Dissimilar welding of high nitrogen stainless steel and low alloy high strength steel under different shielding gas composition:Process,microstructure and mechanical properties

Ar-N_(2)-O_(2)ternary shielding gas is employed in dissimilar welding between high nitrogen steel and low alloy steel.The effect of O_(2)and N_(2)is investigated based on the systematical analysis of the metal transfer,nitrogen escape phenomenon,weld appearance,nondestructive detection,nitrogen content distribution,microstructure and mechanical properties.There are two nitrogen sources of the nitrogen in the weld:high nitrogen base material and shielding gas.The effect of shielding gas is mainly reflected in these two aspects.The change of the droplet transfer mode affects the fusion ratio,N2in the shielding gas can increase nitrogen content and promote the nitrogen uniform distribution.The addition of 2%O_(2)to Ar matrix can change the metal transfer from globular transfer to spray transfer,high nitrogen base material is thereby dissolved more to the molten pool,making nitrogen content increase,ferrite decrease and the mechanical properties improve.When applying N2-containing shielding gas,arc stability becomes poor and short-circuiting transfer frequency increases due to the nitrogen escape from droplets and the molten pool.Performance of the joints is improved with N_(2)increasing,but internal gas pores are easier to appear because of the poor capacity of low alloy steel to dissolve nitrogen,The generation of pores will greatly reduce the impact resistance.4-8%N2content in shielding gas is recommended in this study considering the integrated properties of the dissimilar welded joint.

Gas metal arc welding of high nitrogen stainless steel with AreN_(2)-O_(2)ternary shielding gas

High nitrogen stainless steel with nitrogen content of 0.75%was welded by gas metal arc welding with Ar-N_(2)-O_(2)ternary shielding gas.The effect of the ternary shielding gas on the retention and improvement of nitrogen content in the weld was identified.Surfacing test was conducted first to compare the ability of O_(2)and CO_(2)in prompting nitrogen dissolution.The nitrogen content of the surfacing metal with O_(2)is slightly higher than CO_(2).And then AreN_(2)-O_(2)shielding gas was applied to weld high nitrogen stainless steel.After using N_(2)-containing shielding gas,the nitrogen content of the weld was improved by 0.1 wt%.As N_(2)continued to increase,the increment of nitrogen content was not obvious,but the ferrite decreased from the top to the bottom.When the proportion of N_(2)reached 20%,a full austenitic weld was obtained and the tensile strength was improved by 8.7%.Combined with the results of surfacing test and welding test,it is concluded that the main effect of N_(2)is to inhibit the escape of nitrogen and suppress the nitrogen diffusion from bottom to the top in the molten pool.

Clinical evaluation of prone position ventilation in the treatment of acute respiratory distress syndrome induced by sepsis

BACKGROUND Acute respiratory distress syndrome(ARDS)is an acute,diffuse,inflammatory lung injury.Previous studies have shown prone position ventilation(PPV)to be associated with improvement in oxygenation.However,its role in patients with ARDS caused by sepsis remains unknown.AIM To analyze the clinical effects of PPV in patients with ARDS caused by sepsis.METHODS One hundred and two patients with ARDS were identified and divided into a control group(n=55)and a PPV treatment group(n=47).Outcomes included oxygenation index,lung compliance(Cst)and platform pressure(Pplat),which were compared between the two groups after ventilation.Other outcomes included heart rate(HR),mean arterial pressure(MAP),central venous pressure(CVP),left ventricular ejection fraction(LVEF),the length of mechanical ventilation time and intensive care unit(ICU)stay,and levels of C-reactive protein(CRP),procalcitonin(PCT),and interleukin-6(IL-6)after ventilation.Finally,mortality rate was also compared between the two groups.RESULTS On the first day after ventilation,the oxygenation index and Cst were higher and Pplat level was lower in the PPV group than in the conventional treatment group(P<0.05).There were no significant differences in oxygenation index,Cst,and Pplat levels between the two groups on the 2^(nd),4^(th),and 7^(th) day after ventilation(P>0.05).There were no significant differences in HR,MAP,CVP,LVEF,duration of mechanical ventilation and ICU stay,and the levels of CRP,PCT,and IL-6 between the two groups on the first day after ventilation(all P>0.05).The mortality rates on days 28 and 90 in the PPV and control groups were 12.77% and 29.09%,and 25.53% and 45.45%,respectively(P<0.05).CONCLUSION PPV may improve respiratory mechanics indices and may also have mortality benefit in patients with ARDS caused by sepsis.Finally,PPV was not shown to cause any adverse effects on hemodynamics and inflammation indices.

