The purpose of impedance matching for a Marx generator and DBD lamp is to limit the output current of the Marx generator,provide a large discharge current at ignition,and obtain fast voltage rising/falling edges and l...The purpose of impedance matching for a Marx generator and DBD lamp is to limit the output current of the Marx generator,provide a large discharge current at ignition,and obtain fast voltage rising/falling edges and large overshoot.In this paper,different impedance matching circuits（series inductor,parallel capacitor,and series inductor combined with parallel capacitor） are analyzed.It demonstrates that a series inductor could limit the Marx current.However,the discharge current is also limited.A parallel capacitor could provide a large discharge current,but the Marx current is also enlarged.A series inductor combined with a parallel capacitor takes full advantage of the inductor and capacitor,and avoids their shortcomings.Therefore,it is a good solution.Experimental results match the theoretical analysis well and show that both the series inductor and parallel capacitor improve the performance of the system.However,the series inductor combined with the parallel capacitor has the best performance.Compared with driving the DBD lamp with a Marx generator direcdy,an increase of 97.3%in radiant power and an increase of 59.3%in system efficiency are achieved using this matching circuit.展开更多
A 1.34 GHz-1=60 MHz low noise amplifier （LNA） designed in a 0.35 pm SiGe process is presented. The designed LNA exhibits a power gain of 21.46 dB and a noise figure （NF） of 1.27 dB at 1.34 GHz. The linearity is im...A 1.34 GHz-1=60 MHz low noise amplifier （LNA） designed in a 0.35 pm SiGe process is presented. The designed LNA exhibits a power gain of 21.46 dB and a noise figure （NF） of 1.27 dB at 1.34 GHz. The linearity is improved with an active biasing technique. The post-layout simulation shows an input referred 1-dB compression point （IPldn） of-11.52 dBm. Compared with the recent reported high gain LNAs, the proposed LNA has a much better linearity without degrading other performance. The LNA draws 10 mA current from a 3.3 V power supply.展开更多
针对NFC(near field communication)天线的交互效率不高,导致传输信号不稳定的问题,可以分析天线的参数与电路的结构,使天线性能达到最优。利用Ansoft HFSS(high frequency structure simulator)进行环形天线的建模与分析,讨论了天线的...针对NFC(near field communication)天线的交互效率不高,导致传输信号不稳定的问题,可以分析天线的参数与电路的结构,使天线性能达到最优。利用Ansoft HFSS(high frequency structure simulator)进行环形天线的建模与分析,讨论了天线的结构参数对天线性能的影响,分析了RLC电路对天线电感的影响,设计了串联匹配电路。对天线的带宽进行了优化,并对设计的耦合天线传输距离进行仿真,确定最佳耦合距离,提高天线的品质因数。结果表明:天线的回波损耗降低至-27.25 dB,最佳耦合距离为20 mm。展开更多
This paper presents a modified multi-resolution telescopic search algorithm (MRTlcSA) for the block-matching motion estimation. A novel inverse telescopic search is substituted for the conventional telescopic search, ...This paper presents a modified multi-resolution telescopic search algorithm (MRTlcSA) for the block-matching motion estimation. A novel inverse telescopic search is substituted for the conventional telescopic search, that reduces the on-chip memory size and memory bandwidth for VLSI implementation. In addition, strategies of motion track and adaptive search window are applied to reduce the computational complexity of motion estimation. Simulation results show that, compared with the MRTleSA, the proposed algorithm reduces the computational load to only 30% while preserving almost the same image quality. Comparisons on hardware cost and power consumption of the VLSI implementations using the two algorithms are also presented in the paper.展开更多
Study of radiation properties of mismatched microstrip termination is carried out in warm ionized electron plasma medium. Linearised hydrodynamic theory coupled with vector wave technique is used to investigate radiat...Study of radiation properties of mismatched microstrip termination is carried out in warm ionized electron plasma medium. Linearised hydrodynamic theory coupled with vector wave technique is used to investigate radiation patterns and radiated power of a microstrip mismatched termination in one component electron plasma media for different plasma to source frequencies .These properties are used to compare the performance of an open circuit discontinuity with those of matched microstrip termination. Matched terminations are found more suitable for applications at higher frequencies than an open circuit discontinuity in the plasma medium though in free space they are less suitable.展开更多
