Activation Characteristics of Ml_ (1-x)Mm_x(Ni_ ( 3.550Co_ ( 0.750Mn_ (0.4)Al_ ( 0.3)) Hydrogen Storage Alloys After Surface Modification

The surface of multicomponents Ml_ 1-xMm_x(Ni_ 3.55Co_ 0.75Mn_ 0.4Al_ 0.3)(x=0, 0.1, 0.2, 0.3, 0.4, 0.5) hydrogen storage alloys was impregnated in the vitriol liquor (0.01, 0.02, 0.04 mol·L -1) for five minutes at room temperature. With the following charge/discharge procedure, I_c=60 mAh·g -1×7.5 h, I_d=60 mAh·g -1, the final cutoff voltage was -0.60 V (vs. Hg/HgO), activation characteristics of the alloys with different Ml∶Mm ratio were investigated. And the effects on activation characteristics of alloys modified by different surface methods were also investigated. The results indicate that Ml:Mm ratio and different surface modification process have a prominent effect on activation characteristics of the alloys. Activation characteristics and initial discharge capacities of the alloys have a great improvement after surface modification. The effects of activation characteristics are more obvious with the vitriol concentration increasing. The alloy Ml_ 0.7Mm_ 0.3(Ni_ 3.55Co_ 0.75Mn_ 0.4Al_ 0.3) shows the best activation characteristics and a maximum discharge capacity. With surface modification, the alloy was activated after 2 cycles, and the maximum discharge capacity is 250.1 mAh·g -1.

ANALYSIS OF “BIMODAL PATTERN” STORM ACTIVITY CHARACTERISTICS OF THE BAY OF BENGAL

Storms that occur at the Bay of Bengal(Bo B) are of a bimodal pattern, which is different from that of the other sea areas. By using the NCEP, SST and JTWC data, the causes of the bimodal pattern storm activity of the Bo B are diagnosed and analyzed in this paper. The result shows that the seasonal variation of general atmosphere circulation in East Asia has a regulating and controlling impact on the Bo B storm activity, and the "bimodal period" of the storm activity corresponds exactly to the seasonal conversion period of atmospheric circulation. The minor wind speed of shear spring and autumn contributed to the storm, which was a crucial factor for the generation and occurrence of the"bimodal pattern"storm activity in the Bo B. The analysis on sea surface temperature(SST) shows that the SSTs of all the year around in the Bo B area meet the conditions required for the generation of tropical cyclones(TCs). However,the SSTs in the central area of the bay are higher than that of the surrounding areas in spring and autumn, which facilitates the occurrence of a "two-peak"storm activity pattern. The genesis potential index(GPI) quantifies and reflects the environmental conditions for the generation of the Bo B storms. For GPI, the intense low-level vortex disturbance in the troposphere and high-humidity atmosphere are the sufficient conditions for storms, while large maximum wind velocity of the ground vortex radius and small vertical wind shear are the necessary conditions of storms.

Analysis of genotype differences of rice response to low Zn^(2+) activity and some morphological characteristics

Zinc deficiency is one of the most widespreadmicro-nutritional disorder for rice. To solve the problem, screening Zn-efficient cultivars isan available method and understanding geno-

Three-dimensional crustal velocity structure and activity characteristics of the Madoi Ms7.4 earthquake in 2021

In this paper,using natural earthquake P-wave arrival time data recorded by the seismic network in the surrounding area of Madoi,the three-dimensional fine P-wave crustal velocity structure at depths above 60 km in the epicenter of the Madoi Ms7.4 earthquake was inverted using the double-difference seismic tomography method.On the basis of the relocation of the source of the aftershock sequence,we summarized the strip-shaped distribution characteristics along the strike of the Jiangcuo fault,revealing the significant heterogeneity of the crustal velocity structure in the source area.Research has found that most of the Madoi Ms7.4 aftershocks were located in the weak area of the high-speed anomaly in the upper crust.The focal depth changed with the velocity structure,showing obvious fluctuation and segmentation characteristics.There was a good correspondence between the spatial distribution and the velocity structure.The high-velocity bodies of the upper crust in the hypocenter area provided a medium environment for earthquake rupture,the low-velocity bodies of the middle crust formed the deep material,and the migration channel and the undulating shape of the high-speed body in the lower crust corroborated the strong pushing action in the region.The results confirmed that under the continuous promotion of tectonic stress in the Madoi area,the high-speed body of the Jiangcuo fault blocked the migration of weak materials in the middle crust.When the stress accumulation exceeded the limit,the Madoi Ms7.4 earthquake occurred.Meanwhile,the nonuniform velocity structure near the fault plane determined the location of the main shock and the spatiotemporal distribution of the aftershock sequence.

