Assessment of bearing capacity of interfering strip footings located near sloping surface considering artificial neural network technique

The bearing capacity of interfering footings located near the slope face suffers from reduced bearing capacity due to the formation of the curtailed passive zone. Depending upon the position of the footing, their spacing and steepness of the slope different extents of bearing capacity reduction can be exhibited. A series of finite element investigation has been done with the aid of Plaxis 3 D v AE.01 to elucidate the influence of various geotechnical and geometrical parameters on the ultimate bearing capacity of interfering surface strip footings located at the crest of the natural soil slope. Based on the large database obtained from the numerical simulation, a6-8-1 Artificial Neural Network architecture has been considered for the assessment of the ultimate bearing capacity of interfering strip footings placed on the crest of natural soil slope. Sensitivity analyses have been conducted to establish the relative significance of the contributory parameters, which exhibited that for the stated problem, apart from shear strength parameters, the setback ratio and spacing of footing are the prime contributory parameters.

Dynamic properties and liquefaction behaviour of cohesive soil in northeast India under staged cyclic loading

Estimation of strain-dependent dynamic soil properties, e.g. the shear modulus and damping ratio, along with the liquefaction potential parameters, is extremely important for the assessment and analysis of almost all geotechnical problems involving dynamic loading. This paper presents the dynamic properties and liquefaction behaviour of cohesive soil subjected to staged cyclic loading, which may be caused by main shocks of earthquakes preceded or followed by minor foreshocks or aftershocks, respectively. Cyclic triaxial tests were conducted on the specimens prepared at different dry densities （1.5 g/cm3 and 1.75 g/cm3） and different water contents ranging from 8% to 25%. The results indicated that the shear modulus reduction （G/Gmax） and damping ratio of the specimen remain unaffected due to the changes in the initial dry density and water content. Damping ratio is significantly affected by confining pressure, whereas G/Gmax is affected marginally. It was seen that the liquefaction criterion of cohesive soils based on single-amplitude shear strain （3.75% or the strain at which excess pore water pressure ratio becomes equal to 1, whichever is lower） depends on the initial state of soils and applied stresses. The dynamic model of the regional soil, obtained as an outcome of the cyclic triaxial tests, can be successfully used for ground response analysis of the region.

A time-domain nonlinear effective-stress non-Masing approach of ground response analysis of Guwahati city, India

The response of subsoil strata subjected to seismic excitations plays an important role in governing the response of the overlying superstructures at any site. Ground response analysis(GRA) helps to assess the influence of soil characteristics on the propagating seismic stress waves from the bedrock level to the ground surface during an earthquake. For the northeastern region of India, located in the highest seismic zone in the country, conducting an extensive GRA study is of prime importance. Conventionally, most of the GRA studies are carried out using the equivalent linear method, which, being a simplistic approach, cannot capture the nonlinear behavior of soil during seismic shaking. This paper presents the outcomes of a one-dimensional effective stress based nonlinear GRA conducted for Guwahati city(located in northeast India) incorporating the non-Masing load/unload/reload characteristics. The various ground response parameters evaluated from this study help in assessing the ground shaking, soil amplification, and site responses expected in this region. 2D contour maps, which are representative of the distribution of some of these parameters throughout Guwahati city, are also developed. The results presented herein can serve as guidelines for the design of foundations and superstructures in this region.

Optimum lateral extent of soil domain for dynamic SSI analysis of RC framed buildings on pile foundations

This article describes a novel approach for deciding optimal horizontal extent of soil domain to be used for finite element based numerical dynamic soil structure interaction(SSI)studies.SSI model for a 12 storied building frame,supported on pile foundation-soil system,is developed in the finite element based software framework,OpenSEES.Three different structure-foundation configurations are analyzed under different ground motion characteristics.Lateral extent of soil domain,along with the soil properties,were varied exhaustively for a particular structural configuration.Based on the reduction in the variation of acceleration response at different locations in the SSI system(quantified by normalized root mean square error,NRMSE),the optimum lateral extent of the soil domain is prescribed for various structural widths,soil types and peak ground acceleration levels of ground motion.Compared to the past studies,error estimation analysis shows that the relationships prescribed in the present study are credible and more inclusive of the various factors that influence SSI.These relationships can be readily applied for deciding upon the lateral extent of the soil domain for conducting precise SSI analysis with reduced computational time.