A nozzle inclination angle and swirl combustor inside the low-tar biomass(LTB)gasifier reactor were tested and optimized to evaluate these effects on tar reduction to design tar-free producer gas.The tar reduction pro...A nozzle inclination angle and swirl combustor inside the low-tar biomass(LTB)gasifier reactor were tested and optimized to evaluate these effects on tar reduction to design tar-free producer gas.The tar reduction process is mainly based on the concept of a swirling flow created by the nozzle inclination angle,with the inclination angle of 55◦to the radial line,allowing good mixing between pyrolysis gases and gasifying agents.A separate swirl combustor has created large internal annular and reverses flow zones with the help of swirl flow,resulting in homogenized temperature inside the combustor and providing longer residence time;both have a positive effect on the combustion of mixed gasifying air-pyrolysis gases by the thermal cracking in the partial oxidation zone.Recircling ratio(RR)and combustion degree of volatiles are the two optimization parameters for evaluating the performance of NIA and swirl combustor.The result observed that outstanding tar reduction occurred in this novel system.About 86.5 and 12.8%of tar compounds are broken down in the partial oxidation zone and pyrolysis zone using the novel swirl combustor and NIA,respectively;gas outlet has observed producer gas having tar concentration of less than 1%.The optimization results reveal that a lower recycling ratio(recycle gas/gasifying air)and a higher combustion degree of volatiles perform better in biomass gasification.Finally,this system generated producer gas with the tar concentration at an extremely low level of 7.4 mg/Nm^(3)for a biomass moisture content of 9%and appeared the lower heating value of 4.6–5.1 MJ/Nm^(3).This lower tar concentration might be directly coupled with an internal combustion engine or a gas turbine for power generation.展开更多
The axial and tangential velocities of gas and particle phases and particle concentration for turbulent swirling and recirculating gas-particle (simulating gas-droplet) flows in a cold model of a dual-inlet sudden-exp...The axial and tangential velocities of gas and particle phases and particle concentration for turbulent swirling and recirculating gas-particle (simulating gas-droplet) flows in a cold model of a dual-inlet sudden-expansion combustor with partially tangential central tubes, proposed by the present authors, were measured by using a 2-D LDV system and a laser optic fiber system combined with a sampling probe. The results show that there are both gas and particle strongly reverse flows and swirling flows in the head part of the combustor. The velocity slip between gas and particle phases is remarkable. The particle concentration is higher near the wall and lower near the axis. There are two peaks in the concentration profiles near the inlet tubes. The above-obtained flow characteristics are favorable to ignition, flame stabilization and combustion. The results can also be used to validate the numerical modeling.展开更多
基金Biomass Gasification Group(BGG),DTU Chemical Engineering,Technical University of Denmark to conduct this research are acknowledged thankfully.The author thanks Zsuzsa Sarossy and Kristian Estrup from DTU Chemical Engineering for performing tar samples analysis and experimental setup during all the tests,respectively.
文摘A nozzle inclination angle and swirl combustor inside the low-tar biomass(LTB)gasifier reactor were tested and optimized to evaluate these effects on tar reduction to design tar-free producer gas.The tar reduction process is mainly based on the concept of a swirling flow created by the nozzle inclination angle,with the inclination angle of 55◦to the radial line,allowing good mixing between pyrolysis gases and gasifying agents.A separate swirl combustor has created large internal annular and reverses flow zones with the help of swirl flow,resulting in homogenized temperature inside the combustor and providing longer residence time;both have a positive effect on the combustion of mixed gasifying air-pyrolysis gases by the thermal cracking in the partial oxidation zone.Recircling ratio(RR)and combustion degree of volatiles are the two optimization parameters for evaluating the performance of NIA and swirl combustor.The result observed that outstanding tar reduction occurred in this novel system.About 86.5 and 12.8%of tar compounds are broken down in the partial oxidation zone and pyrolysis zone using the novel swirl combustor and NIA,respectively;gas outlet has observed producer gas having tar concentration of less than 1%.The optimization results reveal that a lower recycling ratio(recycle gas/gasifying air)and a higher combustion degree of volatiles perform better in biomass gasification.Finally,this system generated producer gas with the tar concentration at an extremely low level of 7.4 mg/Nm^(3)for a biomass moisture content of 9%and appeared the lower heating value of 4.6–5.1 MJ/Nm^(3).This lower tar concentration might be directly coupled with an internal combustion engine or a gas turbine for power generation.
基金F oundation of Astronautical Sci. & Tech.China(Project 90 -16 )
文摘The axial and tangential velocities of gas and particle phases and particle concentration for turbulent swirling and recirculating gas-particle (simulating gas-droplet) flows in a cold model of a dual-inlet sudden-expansion combustor with partially tangential central tubes, proposed by the present authors, were measured by using a 2-D LDV system and a laser optic fiber system combined with a sampling probe. The results show that there are both gas and particle strongly reverse flows and swirling flows in the head part of the combustor. The velocity slip between gas and particle phases is remarkable. The particle concentration is higher near the wall and lower near the axis. There are two peaks in the concentration profiles near the inlet tubes. The above-obtained flow characteristics are favorable to ignition, flame stabilization and combustion. The results can also be used to validate the numerical modeling.
基金This work was supported by the National Natural Science Foundation of China(No.52206222,No.22227901)State Key Laboratory of Laser Interaction with Matter Foundation(SKLLIM2009).