Hydrogen Permeation Performance of Ni-BaZr0.1Ce0.7Y0.2O3-δ Metal-Ceramic Hollow Fiber Membrane

一件稠密的 Ni-BaZr0.1Ce0.7Y0.2O3 (BZCY ) 金属陶瓷空纤维被阶段倒置方法在 5%H2/95%Ar 准备的 sintering NiO-BZCY 空纤维先锋制作，它的氢浸透表演被调查。Ni-BZCY 空纤维膜拥有“三明治”结构。指状的结构被观察两个都接近内部、外部的表面，当稠密的层在中心部分是在场的时。在壳方面和 150 mL/min 高度上与 200 mL/min 弄湿 20%H2/80%N2 核心方面上的纯净 Ar，通过在 900 p 的 Ni-BZCY

Effect of Ultrasound on Heterogeneous Nucleation in TIG Welding of Al–Li Alloy

The effect of ultrasound on heterogeneous nucleation in a tungsten inert gas(TIG) weld pool of 2195 Al–Li alloy has been investigated by a series of experiments. An ultrasonic vibration was imposed on the surface of base material before turning off the welding arc during the TIG welding implemented at a fixed point. The results suggest that ultrasound could promote heterogeneous nucleation in the TIG weld pool of 2195 Al–Li alloy. The grain around the fusion zone is changed from a column grain to an equiaxed grain after applying the ultrasonic treatment. To study the influencing mechanism of ultrasound on heterogeneous nucleation, further investigations were implemented where the welding arc was turned off after turning off the ultrasonic power. The results show that the equiaxed grain around the fusion zone disappeared gradually with an increase in heat input after turning off the ultrasonic power. It suggests that ultrasound could promote the heterogeneous nucleation particle to nucleate in advance before turning off the welding arc and the crystal nucleus could again be melted with an increase in heat input after turning off the ultrasonic power. Moreover, the effects of the welding current and ultrasonic amplitude on heterogeneous nucleation in the weld pool of 2195 Al–Li alloy were also investigated. Possible influencing mechanism of the welding current and ultrasonic amplitude on heterogeneous nucleation was discussed.

Small-scale spatial analysis of intermediate and definitive hosts of Angiostrongylus cantonensis

Background:Angiostrongyliasis is a food-borne parasitic zoonosis.Human infection is caused by infection with the third-stage larvae of Angiostrongylus cantonensis.The life cycle of A.cantonensis involves rodents as definitive hosts and molluscs as intermediate hosts.This study aims to investigate on the infection status and characteristics of spatial distribution of these hosts,which are key components in the strategy for the prevention and control of angiostrongyliasis.Methods:Three villages from Nanao Island,Guangdong Province,China,were chosen as study area by stratified random sampling.The density and natural infection of Pomacea canaliculata and various rat species were surveyed every three months from December 2015 to September 2016,with spatial correlations of the positive P.canaliculata and the infection rates analysed by ArcGIS,scan statistics,ordinary least squares(OLS)and geographically weighted regression(GWR)models.Results:A total of 2192 P.canaliculata specimens were collected from the field,of which 1190 were randomly chosen to be examined for third-stage larvae of A.cantonensis.Seventy-two Angiostrongylus-infected snails were found,which represents a larval infection rate of 6.1%(72/1190).In total,110 rats including 85 Rattus norvegicus,10 R.flavipectus,one R.losea and 14 Suncus murinus were captured,and 32 individuals were positive(for adult worms),representing an infection rate of 29.1%of the definitive hosts(32/110).Worms were only found in R.norvegicus and R.flavipectus,representing a prevalence of 36.5%(31/85)and 10%(1/10),respectively in these species,but none in R.losea and S.murinus,despite testing as many as 32 of the latter species.Statistically,spatial correlation and spatial clusters in the spatial distribution of positive P.canaliculata and positive rats existed.Most of the spatial variability of the host infection rates came from spatial autocorrelation.Nine spatial clusters with respect to positive P.canaliculata were identified,but only two correlated to infection rates.The results show that corrected Akaike information criterion,R2,R2 adjusted andσ2 in the GWR model were superior to those in the OLS model.Conclusions:P.canaliculata and rats were widely distributed in Nanao Island and positive infection has also been found in the hosts,demonstrating that there was a risk of angiostrongyliasis in this region of China.The distribution of positive P.canaliculata and rats exhibited spatial correlation,and the GWR model had advantage over the OLS model in the spatial analysis of hosts of A.cantonensis.

Effect of Ultrasonic Impact on the Microstructure of Welded Joint of 2195 Al–Li Alloy

It is known that an ultrasonic impact during tungsten inert gas welding can refine the grains and improve the mechanical properties of the welded joints of aluminum alloys. However, the influence mechanism of the ultrasonic impact on the microstructures is still unclear. In this research, the effects of the mechanical and ultrasonic impact on the microstructures of the welded joint of 2195 Al–Li alloy are analyzed. It is found that the mechanical impact could not refine the grains, but the ultrasonic impact could refine the grains. The grains become smaller in the weld center with an increase in the ultrasonic amplitude. Possible mechanisms for the grain refinement are discussed. The results show that the small temperature gradient promotes formation of the equiaxed grain and the cavitation promotes heterogeneous nucleation.

Efficacy of the combination of modern medicine and traditional Chinese medicine in pulmonary fibrosis arising as a sequelae in convalescent COVID-19 patients: a randomized multicenter trial

Background:The coronavirus disease 2019(COVID-19)caused by severe acute respiratory syndrome coronavirus-2(SARS-CoV-2)has led to a significant number of mortalities worldwide.COVID-19 poses a serious threat to human life.The clinical manifestations of COVID-19 are diverse and severe and 20%of infected patients are reported to be in a critical condition.A loss in lung function and pulmonary fibrosis are the main manifestations of patients with the severe form of the disease.The lung function is affected,even after recovery,thereby greatly affecting the psychology and well-being of patients,and significantly reducing their quality of life.