,and smaller,GaN substrates grown by Hydride Vapor Phase Epitaxy (HVPE) have been presented. The in...Recent results of High Nitrogen Pressure Solution (HNPS) growth of GaN crystals deposited on and separated from 2 inch,and smaller,GaN substrates grown by Hydride Vapor Phase Epitaxy (HVPE) have been presented. The influence of the c-plane bowing in the initial substrate on quality,rate and mode of growth by HNPS method has been analyzed in details.展开更多
Cyclic pressure pulsing with nitrogen is studied for hydraulically fractured wells in depleted reservoirs.A compositional simulation model is constructed to represent the hydraulic fractures through local-grid refinem...Cyclic pressure pulsing with nitrogen is studied for hydraulically fractured wells in depleted reservoirs.A compositional simulation model is constructed to represent the hydraulic fractures through local-grid refinement.The process is analyzed from both operational and reservoir/hydraulic-fracture perspectives.Key sensitivity parameters for the operational component are chosen as the injection rate,lengths of injection and soaking periods and the economic rate limit to shut-in the well.For the reservoir/hydraulic fracturing components,reservoir permeability,hydraulic fracture permeability,effective thickness and half-length are used.These parameters are varied at five levels.A full-factorial experimental design is utilized to run 1250 cases.The study shows that within the ranges studied,the gas-injection process is applied successfully for a 20-year project period with net present values based on the incremental recoveries greater than zero.It is observed that the cycle rate limit,injection and soaking periods must be optimized to maximize the efficiency.The simulation results are used to develop a neural network based proxy model that can be used as a screening tool for the process.The proxy model is validated with blind-cases with a correlation coefficient of 0.96.展开更多
Pure nitrogen gas was heated with direct current arc, at input powers from several hundred Watt to over 5 kW, and then injected through a nozzle into a chamber at 1 or 10 Pa pressure, with the purpose of accelerating ...Pure nitrogen gas was heated with direct current arc, at input powers from several hundred Watt to over 5 kW, and then injected through a nozzle into a chamber at 1 or 10 Pa pressure, with the purpose of accelerating the gas to very high speed around 7 km/s. Various structures of the arc generator and gas expansion nozzle were examined. Results show that bypass exhausting of the boundary layer before it enters the nozzle divergent section can greatly increase flow speed of the jet, thus it might be possible to use nitrogen as a working gas in high speed gas dynamic test facilities.展开更多
Owing to the characteristics of arc ion plating(AIP) technique, the structure and composition of TiAlN films can be tailored by controlling of various parameters such as compositions of target materials, N2 partial pr...Owing to the characteristics of arc ion plating(AIP) technique, the structure and composition of TiAlN films can be tailored by controlling of various parameters such as compositions of target materials, N2 partial pressure, substrate bias and so on. In this study, several titanium aluminum nitride films were deposited on 1Cr11Ni2W2MoV steel for compressor blade of areo-engine under different d.c pulse bias voltage and nitrogen partial pressure. The effects of substrate pulse bias and nitrogen partial pressure on the deposition rate, droplet formation, microstruture and elemental component of the films were investigated.展开更多
[Objective] The research aimed to study the determination of 16 kinds of OCPs in water by liquid-liquid extraction -GC. [Method] The new method for determining 16 kinds of OCPs in water by liquid-liquid extraction -GC...[Objective] The research aimed to study the determination of 16 kinds of OCPs in water by liquid-liquid extraction -GC. [Method] The new method for determining 16 kinds of OCPs in water by liquid-liquid extraction -GC was established, and the influencing factors such as nitrogen pressure and water bath temperature were discussed. [ Result] Detection limit of the method was from 3.2 to 14.1 ng/L, the relative standard deviation was between 4.0% and 9.6%, and the average recovery ranged from 80.8% to 106.0%. By optimizing nitrogen pressure and water bath temperature in the sample pretreatment process, when nitrogen pressure was ＋0.087 kPa, and water bath temperature was ±36 ℃, recovery effect of this method was better. [ Conclusion] The determination method had accurate qualitative and quantitative results, and met detection requirement of 16 kinds of OCPs in water.展开更多
基金supported by the European Union within European Regional Development Fund,through grant Innovative Economy (POIG.01.01.02-00-008/08)
文摘Recent results of High Nitrogen Pressure Solution (HNPS) growth of GaN crystals deposited on and separated from 2 inch,and smaller,GaN substrates grown by Hydride Vapor Phase Epitaxy (HVPE) have been presented. The influence of the c-plane bowing in the initial substrate on quality,rate and mode of growth by HNPS method has been analyzed in details.
文摘Cyclic pressure pulsing with nitrogen is studied for hydraulically fractured wells in depleted reservoirs.A compositional simulation model is constructed to represent the hydraulic fractures through local-grid refinement.The process is analyzed from both operational and reservoir/hydraulic-fracture perspectives.Key sensitivity parameters for the operational component are chosen as the injection rate,lengths of injection and soaking periods and the economic rate limit to shut-in the well.For the reservoir/hydraulic fracturing components,reservoir permeability,hydraulic fracture permeability,effective thickness and half-length are used.These parameters are varied at five levels.A full-factorial experimental design is utilized to run 1250 cases.The study shows that within the ranges studied,the gas-injection process is applied successfully for a 20-year project period with net present values based on the incremental recoveries greater than zero.It is observed that the cycle rate limit,injection and soaking periods must be optimized to maximize the efficiency.The simulation results are used to develop a neural network based proxy model that can be used as a screening tool for the process.The proxy model is validated with blind-cases with a correlation coefficient of 0.96.
基金supported by the National Natural Science Foundation of China(Nos.11575273 and 11475239)
文摘Pure nitrogen gas was heated with direct current arc, at input powers from several hundred Watt to over 5 kW, and then injected through a nozzle into a chamber at 1 or 10 Pa pressure, with the purpose of accelerating the gas to very high speed around 7 km/s. Various structures of the arc generator and gas expansion nozzle were examined. Results show that bypass exhausting of the boundary layer before it enters the nozzle divergent section can greatly increase flow speed of the jet, thus it might be possible to use nitrogen as a working gas in high speed gas dynamic test facilities.
文摘Owing to the characteristics of arc ion plating(AIP) technique, the structure and composition of TiAlN films can be tailored by controlling of various parameters such as compositions of target materials, N2 partial pressure, substrate bias and so on. In this study, several titanium aluminum nitride films were deposited on 1Cr11Ni2W2MoV steel for compressor blade of areo-engine under different d.c pulse bias voltage and nitrogen partial pressure. The effects of substrate pulse bias and nitrogen partial pressure on the deposition rate, droplet formation, microstruture and elemental component of the films were investigated.
文摘[Objective] The research aimed to study the determination of 16 kinds of OCPs in water by liquid-liquid extraction -GC. [Method] The new method for determining 16 kinds of OCPs in water by liquid-liquid extraction -GC was established, and the influencing factors such as nitrogen pressure and water bath temperature were discussed. [ Result] Detection limit of the method was from 3.2 to 14.1 ng/L, the relative standard deviation was between 4.0% and 9.6%, and the average recovery ranged from 80.8% to 106.0%. By optimizing nitrogen pressure and water bath temperature in the sample pretreatment process, when nitrogen pressure was ＋0.087 kPa, and water bath temperature was ±36 ℃, recovery effect of this method was better. [ Conclusion] The determination method had accurate qualitative and quantitative results, and met detection requirement of 16 kinds of OCPs in water.
