期刊文献+
共找到5篇文章
< 1 >
每页显示 20 50 100
应力时效影响Al-10Zn-3Mg-3Cu合金带外纵筋筒形件组织性能研究
1
作者 任贤魏 崔旭 +1 位作者 赵熹 薛勇 《精密成形工程》 北大核心 2024年第3期76-85,共10页
目的研究应力时效条件下Al-10Zn-3Mg-3Cu合金带外纵筋筒形件筋部试样的应力松弛行为,探明基体应力松弛机制以及强韧性协同提升机理。方法针对淬火态筋部试样,设计不同的初始应力值进行应力时效实验,然后采用数据分析与微观组织形貌表征... 目的研究应力时效条件下Al-10Zn-3Mg-3Cu合金带外纵筋筒形件筋部试样的应力松弛行为,探明基体应力松弛机制以及强韧性协同提升机理。方法针对淬火态筋部试样,设计不同的初始应力值进行应力时效实验,然后采用数据分析与微观组织形貌表征方法研究试样组织性能。结果当施加的初始应力为250MPa时,筋部试样的应力松弛程度可达85.8%,同时,试样抗拉强度为736.40 MPa,屈服强度为697.53 MPa,延伸率为10.96%。结论在250MPa应力时效条件下,应力松弛机制主要为晶界Coble蠕变和位错运动,位错运动促进了亚晶的增殖,Coble蠕变使基体晶粒长大,这些行为促使试样应力耗散。同时,应力时效改变了析出相形态,发展了具有孪生界面的复合析出相。经分子动力学计算可知,该特征微结构有利于基体强韧性的协同提升。 展开更多
关键词 应力时效 al-10zn-3mg-3cu合金 应力松弛 强韧性 析出相
下载PDF
间断直流磁场对Al-5Mg-3Zn-1Cu合金凝固组织和性能的影响
2
作者 曾麟添 周全 +2 位作者 陈乐平 刘武平 刘厚清 《机械工程材料》 CAS CSCD 北大核心 2024年第1期22-28,共7页
对Al-5Mg-3Zn-1Cu合金的凝固过程施加不同直流电压(0~300 V)和放电频率(0~20 Hz)以及占空比为30%的间断直流磁场,研究了间断直流磁场对其凝固组织及力学性能的影响。结果表明:间断直流磁场有效细化了合金的凝固组织,初生α-Al相由无磁... 对Al-5Mg-3Zn-1Cu合金的凝固过程施加不同直流电压(0~300 V)和放电频率(0~20 Hz)以及占空比为30%的间断直流磁场,研究了间断直流磁场对其凝固组织及力学性能的影响。结果表明:间断直流磁场有效细化了合金的凝固组织,初生α-Al相由无磁场时的粗大枝晶变为细小的蔷薇状晶粒,第二相由粗大而连续的网格状结构变为细小而断续分布结构。随着直流电压的增加,合金的晶粒尺寸、第二相体积分数和长度均减小,抗压强度和断裂应变均先升后降;随着放电频率的增加,晶粒尺寸、第二相体积分数和长度均先减小后增大,抗压强度和断裂应变均先升后降。施加间断直流磁场后,合金的拉伸性能提高,断口中的准解理面减少,撕裂棱增多。当直流电压为200 V、放电频率为5 Hz时,合金的抗压强度和断裂应变最大,与无磁场时相比分别提高了31.6%和43%,抗拉强度和断后伸长率则分别提高了79.71%和83.3%。 展开更多
关键词 al-5mg-3zn-1cu合金 间断直流磁场 凝固组织 力学性能
下载PDF
Effects of Mg content on microstructure and mechanical properties of low Zn-containing Al-xMg-3Zn-1Cu cast alloys 被引量:1
3
作者 Chuan LEI Qu-dong WANG +5 位作者 Hua-ping TANG Tian-wen LIU Zhong-yang LI Hai-yan JIANG Kui WANG Wen-jiang DING 《Transactions of Nonferrous Metals Society of China》 SCIE EI CAS CSCD 2022年第3期721-738,共18页
Effects of Mg content on the microstructure and mechanical properties of low Zn-containing Al−xMg−3Zn−1Cu cast alloys(x=3−5,wt.%)were investigated.As Mg content increased in the as-cast alloys,the grains were refined ... Effects of Mg content on the microstructure and mechanical properties of low Zn-containing Al−xMg−3Zn−1Cu cast alloys(x=3−5,wt.%)were investigated.As Mg content increased in the as-cast alloys,the grains were refined due to enhanced growth restriction,and the formation ofη-Mg(AlZnCu)_(2) and S-Al_(2)CuMg phases was inhibited while the formation of T-Mg_(32)(AlZnCu)_(49 )phase was promoted when Mg content exceeded 4 wt.