Shoulder lines are the most important landform demarcations for geographical analysis,soil erosion modeling and land use planning in the Loess Plateau area of China.This paper proposes an automatic,effective and accur...Shoulder lines are the most important landform demarcations for geographical analysis,soil erosion modeling and land use planning in the Loess Plateau area of China.This paper proposes an automatic,effective and accurate method of determining loess shoulder line from DEMs by integrating a hydrological D8 algorithm and a snake model.The watershed boundary line is adopted as the initial contour which evolves to identify the exact position of loess shoulder-line by the guidance of an external force of snake model from DEMs.Experiments show that the method overcomes the difficulties in both threshold selection for edge detection and the disconnecting issues in former extraction approaches.The accuracy evaluation of shoulder-line maps from the two test sites of the loess plateau area show obvious improvements in the extraction.The average contour matching distance of the new method is 12.0 m on 5 m resolution DEM,and shows improvement in the accuracy and continuity.The comparisons of accuracy evaluations of the two test sites show that the snake model method performs better in the loess plain area than in the area with high gully density.展开更多
The dynamic transmission characteristics and the sensitivities of the three stage idler gear system of the new NC power turret are studied in the paper. Considering the strongly nonlinear factors such as the periodica...The dynamic transmission characteristics and the sensitivities of the three stage idler gear system of the new NC power turret are studied in the paper. Considering the strongly nonlinear factors such as the periodically time-varying mesh stiffness, the nonlinear tooth backlash, the lump-parameter model of the gear system is developed with one rotational and two translational freedoms of each gear. The eigen-values and eigenvectors are derived and analyzed on the basis of the real modal theory. The sensitivities of natural frequencies to design parameters including supporting and meshing stiffnesses, gear masses, and moments of inertia by the direct differential method are also calculated. The results show the quantitative and qualitative impact of the parameters to the natural characteristics of the gear system. Furthermore, the periodic steady state solutions are obtained by the numerical approach based on the nonlinear model. These results are employed to gain insights into the primary controlling parameters, to forecast the severity of the dynamic response, and to assess the acceptability of the gear design.展开更多
A research on difference scheme of image gravitational field in the GVF snake model is performed depending on the uniform stability and convergence conditions of the difference scheme.It is found that the original exp...A research on difference scheme of image gravitational field in the GVF snake model is performed depending on the uniform stability and convergence conditions of the difference scheme.It is found that the original explicit forward difference scheme puts a strict restriction on the diffusion coefficient in the partial differential equation which decelerates the convergence speed of difference equation iteration.A new difference scheme is put forward,which has the advantage of unconditional uniform stability and convergence,and the restriction on the coefficient of partial differential equation is removed.Through increasing the value of the coefficient appropriately,the image of boundary information transmission becomes faster.Hence,iteration calculations are decreased rapidly for a given transmission range.The simulation experiments indicate that the new difference scheme be higher efficiency than the traditional one.展开更多
We used GIS and maximum entropy to predict the potential distribution of six snake species belong to three families in Kroumiria（Northwestern Tunisia）： Natricidae（Natrix maura and Natrix astreptophora）, Colubrida...We used GIS and maximum entropy to predict the potential distribution of six snake species belong to three families in Kroumiria（Northwestern Tunisia）： Natricidae（Natrix maura and Natrix astreptophora）, Colubridae（Hemorrhois hippocrepis, Coronella girondica and Macroprotodon mauritanicus）, and Lamprophiidae（Malpolon insignitus）. The suitable habitat for each species was modelled using the maximum entropy algorithm, combining presence field data（collected during 16 years：2000–2015） with a set of seven environmental variables（mean annual precipitation, elevation, slope gradient,aspect, distance to watercourses, land surface temperature and normalized Differential Vegetation Index. The relative importance of these environmental variables was evaluated by jackknife tests and the predictive power of our models was assessed using the area under the receiver operating characteristic. The main explicative variables of the species distribution were distance from streams and elevation, with contributions ranging from 60 to 77 and from 10 to 25%,respectively. Our study provided the first habitat suitability models for snakes in Kroumiria and this information can be used by conservation biologists and land managers concerned with preserving snakes in Kroumiria.展开更多
A novel Snake model with region information is proposed to detect and track moving objects. Generally, the region-information-based approach is sensitive to illumination changes and small movement in the background, w...A novel Snake model with region information is proposed to detect and track moving objects. Generally, the region-information-based approach is sensitive to illumination changes and small movement in the background, while the edge-information-based approach often obtains incorrect results for ambiguous images. The two types of information are introduced in computing the image force. Edge-information-based features make the algorithm fast and robust, and region information makes the active confour energy function obtains correct results for ambiguous images. Furthermore, an automatic contour initialization method using double difference images is given to meet the requirement of video sequence tracking. Meanwhile, a simple forecast section is added to estimate the position of the contour in the algorithm so that it can improve the convergence speed of the active contour. Experimental results show that the computation time of the algorithm is less than 0.1 s/frame. And it can be applied to a real-time system.展开更多
基金supported by the National Natural Science Foundation of China (Grant Nos. 40930531, 41001294, 41301422)the Open Project Foundation of State Key Laboratory of Resources and Environmental Information System in China (Grant No. 2010KF0002SA)
文摘Shoulder lines are the most important landform demarcations for geographical analysis,soil erosion modeling and land use planning in the Loess Plateau area of China.This paper proposes an automatic,effective and accurate method of determining loess shoulder line from DEMs by integrating a hydrological D8 algorithm and a snake model.The watershed boundary line is adopted as the initial contour which evolves to identify the exact position of loess shoulder-line by the guidance of an external force of snake model from DEMs.Experiments show that the method overcomes the difficulties in both threshold selection for edge detection and the disconnecting issues in former extraction approaches.The accuracy evaluation of shoulder-line maps from the two test sites of the loess plateau area show obvious improvements in the extraction.The average contour matching distance of the new method is 12.0 m on 5 m resolution DEM,and shows improvement in the accuracy and continuity.The comparisons of accuracy evaluations of the two test sites show that the snake model method performs better in the loess plain area than in the area with high gully density.
