期刊文献+
共找到6篇文章
< 1 >
每页显示 20 50 100
脉冲中子源法测量铅基零功率反应堆Venus-Ⅱ次临界度 被引量:4
1
作者 万波 罗皇达 +11 位作者 马飞 陈亮 葛红林 张艳斌 张宏斌 骆鹏 鞠永芹 周琦 尹生贵 刘洋 史永谦 张雪荧 《原子能科学技术》 EI CAS CSCD 北大核心 2018年第10期1762-1768,共7页
本文利用脉冲中子源法测量了铅基零功率反应堆Venus-Ⅱ在4种燃料棒装载情况下的次临界度,简要介绍了脉冲中子源法测量次临界度的原理、测量系统及实验结果等,通过面积比法分析了各探测器的计数率时间谱,确定了系统次临界度。测量结果表... 本文利用脉冲中子源法测量了铅基零功率反应堆Venus-Ⅱ在4种燃料棒装载情况下的次临界度,简要介绍了脉冲中子源法测量次临界度的原理、测量系统及实验结果等,通过面积比法分析了各探测器的计数率时间谱,确定了系统次临界度。测量结果表明,当系统有效增殖因数在0.94附近时,不同位置处的探测器测量结果之间呈明显差异。基于MCNP理论模拟计算,分别用空间修正因子和普适的微扰法对面积比测量结果进行必要修正,消除了空间效应对实验结果的影响。在系统有效增殖因数约0.94时,经修正的面积比法能精确给出系统的次临界度。本实验研究为ADS嬗变系统的次临界度精确测量提供了一种有效方法。 展开更多
关键词 脉冲中子源法 次临界度 面积比法 空间效应
下载PDF
80.5 MeV/u碳离子诱发铜靶的放射性剩余产物测量
2
作者 周斌 于全芝 +4 位作者 张宏斌 张雪荧 鞠永芹 陈亮 阮锡超 《物理学报》 SCIE EI CAS CSCD 北大核心 2021年第7期79-83,共5页
高能重带电粒子能直接穿透靶原子核外电子层,与原子核发生直接碰撞,发生散裂反应,产生一系列具有放射性的剩余产物核.重带电粒子诱发靶材放射性剩余核与辐射防护和人员安全有着密切联系,当前,大部分剩余核产额主要依靠蒙特卡罗粒子输运... 高能重带电粒子能直接穿透靶原子核外电子层,与原子核发生直接碰撞,发生散裂反应,产生一系列具有放射性的剩余产物核.重带电粒子诱发靶材放射性剩余核与辐射防护和人员安全有着密切联系,当前,大部分剩余核产额主要依靠蒙特卡罗粒子输运程序进行模拟计算,其准确程度亟需通过实验测量进行准确评估.本文利用能量为80.5 MeV/u的(12)^C^(6+)粒子对薄铜靶开展了辐照实验与伽玛射线测量,结合伽玛谱学分析方法,得出了辐照产生的18种放射性剩余产物的初始活度和产生截面值,并与PHITS模拟结果进行对比.结果表明,PHITS模拟程序对放射性剩余核种类的估计具有较高可靠性,在其绝对产额方面,与实验测量仍具有较大偏差. 展开更多
关键词 散裂反应 剩余产物 蒙特卡罗模拟 伽玛谱学
下载PDF
Residual Nuclides Induced in Cu Target by a 250 MeV Proton Beam
3
作者 张宏斌 张雪荧 +11 位作者 马飞 鞠永芹 葛红林 陈亮 张艳斌 魏计房 李严严 骆鹏 王建国 万波 许晓伟 周斌 《Chinese Physics Letters》 SCIE CAS CSCD 2015年第4期29-32,共4页
Residual nuclide production is studied experimentally by bombarding a Cu target with a 250 MeV proton beam. The data are measured by the off-line γ-spectroscopy method. Six nuclides are identified and their cross sec... Residual nuclide production is studied experimentally by bombarding a Cu target with a 250 MeV proton beam. The data are measured by the off-line γ-spectroscopy method. Six nuclides are identified and their cross sections are determined. The corresponding calculated results by the MCNPX and GEANT4 codes are compared with the experimental data to check the validity of the codes. A comparison shows that the MCNPX simulation has a better agreement with the experiment. The energy dependence of residual nuclide production is studied with the aid of MCNPX simulation, and it is found that the mass yields for the nuclides in the light mass region increase significantly with the proton energy. 展开更多
关键词 MCNPX Residual Nuclides Induced in Cu Target by a 250 MeV Proton Beam CU
下载PDF
Spallation Yield of Neutrons Produced in Thick Lead Target by 400 MeV/u Carbon Ions
4
作者 马飞 张宏斌 +8 位作者 张雪荧 张彦斌 葛红林 鞠永芹 陈亮 李严严 万波 周斌 徐俊奎 《Chinese Physics Letters》 SCIE CAS CSCD 2017年第12期21-23,共3页
Measurement of the neutron yield is performed at a primary energy of 400 MeV/u carbons for the Pb target.Water-bath activation-foil method is used in a moderation measurement with Au foils to detect the moderated neut... Measurement of the neutron yield is performed at a primary energy of 400 MeV/u carbons for the Pb target.Water-bath activation-foil method is used in a moderation measurement with Au foils to detect the moderated neutrons. The neutron yield is determined to be 18.4±2.1 per carbon by integrating the neutron flux over the entire water volume. The corresponding simulation values are performed by Geant4 code with three models to compare with the experimental results. The comparison shows that the calculated result with the INCL model is in good agreement with the experimental data. 展开更多
