Simulation study of hydrogen sulfide removal in underground gas storage converted from the multilayered sour gas field

A simulation study was carried out to investigate the temporal evolution of H_(2)S in the Huangcaoxia underground gas storage (UGS), which is converted from a depleted sulfur-containing gas field. Based on the rock and fluid properties of the Huangcaoxia gas field, a multilayered model was built. The upper layer Jia-2 contains a high concentration of H_(2)S (27.2 g/m^(3)), and the lower layer Jia-1 contains a low concentration of H_(2)S (14.0 mg/m^(3)). There is also a low-permeability interlayer between Jia-1 and Jia-2. The multi-component fluid characterizations for Jia-1 and Jia-2 were implemented separately using the Peng-Robinson equation of state in order to perform the compositional simulation. The H_(2)S concentration gradually increased in a single cycle and peaked at the end of the production season. The peak H_(2)S concentration in each cycle showed a decreasing trend when the recovery factor (RF) of the gas field was lower than 70%. When the RF was above 70%, the peak H_(2)S concentration increased first and then decreased. A higher reservoir RF, a higher maximum working pressure, and a higher working gas ratio will lead to a higher H_(2)S removal efficiency. Similar to developing multi-layered petroleum fields, the operation of multilayered gas storage can also be divided into multi-layer commingled operation and independent operation for different layers. When the two layers are combined to build the storage, the sweet gas produced from Jia-1 can spontaneously mix with the sour gas produced from Jia-2 within the wellbore, which can significantly reduce the overall H_(2)S concentration in the wellstream. When the working gas volume is set constant, the allocation ratio between the two layers has little effect on the H_(2)S removal. After nine cycles, the produced gas’s H_(2)S concentration can be lowered to 20 mg/m^(3). Our study recommends combining the Jia-2 and Jia-1 layers to build the Huangcaoxia underground gas storage. This plan can quickly reduce the H_(2)S concentration of the produced gas to 20 mg/m^(3), thus meeting the gas export standards as well as the HSE (Health, Safety, and Environment) requirements in the field. This study helps the engineers understand the H_(2)S removal for sulfur-containing UGS as well as provides technical guidelines for converting other multilayered sour gas fields into underground storage sites.

Hydrogen sulfide responsive nanoplatforms: Novel gas responsive drug delivery carriers for biomedical applications

Hydrogen sulfide(H_(2)S)is a toxic,essential gas used in various biological and physical processes and has been the subject of many targeted studies on its role as a new gas transmitter.These studies have mainly focused on the production and pharmacological side effects caused by H_(2)S.Therefore,effective strategies to remove H_(2)S has become a key research topic.Furthermore,the development of novel nanoplatforms has provided new tools for the targeted removal of H_(2)S.This paper was performed to review the association between H_(2)S anddisease,relatedH_(2)S inhibitory drugs,aswell as H_(2)S responsive nanoplatforms(HRNs).This review first analyzed the role of H_(2)S in multiple tissues and conditions.Second,common drugs used to eliminate H_(2)S,as well as their potential for combination with anticancer agents,were summarized.Not only the existing studies on HRNs,but also the inhibition H_(2)S combined with different therapeutic methods were both sorted out in this review.Furthermore,this review provided in-depth analysis of the potential of HRNs about treatment or detection in detail.Finally,potential challenges of HRNs were proposed.This study demonstrates the excellent potential of HRNs for biomedical applications.

Optimization of hydrogen networks with multiple impurities and impurity removal

To explore the effect of removing different impurities to hydrogen networks, an MINLP model is proposed with all matching possibilities and the trade-off between operation cost and capital cost is considered. Furthermore,the impurity remover, hydrogen distribution, compressor and pipe setting are included in the model. Based on this model, the impurity and source(s) that are in higher priority for impurity removal, the optimal targeted concentration, and the hydrogen network with the minimum annual cost can be identified. The efficiency of the proposed model is verified by a case study.

Application and Regeneration of a Non-Aqueous System of Cu/HCl and DMF for the Oxidation of Hydrogen Sulfide in Natural Gas

A copper-based non-aqueous-phase desulfurization agent is prepared by adding CuCl_(2) to the solvent N,Ndimethylformamide(DMF).Static desulfurization experiments show that the agent has high efficiency.However,the desulfurization reaction leads to the formation of a copper sulfide precipitate.It is found that the addition of chloride ions in the form of hydrochloric acid or potassium chloride prevents the formation of copper sulfide,and elemental sulfur is precipitated instead.The efficient absorption of H2S by the Cu/HCl–DMF agent relies on the rapid coordination of Cu^(2+)with DMF,Cl^(−),and H2S molecules to form a[Cu(DMF)_(n−p)(HS−)_(p)(Cl−)_(m)]_((2−p−m))+complex.The desulfurization agent has a sulfur capacity of up to 9.81 g/L when used in static bubble desulfurization at atmospheric pressure.The system has low viscosity and good chemical and thermal stability.It can be rapidly regenerated through continuous oxidation.After five repetitions of the regeneration procedure,the sulfur capacity reaches more than 91%of the initial capacity,indicating the potential of the system for commercial applications.

THEORETICAL ANALYSIS FOR THE MOTION AND TEMPERATURE OF MELT DROPLETS IN SPRAY DEGASSING PROCESS

The motion of melt droplets in spray degassing process was analyzed theoretically. The height of the treatment tank in spray degassing process couM be determined by the results of theoretical calculation of motion of melt droplets. To know whether the melt droplets wouM solidify during spraying process, the balance temperature of melt droplets was also theoretically analyzed. Then proof experiments for theoretical results about temperature of melt droplets were carried. In comparison, the experimental results were nearly similar to the calculation results,