%.The increase of Mg content encumbered the solution kinetics by increasing the size of eutectic phase but accelerated and enhanced the age-hardening through expediting precipitation kinetics and elevating the number density of the precipitates.As Mg content increased,the yield strength and tensile strength of the as-cast,solution-treated and peak-aged alloys were severally improved,while the elongation of the alloys decreased.The tensile strength and elongation of the peak-aged Al−5Mg−3Zn−1Cu alloy exceed 500 MPa and 5%,respectively.Precipitation strengthening implemented by T′precipitates is the predominant strengthening mechanism in the peak-aged alloys and is enhanced by increasing Mg content. 展开更多
关键词 Mg content low zn-containing al-x mg-3zn-1cu cast alloys microstructure aging response strengthening mechanism
下载PDF
Microstructure of Mg-8Zn-4Al-1Ca aged alloy 被引量:1
4
作者 董允 林小娉 +2 位作者 叶杰 郑润国 何娜 《Transactions of Nonferrous Metals Society of China》 SCIE EI CAS CSCD 2014年第2期310-315,共6页
The microstructure of Mg-8Zn-4Al-1Ca aged alloy was investigated by TEM and HRTEM. The results show that the hardening produced in the Mg-8Zn-4Al-1Ca alloy is considerably higher than that in the Mg-8Zn-4A1 alloy. A d... The microstructure of Mg-8Zn-4Al-1Ca aged alloy was investigated by TEM and HRTEM. The results show that the hardening produced in the Mg-8Zn-4Al-1Ca alloy is considerably higher than that in the Mg-8Zn-4A1 alloy. A dense dispersion of disc-like Ca2Mg6Zn3 precipitates are formed in Mg-8Zn-4Al-1Ca alloy aged at 160 ℃ for 16 h. In addition, the lattice distortions, honeycomb-looking Moir&#233; fringes, edge dislocations and dislocation loop also exist in the microstructure. The precipitates of alloy aged at 160 ℃ for 48 h are coarse disc-like and fine dispersed grainy. When the alloy is subjected to aging at 160 ℃ for 227 h, the microstructure consists of numerous MgZn2 precipitates and Ca2Mg6Zn3 precipitates. All the analyses show that Ca is a particularly effective trace addition in improving the age-hardening and postponing the formation of MgZn2 precipitates in Mg-8Zn-4Al alloy aged at 160 ℃. 展开更多
关键词 mg-8zn-4al-1 Ca alloy age hardening Ca2Mg6Zn3 Moire fringe
下载PDF
Al-5Mg-3Zn-1Cu铝卡钳壳体的倾转铸造模拟与试制
5
作者 汤华平 毕云杰 +4 位作者 王渠东 韩斌 娄俊岭 张磊 关俊清 《特种铸造及有色合金》 CAS 北大核心 2023年第5期690-694,共5页
针对Al-5Mg-3Zn-1Cu铝卡钳壳体的倾转铸造工艺,利用ProCAST软件对铸件充型和凝固过程进行模拟,分析缺陷形成原因。对卡钳壳体结构进行优化,扩大铝液流动和补缩通道,并进行数值模拟和试制验证。结果表明,优化后的铸件实现了顺序凝固,避... 针对Al-5Mg-3Zn-1Cu铝卡钳壳体的倾转铸造工艺,利用ProCAST软件对铸件充型和凝固过程进行模拟,分析缺陷形成原因。对卡钳壳体结构进行优化,扩大铝液流动和补缩通道,并进行数值模拟和试制验证。结果表明,优化后的铸件实现了顺序凝固,避免形成孤立液相区并消除了缩孔缺陷。采用倾转铸造工艺试制的Al-5Mg-3Zn-1Cu铝卡钳壳体铸件表面光洁,内部组织致密均匀,且无缩孔、缩松缺陷。 展开更多
关键词 al-5mg-3zn-1cu合金 倾转铸造 数值模拟
原文传递
上一页 1 下一页 到第
使用帮助 返回顶部