In this article,a steady-state mathematical model was developed and experimentally evaluated to inves- tigate the effect of influent flow distribution and volume ratios of anoxic and aerobic zones in each stage on the...In this article,a steady-state mathematical model was developed and experimentally evaluated to inves- tigate the effect of influent flow distribution and volume ratios of anoxic and aerobic zones in each stage on the to- tal nitrogen concentration of the effluent in the step-feed biological nitrogen removal process.Unlike the previous modeling methods,this model can be used to calculate the removal rates of ammonia and nitrate in each stage and thereby predict the concentrations of ammonia,nitrate,and total nitrogen in the effluent.To verify the simulation results,pilot-scale experimental studies were carried out in a four-stage step feed process.Good correlations were achieved between the measured data and the simulation results,which proved the validity of the developed model. The sensitivity of the model predictions was analyzed.After verification of the validity,the step feed process was optimally operated for five months using the model and the criteria developed for the design and operation.During the pilot-scale experimental period,the effluent total nitrogen concentrations were all below 5mg·L -1 ,with more than 90%removal efficiency.展开更多
This research evaluated the use of sewage sludge and refuse incineration bottom ash to replace calcium sulfoaluminate cement （CSA） in making controlled low-strength material （CLSM）. Various properties of CLSM mixt...This research evaluated the use of sewage sludge and refuse incineration bottom ash to replace calcium sulfoaluminate cement （CSA） in making controlled low-strength material （CLSM）. Various properties of CLSM mixtures were characterized in terms of unconfined compressive strength, microstructure and leachability. It was found that the strength of tested CLSM mixtures ranged from 3.6 to 9.0 MPa, over the upper excavatable limit of 2.1 MPa. The micro-structural analysis revealed that sewage sludge and bottom ash were crystallochemically in- corporated within CLSM system_s by forming the needle-like ettringite （C3A＇3CS＇_H32） with exiguous tu.bers via the typical Pozzolanic Reaction, leading to a dense and low-porosity microst;＇ucture. Furthermore,-the toxicity characteristic leaching procedure evidenced that the cumulative leachable metals in the leachate were much below the regulatory thresholds. The potential for us!ng sewage sludge and bottom ash!n CLSM makin.g was thus confirmed.展开更多
基金Supported by the National Natural Science Foundation Key International Cooperation Project of China （No.50521140075）, the 863 Attached Financial Supporting Item of Beijing Municipal Science and Technology Commission （No.Z0005186040421） and the Doctor Subject Soecial Financial Supporfing Item of High College （No.20060005002）.
文摘In this article,a steady-state mathematical model was developed and experimentally evaluated to inves- tigate the effect of influent flow distribution and volume ratios of anoxic and aerobic zones in each stage on the to- tal nitrogen concentration of the effluent in the step-feed biological nitrogen removal process.Unlike the previous modeling methods,this model can be used to calculate the removal rates of ammonia and nitrate in each stage and thereby predict the concentrations of ammonia,nitrate,and total nitrogen in the effluent.To verify the simulation results,pilot-scale experimental studies were carried out in a four-stage step feed process.Good correlations were achieved between the measured data and the simulation results,which proved the validity of the developed model. The sensitivity of the model predictions was analyzed.After verification of the validity,the step feed process was optimally operated for five months using the model and the criteria developed for the design and operation.During the pilot-scale experimental period,the effluent total nitrogen concentrations were all below 5mg·L -1 ,with more than 90%removal efficiency.
基金Supported by the Science and Technology Commission of Shanghai Municipality (08 DZ 1202802,09 DZ 1204105,09 DZ2251700)the National Natural Science Foundation of China (51008322)
文摘This research evaluated the use of sewage sludge and refuse incineration bottom ash to replace calcium sulfoaluminate cement （CSA） in making controlled low-strength material （CLSM）. Various properties of CLSM mixtures were characterized in terms of unconfined compressive strength, microstructure and leachability. It was found that the strength of tested CLSM mixtures ranged from 3.6 to 9.0 MPa, over the upper excavatable limit of 2.1 MPa. The micro-structural analysis revealed that sewage sludge and bottom ash were crystallochemically in- corporated within CLSM system_s by forming the needle-like ettringite （C3A＇3CS＇_H32） with exiguous tu.bers via the typical Pozzolanic Reaction, leading to a dense and low-porosity microst;＇ucture. Furthermore,-the toxicity characteristic leaching procedure evidenced that the cumulative leachable metals in the leachate were much below the regulatory thresholds. The potential for us!ng sewage sludge and bottom ash!n CLSM makin.g was thus confirmed.