Research on Present Activity Characteristics of Heizi Fault and Discussion of Its Relative Problems

Based on other previous researches, we recalculate the micro-displacement along the Heizi fault with recent deformation data of the Heizi reservoir. The result shows that activity characteristics of Heizi fault has changed greatly since 1973 and have experienced four phases. The third phase is characteristics of normal fault, and others characteristic of reverse faults. Constructing the reservoir dam and reservoir sluice has important effect on present activity of the fault, even changed the activity characteristics of faults in some phases. Seismicity has some effect on deformation data and fault activity.

Kinetic Characteristics in Pyrolysis of RPF with Additives

PVC（polyvinyl chloride） was isolated from waste plastic before manufacturing RPF（refuse paper ＆ plastic fuel）, and the characteristics of manufactured RPF including properties, calorific value, pyrolysis, chlorine content and kinetics analysis were analyzed. Based on the result of TGA（Thermogravimetric analysis）, the kinetics characteristics was analyzed by using Kissinger method and Ozawa method which are the most common methods for obtaining activation energy, and the experimental conditions of TGA were set as follows： in a nitrogen atmosphere, with gas flow rate of 20mL/min, heating rate of 5-50 ℃/min, and maximum temperature of 800 ℃. In conclusion, the activation energy showed a tendency to gradually increase by a rise of reaction rate. Although the activation energy with pyrolysis of RPF was irregularly scattered, it was shown that the activation energy was stabilized by co-pyrolysis of RPF and additives（rice bran and sawdust）.

Analysis of Some Characteristics of the Fault Activities in Eastern China by Satellite Images

Active faults have special electromagnetic effect and remote sensing characteristics, and exhibit unique im-agery marks in satellite images. A comprehensive comparison of images of active faults in eastern China and ananalysis of geologic and geomorphic data can tell us some characteristics of fault activity in the area during theneotectonic period: 1) The fault activities of the north-south tectonic zone, North China and Taiwan werestronger than those of southeastern and northeastern China; 2) the faulting in the north-south tectonic zone,North China and Taiwan has continued up to now, and most of the fault activites in southeastern andnorth-eastern China have become weaker since the Middle Pleistocene; 3) the activity is unsteady in time, mostbeing intermittent, or episodic, i.e. alternately strong and weak; 4) most active faults of a definite size can be di-vided into several segments which somewhat differ from each other in the characteristics of the activity.

Analysis of Seismic Activity Characteristics before the Yutian M_S7.3 Earthquake,Xinjiang on February 12,2014

This paper introduces the geological structure background around the 2014 Yutian Ms7. 3 earthquake area, investigates and analyzes the regime of small earthquake activity and the characteristics of regional seismicity pattern in Xinjiang before the earthquake, and compares the characteristics of the regional seismic activity with the 2008 Yutian Ms7.3 earthquake. The results show： ① 2 ~ 3 years before the 2014 Yutian Ms7. 3 earthquake, Xinjiang was in a seismic active state with strong earthquake occurring successively, and before the 2008 Ms 7. 3 earthquake, Xinjiang was in the quiet state of moderate-small earthquakes with M3. 0 ~ 4. 0. ② Before this Yutian Ms7. 3 earthquake, the regional seismic activity showed a short-term anomaly feature, that is, seismicity of M ≥ 5. 0 earthquakes significantly increased on the Altun seismic zone and in the source area three years before the Ms7.3 earthquake, while a five year long quiescence of seismicity of M ≥4. 0 earthquakes appeared on the east of the source area in a range of about 440kin. Six months before this M7. 3 earthquake, there existed seismic gap of M3. 0 ~ 4. 0 earthquakes and near-conjugate seismic belt magnitude 3. 0 and 4. 0 in the source area. ③ The state of strong earthquake activity and the seismicity pattern of small earthquakes before this Yutian Ms7. 3 earthquake were significantly different to that before the 2008 Yutian Ms7. 3 earthquake, and this may be related to the different seismogenic environments of the two Ms7. 3 earthquakes.

