Adsorption properties of dibenzothiophene (DBT) on a CNT (carbon nanotube) support as well as on CoMoS/CNT and CoMoO/CNT catalysts have been studied. Consecutive desorption of adsorbates was measured by TGA. The commo...Adsorption properties of dibenzothiophene (DBT) on a CNT (carbon nanotube) support as well as on CoMoS/CNT and CoMoO/CNT catalysts have been studied. Consecutive desorption of adsorbates was measured by TGA. The commonly used carriers AC (activated carbon), γ-Al_2O_3, and their supported catalysts (CoMoO/AC, CoMoS/AC, CoMoO/γ-Al_2O_3, CoMoS/γ-Al_2O_3)were also subjected to analysis for comparison. The acidic properties of the samples were characterized using the NH_3-TPD technique. Correlation between the adsorption of DBT and the acidic properties of the catalysts has been established. It was found that the Co-Mo catalysts in the sulfide state adsorbed much more DBT molecules than the corresponding Co-Mo catalysts in the oxide state. The CoMoS/CNT catalyst exhibited very high HDS activity and selectivity, as compared with the CoMoS/γ-Al)_2O_3 catalysts. Based on the BET data and the high hydrogenolysis/hydrogenation selectivity of the CoMoS/CNT, it was deduced that more than 90% of the DBT molecules adsorbed on the CoMoS/CNT with an end-on mode, and the surface of the CoMoS/CNT catalyst was almost fully covered with DBT molecules. Although the AC support had very high surface area and high loading ability, the AC supported CoMoS catalyst showed lower HDS activity, as compared with the CoMoS/γ-Al_2O_3 catalyst.展开更多
In this paper, adsorption properties of dibenzothiophene (DBT) on carbon nanotube, carbon nanotube supported oxide state and sulfide state CoMo catalysts are studied by using thermal gravimetric analysis (TGA) techniq...In this paper, adsorption properties of dibenzothiophene (DBT) on carbon nanotube, carbon nanotube supported oxide state and sulfide state CoMo catalysts are studied by using thermal gravimetric analysis (TGA) technique and FT-IR spectroscopy. Activated carbon support, γ-AlgO3 support and supported CoMo catalysts are also subjected to studies for comparison. It was found that sulfide state CoMoS/MWCNT, CoMoS/AC and CoMoS/γ-Al2O3 catalysts adsorbed much more DBT molecules than their corresponding oxide state catalysts, as well as their corresponding supports. The chemically adsorbed DBT aromatic molecules did not undergo decomposition on the surface of supports, supported oxide state CoMo catalysts and sulfide state CoMo catalysts when out-gassing at 373 K. FT-IR results indicated that DBT molecules mainly stand upright on the active sites (acid sites and/or transition active phases) of CoMoS/MWCNT catalyst. However, DBT aromatic molecules mainly lie flat on MWCNT and CoMoO/MWCNT.展开更多
文摘Adsorption properties of dibenzothiophene (DBT) on a CNT (carbon nanotube) support as well as on CoMoS/CNT and CoMoO/CNT catalysts have been studied. Consecutive desorption of adsorbates was measured by TGA. The commonly used carriers AC (activated carbon), γ-Al_2O_3, and their supported catalysts (CoMoO/AC, CoMoS/AC, CoMoO/γ-Al_2O_3, CoMoS/γ-Al_2O_3)were also subjected to analysis for comparison. The acidic properties of the samples were characterized using the NH_3-TPD technique. Correlation between the adsorption of DBT and the acidic properties of the catalysts has been established. It was found that the Co-Mo catalysts in the sulfide state adsorbed much more DBT molecules than the corresponding Co-Mo catalysts in the oxide state. The CoMoS/CNT catalyst exhibited very high HDS activity and selectivity, as compared with the CoMoS/γ-Al)_2O_3 catalysts. Based on the BET data and the high hydrogenolysis/hydrogenation selectivity of the CoMoS/CNT, it was deduced that more than 90% of the DBT molecules adsorbed on the CoMoS/CNT with an end-on mode, and the surface of the CoMoS/CNT catalyst was almost fully covered with DBT molecules. Although the AC support had very high surface area and high loading ability, the AC supported CoMoS catalyst showed lower HDS activity, as compared with the CoMoS/γ-Al_2O_3 catalyst.
基金Foundation of Innovation for Middle-aged and Youth, CNPC (Foundation No.W990411)
文摘In this paper, adsorption properties of dibenzothiophene (DBT) on carbon nanotube, carbon nanotube supported oxide state and sulfide state CoMo catalysts are studied by using thermal gravimetric analysis (TGA) technique and FT-IR spectroscopy. Activated carbon support, γ-AlgO3 support and supported CoMo catalysts are also subjected to studies for comparison. It was found that sulfide state CoMoS/MWCNT, CoMoS/AC and CoMoS/γ-Al2O3 catalysts adsorbed much more DBT molecules than their corresponding oxide state catalysts, as well as their corresponding supports. The chemically adsorbed DBT aromatic molecules did not undergo decomposition on the surface of supports, supported oxide state CoMo catalysts and sulfide state CoMo catalysts when out-gassing at 373 K. FT-IR results indicated that DBT molecules mainly stand upright on the active sites (acid sites and/or transition active phases) of CoMoS/MWCNT catalyst. However, DBT aromatic molecules mainly lie flat on MWCNT and CoMoO/MWCNT.