In this paper, an attempt has been made to produce a recipient system of wireless charge for a simple hearing aid so that electrical signal would be generated through detecting and receiving radio frequency waves (RF)...In this paper, an attempt has been made to produce a recipient system of wireless charge for a simple hearing aid so that electrical signal would be generated through detecting and receiving radio frequency waves (RF). The purpose of this design is to receive wireless charge for hearing aids and basically for any electronic device which is not required to a high energy for being setup. In this study, it has been demonstrated that as the amount of radio receiving energy increases, distance of receiver from antenna should be decreased;otherwise, either maximum amount of the receiving energy, or signal power density of the transmitter should be increased. Since it is impossible to be performed, it is decided to set up an energy receiving system constructed by rectenna and charge Circuit and to adjust their parameters to provide energy requirements for a device with low-power consumption. In this paper, different components of an energy receiving system from radio frequency band have been mentioned and a diagram block has been suggested. Subsequently, input impedance of designed antenna has been adjusted by provided relations. This impedance should be adjusted with the total impedance of regarded hearing aid Circuit by which the highest amount of received signal power is transferred to the battery of hearing aids. Received signal is converted to a dc voltage by rectifier diode. Finally, by applying a voltage regulator which has been designed using a common-collector amplifier not only the output voltage is kept constant, but the power is also strengthened. The battery of the hearing aids will be charged using the obtained power and voltage.展开更多
对于环境中存在的各种类型能量源,其往往具有不同的阻抗特性以及输出功率范围。为了提高能量收集系统的能量萃取能力,合理的接口电路设计是关键。基于此,通过对环境中光伏(Photovoltaic,PV)能量源微弱直流特性以及高效率收集和转化的研...对于环境中存在的各种类型能量源,其往往具有不同的阻抗特性以及输出功率范围。为了提高能量收集系统的能量萃取能力,合理的接口电路设计是关键。基于此,通过对环境中光伏(Photovoltaic,PV)能量源微弱直流特性以及高效率收集和转化的研究,在传统开路电压法(Open-Circuit Voltage,OCV)的基础上,结合输入电压纹波控制,提出了一种可实时最大功率点追踪(Maximum Power Point Tracking,MPPT)的预估算法。该预估算法根据能量源的输出特性,采用了分数开路电压法(Fractional Open-Circuit Voltage,FOCV),并根据纹波大小动态调节变换器的工作模式,实现阻抗匹配。为了尽可能减小因采样带来的能量损失,采用可片上全集成的较小的采样电容,并逐周期的进行开路电压采样和计算,实现了对源功率变化的高精度追踪。仿真结果表明,所提出的追踪算法能够实时监测能量源的状态,具有高的追踪速度和追踪精度,且采样时间仅需100 ns。能量源功率在1μW~10 mW范围内变化时,最短的追踪时间仅需4.37μs,追踪精度可达99.7%。展开更多
基金supported by National Natural Science Foundation of China under the Grant No.51277033
文摘The purpose of impedance matching for a Marx generator and DBD lamp is to limit the output current of the Marx generator,provide a large discharge current at ignition,and obtain fast voltage rising/falling edges and large overshoot.In this paper,different impedance matching circuits（series inductor,parallel capacitor,and series inductor combined with parallel capacitor） are analyzed.It demonstrates that a series inductor could limit the Marx current.However,the discharge current is also limited.A parallel capacitor could provide a large discharge current,but the Marx current is also enlarged.A series inductor combined with a parallel capacitor takes full advantage of the inductor and capacitor,and avoids their shortcomings.Therefore,it is a good solution.Experimental results match the theoretical analysis well and show that both the series inductor and parallel capacitor improve the performance of the system.However,the series inductor combined with the parallel capacitor has the best performance.Compared with driving the DBD lamp with a Marx generator direcdy,an increase of 97.3%in radiant power and an increase of 59.3%in system efficiency are achieved using this matching circuit.
文摘A 1.34 GHz-1=60 MHz low noise amplifier （LNA） designed in a 0.35 pm SiGe process is presented. The designed LNA exhibits a power gain of 21.46 dB and a noise figure （NF） of 1.27 dB at 1.34 GHz. The linearity is improved with an active biasing technique. The post-layout simulation shows an input referred 1-dB compression point （IPldn） of-11.52 dBm. Compared with the recent reported high gain LNAs, the proposed LNA has a much better linearity without degrading other performance. The LNA draws 10 mA current from a 3.3 V power supply.