关键词 Spallation Yield of Neutrons Produced in Thick Lead Target by 400 MeV/u Carbon Ions
下载PDF
Digital pulse shape discrimination methods for n-γ separation in an EJ-301 liquid scintillation detector 被引量:1
5
作者 万波 张雪荧 +7 位作者 陈亮 葛红林 马飞 张宏斌 鞠永芹 张艳斌 李严严 许晓伟 《Chinese Physics C》 SCIE CAS CSCD 2015年第11期76-80,共5页
A digital pulse shape discrimination system based on a programmable module NI-5772 has been established and tested with an EJ-301 liquid scintillation detector. The module was operated by running programs developed in... A digital pulse shape discrimination system based on a programmable module NI-5772 has been established and tested with an EJ-301 liquid scintillation detector. The module was operated by running programs developed in Lab VIEW, with a sampling frequency up to 1.6 GS/s. Standard gamma sources ^22 Na,^137Cs and ^60 Co were used to calibrate the EJ-301 liquid scintillation detector, and the gamma response function was obtained. Digital algorithms for the charge comparison method and zero-crossing method have been developed. The experimental results show that both digital signal processing(DSP) algorithms can discriminate neutrons from γ-rays. Moreover,the zero-crossing method shows better n-γ discrimination at 80 ke Vee and lower, whereas the charge comparison method gives better results at higher thresholds. In addition, the figure-of-merit(FOM) for detectors of two different dimensions were extracted at 9 energy thresholds, and it was found that the smaller detector presented better n-γseparation for fission neutrons. 展开更多
关键词 EJ-301 liquid scintillation detector digital signal processing charge comparison method zero-crossing method
原文传递
Study of neutron activation yields in spallation reaction of 400 MeV/u carbon on a thick lead target
6
作者 马飞 葛红林 +15 位作者 张雪荧 张宏斌 鞠永芹 陈亮 杨磊 付芬 张雅玲 李建洋 梁天骄 周斌 王松林 李金阳 徐俊奎 雷祥国 秦芝 顾龙 《Chinese Physics C》 SCIE CAS CSCD 2014年第7期18-21,共4页
The spallation-neutron yield was studied experimentally by bombarding a thick lead target with 400 MeV/u carbon beam. The data were obtained with the activation analysis method using foils of Au, Mn, Al, Fe and In. Th... The spallation-neutron yield was studied experimentally by bombarding a thick lead target with 400 MeV/u carbon beam. The data were obtained with the activation analysis method using foils of Au, Mn, Al, Fe and In. The yields of produced isotopes were deduced by analyzing the measured γ spectra of the irradiated foils. According to the isotopes yields, the spatial and energy distributions of the neutron field were discussed. The experimental results were compared with Monte Carlo simulations performed by the GEANT4+FLUKA code. 展开更多
关键词 spallation reaction activation analysis method neutron production
原文传递
上一页 1 下一页 到第
使用帮助 返回顶部