New Activity of the Tanlu Fault Zone in the South of Huaihe to the Nvshanhu Segment since the Late Quaternary

Taking the Huaihe to the Nvshanhu segment of the Tanlu( Tancheng-Lujiang) fault zone as the main research target to explore whether there has been new activity since the late Quaternary,and based on the interpretation of remote sensing images and repeated surface investigations,we excavated trenches at the sections where the tectonic landform is significant,identified and recorded the deformation patterns of the fault and analyzed the activity behavior. Samples of new activity and deformation were collected and oriented slices were ground based on the samples ' original state to make the micro structural analysis and demonstration. All of the above research shows very clear linear tectonic geomorphology along the fault,three trenches across the fault zone all revealed new deformation traces since late Quaternary. The latest stratum dislocated by the fault is the late Quaternary and Holocene. The main slip mode is stick slip,as represented typically by fault scarps,wedge accumulation,the faults and the filled cracks and so on. In general,it shows the characteristics of brittle high-speed deformation and belongs to the prehistoric earthquake ruins. The above understanding was confirmed partially by microscopic analysis. In addition,the similarities and differences and the possible reasons for the characteristics of the latest activities of the Tancheng-Lujiang fault zone in the north and south of the Huaihe River regions are also discussed in this paper.

LINEAR ACTIVE STRUCTURES AND MODES (Ⅱ) —DISCRETE SYSTEMS AND BEAMS

The basic concepts about the active structures and some attributes of the modes were presented in paper “Liner Active Structures and Modes]( I) ". The characteristics of the active discrete systems and active beams were discussed, especially, the stability of the active structures and the orthogonality of the eigenvectors. The notes about modes were portrayed by a model of a seven-storeyed building with sensors and actuators. The concept of the adjoint active structure was extended from the discrete systems to the beams that were the representations of the continuous structures. Two types of beams with different placements of the measuring and actuating systems were discussed in detail. One is the beam with the discrete sensors and actuators, and the other is the beam with distributed sensor and actuator function. The orthogonality conditions were derived with the modal shapes of the active beam and its adjoint active beam. An example shows that the variation of eigenvalues with feedback amplitude for the homo-configuration and non-homo-configuration active structures.

Clinical characteristics of macrophage activation syndrome secondary to systemic lupus erythematosus

Objective To investigate the clinical features of macrophage activation syndrome(MAS)associated with systemic lupus erythematosus(SLE).Methods The clinical data of 15 patients with SLE-induced MAS diagnosed in Peking Union Medical College Hospital from July

Association of secretory IgA with clinical pathological characteristics and complement activation in IgA nephropathy

Objective To further investigate the association among clinical pathology,complement activation and renal secretory IgA(SIgA)deposition in patients with IgA nephropathy(IgAN).Methods The activation of serum complements was detected by immunoturbidimetry and ELISA.Renal deposition of SIgA and activation of complements were detected by immunofluorescence.

Combustion Characteristics and Kinetics of Anthracite Blending with Pine Sawdust

The combustion characteristics and kinetics of anthracite,pine sawdust and their blends were investigated under combustion condition by thermogravimetric analysis,respectively.The fractions of pine sawdust in the blended samples were set to be 30%,50%,and 80%.The results showed that the ignition and burnout temperatures of pine sawdust were lower and the maximum combustion rate was higher than those of anthracite.With the increase of pine sawdust content,the ignition temperature and burnout temperature of the blends decreased,while the maximum mass loss rate and the combustible index of the blends increased;that is,the comprehensive combustion property became better.The kinetic parameters for the blends combustion under air condition were calculated based on experimental results using Coats-Redfern model.When the pine sawdust content varied in the range of 30%-80%,the combustion processes of these blends could be divided into two stages and the combustion reactions belong to the first-order reaction.The values of apparent activation energy at two individual stages decreased from 68.78to47.28kJ·mol-1 and from 113.53 to 46.43kJ·mol-1,respectively.

Hot Deformation Behavior of a Novel Ni-Cr-Mo-B Ultra-heavy Plate Steel by Hot Compression Test

Hot deformation behavior of a novel Ni-Cr-Mo-B heavy plate steel was studied by hot compression tests,which were conducted on a Gleeble-3800thermo-mechanical simulator corresponding to the temperature range of850-1 150℃ with the strain rates of 0.01-10s-1 and the true strain of 0.8.The results suggest that the majority of flow curves exhibit a typical dynamic recrystallization（DRX）behavior with an apparent single peak stress followed by agradual fall towards a steady-state stress.Important characteristic parameters of flow behavior as critical stress/strain for initiation of DRX and peak and steady-state stress/strain were derived from curves of strain hardening rate versus stress and stress versus strain,respectively.Material constants of the investigated steel were determined based on Arrhenius-type constitutive equation,and then the peak stress was predicted by the equation with the hot deformation activation energy of 379 139J/mol,and the predicted values agree well with the experimental values.Furthermore,the effect of Zener-Hollomon parameter on the characteristic points of flow curves was studied using the power law relation,and the ratio of critical stress and strain to peak stress and strain were found to be 0.91and0.46,respectively.