The upper reach of the Yellow River from Daliushu to Shapotou consists of five bends and has complex topography. A two-dimensional Re-Normalisation Group （RNG） k-ε model was developed to simulate the flow in the re...The upper reach of the Yellow River from Daliushu to Shapotou consists of five bends and has complex topography. A two-dimensional Re-Normalisation Group （RNG） k-ε model was developed to simulate the flow in the reach. In order to take the circulation currents in the bends into account, the momentum equations were improved by adding an additional source term. Comparison of the numerical simulation with field measurements indicates that the improved two-dimensional depth-averaged RNG k-e model can improve the accuracy of the numerical simulation. A rapid adaptive algorithm was constructed, which can automatically adjust Manning＇s roughness coefficient in different parts of the study river reach. As a result, not only can the trial computation time be significantly shortened, but the accuracy of the numerical simulation can also be greatly improved. Comparison of the simulated and measured water surface slopes for four typical cases shows that the longitudinal and transverse slopes of the water surface increase with the average velocity upstream. In addition, comparison was made between the positions of the talweg and the main streamline, which coincide for most of the study river reach. However, deviations between the positions of the talweg and the main streamline were found at the junction of two bends, at the position where the river width suddenly decreases or increases.展开更多
The balance between metal and acid sites directly affects the preparation of high-performance cracking catalysts with high heat sink and low coking.Nevertheless,how to control acid-metal sites balance and its relation...The balance between metal and acid sites directly affects the preparation of high-performance cracking catalysts with high heat sink and low coking.Nevertheless,how to control acid-metal sites balance and its relationship with cracking performance are reported scarcely.In this work,a series of Pt/Al_(2)O_(3)-SiO_(2) dual sites catalysts with different metal to acid active sites ratio(C_(M)/C_(SA))were constructed by ethanolassisted impregnation method and the impact on n-decane cracking under supercritical conditions was systematically and deeply investigated.The results showed that the conversion and carbon deposition increased gradually with varied C_(M)/C_(SA)and reached the balance at C_(M)/C_(SA)of 0.13.The proper ratio C_(M)/C_(SA)(0.13)can balance the deep dehydrogenation coking over metal active sites and high heat sink of cracking over acid active sites,the chemical heat sink reaches amazing 1.75 MJ/kg and carbon deposition is only22.03 mg/cm^(2) at 750℃.Meanwhile,the few metal sites at low C_(M)/C_(SA)and the few strong acid sites at high C_(M)/C_(SA)are the main factors limiting the cracking activity.Low C_(M)/C_(SA)limit the activation of C-H bond and deep dehydrogenation of coking precursor,resulting in relative low cracking activity and carbon deposition,while high C_(M)/C_(SA)limit the activation of C-C bond and increase the deep dehydrogenation.In this contribution,design and construction of metal-acid dual sites can not only provide the technical solution for the preparation of high heat sink and low coking cracking catalyst,but also deepen the understanding of the cracking path of hydrocarbon fuel.展开更多
The aquatic vegetation can significantly affect the flow structure,the sediment transport,the bed scour and the water quality in rivers,lakes,reservoirs and open channels.In this study,the lattice Boltzmann method(LBM...The aquatic vegetation can significantly affect the flow structure,the sediment transport,the bed scour and the water quality in rivers,lakes,reservoirs and open channels.In this study,the lattice Boltzmann method(LBM)is applied in the two-dimensional numerical simulation of the flow structure in a flume with rigid vegetation.A multi-relaxation time model is applied to improve the stability of the numerical scheme for flows with a high Reynolds number.The vegetation induced drag force is added in the lattice Boltzmann equation model in order to improve the simulation accuracy and an algorithm of the multi-relaxation time is developed.Numerical simulations are performed for a wide range of flow and vegetation conditions and are validated by comparing with the laboratory experiments.Analysis of the simulated and experimentally measured flow Helds shows that the numerical simulation can satisfactorily reproduce the laboratory experiments,indicating that the proposed lattice Boltzmann model enjoys a high accuracy for simulating the flow-vegetation interaction in open channels.展开更多
In order to study the flow characteristics in water bodies with rigid aquatic vegetation,series of laboratory experiments are carried out in an open channel,in which glass rods are used as plants with diameters of 6mm...In order to study the flow characteristics in water bodies with rigid aquatic vegetation,series of laboratory experiments are carried out in an open channel,in which glass rods are used as plants with diameters of 6mm,8mm and 10mm,respectively.For each diameter of glass rods,four typical cases are considered with various densities and arrangements of glass rods.The flow velocities in the four cases are measured by the 3-D laser Doppler velocimeter(LDV).The water surface slope,the flow velocity,the water head loss,the vegetation drag force and the hydraulic slope are calculated,analyzed and discussed.The horizontal,vertical and total vegetation densities in the vegetation area are defined and the relationship between these physical parameters and the water surface slope are studied.The head loss and the hydraulic slope in the vegetation area are also calculated,compared and analyzed.It is indicated that the water surface slope and velocity,the head loss and the hydraulic slope in the vegetation area have a close relationship with the arrangement,the density,and the plant diameter of the vegetation.展开更多
基金supported by the National Natural Science Foundation of China(Grants No.11361002 and 91230111)the Natural Science Foundation of Ningxia,China(Grant No.NZ13086)+1 种基金the Project of Beifang University of Nationalities,China(Grant No.2012XZK05)the Foreign Expert Project of Beifang University of Nationalities,China,and the Visiting Scholar Foundation of State Key Laboratory of Water Resources and Hydropower Engineering Science,Wuhan University,China(Grant No.2013A011)
文摘The upper reach of the Yellow River from Daliushu to Shapotou consists of five bends and has complex topography. A two-dimensional Re-Normalisation Group （RNG） k-ε model was developed to simulate the flow in the reach. In order to take the circulation currents in the bends into account, the momentum equations were improved by adding an additional source term. Comparison of the numerical simulation with field measurements indicates that the improved two-dimensional depth-averaged RNG k-e model can improve the accuracy of the numerical simulation. A rapid adaptive algorithm was constructed, which can automatically adjust Manning＇s roughness coefficient in different parts of the study river reach. As a result, not only can the trial computation time be significantly shortened, but the accuracy of the numerical simulation can also be greatly improved. Comparison of the simulated and measured water surface slopes for four typical cases shows that the longitudinal and transverse slopes of the water surface increase with the average velocity upstream. In addition, comparison was made between the positions of the talweg and the main streamline, which coincide for most of the study river reach. However, deviations between the positions of the talweg and the main streamline were found at the junction of two bends, at the position where the river width suddenly decreases or increases.