文摘针对NFC(near field communication)天线的交互效率不高,导致传输信号不稳定的问题,可以分析天线的参数与电路的结构,使天线性能达到最优。利用Ansoft HFSS(high frequency structure simulator)进行环形天线的建模与分析,讨论了天线的结构参数对天线性能的影响,分析了RLC电路对天线电感的影响,设计了串联匹配电路。对天线的带宽进行了优化,并对设计的耦合天线传输距离进行仿真,确定最佳耦合距离,提高天线的品质因数。结果表明:天线的回波损耗降低至-27.25 dB,最佳耦合距离为20 mm。
文摘This paper presents a modified multi-resolution telescopic search algorithm (MRTlcSA) for the block-matching motion estimation. A novel inverse telescopic search is substituted for the conventional telescopic search, that reduces the on-chip memory size and memory bandwidth for VLSI implementation. In addition, strategies of motion track and adaptive search window are applied to reduce the computational complexity of motion estimation. Simulation results show that, compared with the MRTleSA, the proposed algorithm reduces the computational load to only 30% while preserving almost the same image quality. Comparisons on hardware cost and power consumption of the VLSI implementations using the two algorithms are also presented in the paper.
文摘Study of radiation properties of mismatched microstrip termination is carried out in warm ionized electron plasma medium. Linearised hydrodynamic theory coupled with vector wave technique is used to investigate radiation patterns and radiated power of a microstrip mismatched termination in one component electron plasma media for different plasma to source frequencies .These properties are used to compare the performance of an open circuit discontinuity with those of matched microstrip termination. Matched terminations are found more suitable for applications at higher frequencies than an open circuit discontinuity in the plasma medium though in free space they are less suitable.
文摘In this paper, an attempt has been made to produce a recipient system of wireless charge for a simple hearing aid so that electrical signal would be generated through detecting and receiving radio frequency waves (RF). The purpose of this design is to receive wireless charge for hearing aids and basically for any electronic device which is not required to a high energy for being setup. In this study, it has been demonstrated that as the amount of radio receiving energy increases, distance of receiver from antenna should be decreased;otherwise, either maximum amount of the receiving energy, or signal power density of the transmitter should be increased. Since it is impossible to be performed, it is decided to set up an energy receiving system constructed by rectenna and charge Circuit and to adjust their parameters to provide energy requirements for a device with low-power consumption. In this paper, different components of an energy receiving system from radio frequency band have been mentioned and a diagram block has been suggested. Subsequently, input impedance of designed antenna has been adjusted by provided relations. This impedance should be adjusted with the total impedance of regarded hearing aid Circuit by which the highest amount of received signal power is transferred to the battery of hearing aids. Received signal is converted to a dc voltage by rectifier diode. Finally, by applying a voltage regulator which has been designed using a common-collector amplifier not only the output voltage is kept constant, but the power is also strengthened. The battery of the hearing aids will be charged using the obtained power and voltage.
文摘对于环境中存在的各种类型能量源,其往往具有不同的阻抗特性以及输出功率范围。为了提高能量收集系统的能量萃取能力,合理的接口电路设计是关键。基于此,通过对环境中光伏(Photovoltaic,PV)能量源微弱直流特性以及高效率收集和转化的研究,在传统开路电压法(Open-Circuit Voltage,OCV)的基础上,结合输入电压纹波控制,提出了一种可实时最大功率点追踪(Maximum Power Point Tracking,MPPT)的预估算法。该预估算法根据能量源的输出特性,采用了分数开路电压法(Fractional Open-Circuit Voltage,FOCV),并根据纹波大小动态调节变换器的工作模式,实现阻抗匹配。为了尽可能减小因采样带来的能量损失,采用可片上全集成的较小的采样电容,并逐周期的进行开路电压采样和计算,实现了对源功率变化的高精度追踪。仿真结果表明,所提出的追踪算法能够实时监测能量源的状态,具有高的追踪速度和追踪精度,且采样时间仅需100 ns。能量源功率在1μW~10 mW范围内变化时,最短的追踪时间仅需4.37μs,追踪精度可达99.7%。