文摘The dynamic transmission characteristics and the sensitivities of the three stage idler gear system of the new NC power turret are studied in the paper. Considering the strongly nonlinear factors such as the periodically time-varying mesh stiffness, the nonlinear tooth backlash, the lump-parameter model of the gear system is developed with one rotational and two translational freedoms of each gear. The eigen-values and eigenvectors are derived and analyzed on the basis of the real modal theory. The sensitivities of natural frequencies to design parameters including supporting and meshing stiffnesses, gear masses, and moments of inertia by the direct differential method are also calculated. The results show the quantitative and qualitative impact of the parameters to the natural characteristics of the gear system. Furthermore, the periodic steady state solutions are obtained by the numerical approach based on the nonlinear model. These results are employed to gain insights into the primary controlling parameters, to forecast the severity of the dynamic response, and to assess the acceptability of the gear design.
基金supported by the National Key Technology R&D Program for the 11th five-year plan(NO.2008BADC4B15)Dr.Start Fund Project of Sichuan University of Science and Engineering(NO.2010ZY019)+2 种基金the project of youth fund of Sichuan Province(NO.10ZB097)the project for talent introduction of Sichuan University of Science and Engineering(NO.2009XJKL002)the Graduate Student Innovation Fund of Sichuan University of Science and Engineering(NO.Y2011001)~~
文摘A research on difference scheme of image gravitational field in the GVF snake model is performed depending on the uniform stability and convergence conditions of the difference scheme.It is found that the original explicit forward difference scheme puts a strict restriction on the diffusion coefficient in the partial differential equation which decelerates the convergence speed of difference equation iteration.A new difference scheme is put forward,which has the advantage of unconditional uniform stability and convergence,and the restriction on the coefficient of partial differential equation is removed.Through increasing the value of the coefficient appropriately,the image of boundary information transmission becomes faster.Hence,iteration calculations are decreased rapidly for a given transmission range.The simulation experiments indicate that the new difference scheme be higher efficiency than the traditional one.
基金Funding support for this work was provided by the Silvo-Pastoral Institute of Tabarka
文摘We used GIS and maximum entropy to predict the potential distribution of six snake species belong to three families in Kroumiria（Northwestern Tunisia）： Natricidae（Natrix maura and Natrix astreptophora）, Colubridae（Hemorrhois hippocrepis, Coronella girondica and Macroprotodon mauritanicus）, and Lamprophiidae（Malpolon insignitus）. The suitable habitat for each species was modelled using the maximum entropy algorithm, combining presence field data（collected during 16 years：2000–2015） with a set of seven environmental variables（mean annual precipitation, elevation, slope gradient,aspect, distance to watercourses, land surface temperature and normalized Differential Vegetation Index. The relative importance of these environmental variables was evaluated by jackknife tests and the predictive power of our models was assessed using the area under the receiver operating characteristic. The main explicative variables of the species distribution were distance from streams and elevation, with contributions ranging from 60 to 77 and from 10 to 25%,respectively. Our study provided the first habitat suitability models for snakes in Kroumiria and this information can be used by conservation biologists and land managers concerned with preserving snakes in Kroumiria.
文摘A novel Snake model with region information is proposed to detect and track moving objects. Generally, the region-information-based approach is sensitive to illumination changes and small movement in the background, while the edge-information-based approach often obtains incorrect results for ambiguous images. The two types of information are introduced in computing the image force. Edge-information-based features make the algorithm fast and robust, and region information makes the active confour energy function obtains correct results for ambiguous images. Furthermore, an automatic contour initialization method using double difference images is given to meet the requirement of video sequence tracking. Meanwhile, a simple forecast section is added to estimate the position of the contour in the algorithm so that it can improve the convergence speed of the active contour. Experimental results show that the computation time of the algorithm is less than 0.1 s/frame. And it can be applied to a real-time system.