基金subsidized by Sichuan Province Science and Technology Program (2023NSFSC0093)Enterprises Entrust Technology Development Program (FJF22KX0055,202302914)。
文摘The balance between metal and acid sites directly affects the preparation of high-performance cracking catalysts with high heat sink and low coking.Nevertheless,how to control acid-metal sites balance and its relationship with cracking performance are reported scarcely.In this work,a series of Pt/Al_(2)O_(3)-SiO_(2) dual sites catalysts with different metal to acid active sites ratio(C_(M)/C_(SA))were constructed by ethanolassisted impregnation method and the impact on n-decane cracking under supercritical conditions was systematically and deeply investigated.The results showed that the conversion and carbon deposition increased gradually with varied C_(M)/C_(SA)and reached the balance at C_(M)/C_(SA)of 0.13.The proper ratio C_(M)/C_(SA)(0.13)can balance the deep dehydrogenation coking over metal active sites and high heat sink of cracking over acid active sites,the chemical heat sink reaches amazing 1.75 MJ/kg and carbon deposition is only22.03 mg/cm^(2) at 750℃.Meanwhile,the few metal sites at low C_(M)/C_(SA)and the few strong acid sites at high C_(M)/C_(SA)are the main factors limiting the cracking activity.Low C_(M)/C_(SA)limit the activation of C-H bond and deep dehydrogenation of coking precursor,resulting in relative low cracking activity and carbon deposition,while high C_(M)/C_(SA)limit the activation of C-C bond and increase the deep dehydrogenation.In this contribution,design and construction of metal-acid dual sites can not only provide the technical solution for the preparation of high heat sink and low coking cracking catalyst,but also deepen the understanding of the cracking path of hydrocarbon fuel.
基金Supported by the National Natural Science Foundation of China(Grant No.11861003,11761005).
文摘The aquatic vegetation can significantly affect the flow structure,the sediment transport,the bed scour and the water quality in rivers,lakes,reservoirs and open channels.In this study,the lattice Boltzmann method(LBM)is applied in the two-dimensional numerical simulation of the flow structure in a flume with rigid vegetation.A multi-relaxation time model is applied to improve the stability of the numerical scheme for flows with a high Reynolds number.The vegetation induced drag force is added in the lattice Boltzmann equation model in order to improve the simulation accuracy and an algorithm of the multi-relaxation time is developed.Numerical simulations are performed for a wide range of flow and vegetation conditions and are validated by comparing with the laboratory experiments.Analysis of the simulated and experimentally measured flow Helds shows that the numerical simulation can satisfactorily reproduce the laboratory experiments,indicating that the proposed lattice Boltzmann model enjoys a high accuracy for simulating the flow-vegetation interaction in open channels.
基金Project supported by the National Natural Science Foundation of China(Grant Nos.11861003,11761005).
文摘In order to study the flow characteristics in water bodies with rigid aquatic vegetation,series of laboratory experiments are carried out in an open channel,in which glass rods are used as plants with diameters of 6mm,8mm and 10mm,respectively.For each diameter of glass rods,four typical cases are considered with various densities and arrangements of glass rods.The flow velocities in the four cases are measured by the 3-D laser Doppler velocimeter(LDV).The water surface slope,the flow velocity,the water head loss,the vegetation drag force and the hydraulic slope are calculated,analyzed and discussed.The horizontal,vertical and total vegetation densities in the vegetation area are defined and the relationship between these physical parameters and the water surface slope are studied.The head loss and the hydraulic slope in the vegetation area are also calculated,compared and analyzed.It is indicated that the water surface slope and velocity,the head loss and the hydraulic slope in the vegetation area have a close relationship with the arrangement,the density,and the plant diameter of the vegetation.
