Roof falls in longwall headgate can occur when weak roof and high horizontal stress are present. To prevent roof falls in the headgate under high horizontal stress, it is important to understand the ground response to...Roof falls in longwall headgate can occur when weak roof and high horizontal stress are present. To prevent roof falls in the headgate under high horizontal stress, it is important to understand the ground response to high horizontal stress in the longwall headgate and the requirements for supplemental roof support. In this study, a longwall headgate under high horizontal stress was instrumented to monitor stress change in the pillars, deformations in the roof, and load in the cable bolts. The conditions in the headgate were monitored for about six months as the longwall face passed by the instrumented site.The roof behavior in the headgate near the face was carefully observed during longwall retreat.Numerical modeling was performed to correlate the modeling results with underground observation and instrumentation data and to quantify the effect of high horizontal stress on roof stability in the longwall headgate. This paper discusses roof support requirements in the longwall headgate under high horizontal stress in regard to the pattern of supplemental cable bolts and the critical locations where additional supplemental support is necessary.展开更多
The introduction of transconjunctival sutureless microincision vitrectomy surgery(MIVS)with 23-and25-gauge(23 and 25 G)instrumentation has virtually replaced the more antiquated 20-gauge equivalents,resulting in short...The introduction of transconjunctival sutureless microincision vitrectomy surgery(MIVS)with 23-and25-gauge(23 and 25 G)instrumentation has virtually replaced the more antiquated 20-gauge equivalents,resulting in shorter operation time,reduced展开更多
Longwall mining has a significant influence on gas wells located within longwall chain pillars.Subsurface subsidence and abutment pressure induced by longwall mining can cause excessive stresses and deformations in ga...Longwall mining has a significant influence on gas wells located within longwall chain pillars.Subsurface subsidence and abutment pressure induced by longwall mining can cause excessive stresses and deformations in gas well casings.If the gas well casings are compromised or ruptured,natural gas could migrate into the mine workings,potentially causing a fire or explosion.By the current safety regulations,the gas wells in the chain pillars have to be either plugged or protected by adequate coal pillars.The current regulations for gas well pillar design are based on the 1957 Pennsylvania gas well pillar study.The study provided guidelines for gas well pillars by considering their support area and overburden depth as well as the location of the gas wells within the pillars.As the guidelines were developed for room-andpillar mining under shallow cover,they are no longer applicable to modern longwall coal mining,particularly,under deep cover.Gas well casing of failures have occurred even though the chain pillars for the gas wells met the requirements by the 1957 study.This study,conducted by the National Institute for Occupational Safety and Health(NIOSH),presents seven cases of conventional gas wells penetrating through longwall chain pillars in the Pittsburgh Coal Seam.The study results indicate that overburden depth and pillar size are not the only determining factors for gas well stability.The other important factors include subsurface ground movement,overburden geology,weak floor,as well as the type of the construction of gas wells.Numerical modeling was used to model abutment pressure,subsurface deformations,and the response of gas well casings.The study demonstrated that numerical models are able to predict with reasonable accuracy the subsurface deformations in the overburden above,within,and below the chain pillars,and the potential location and modes of gas well failures,thereby providing a more quantifiable approach to assess the stability of the gas wells in longwall chain pillars.展开更多
Many states rely upon the Pennsylvania 1957 Gas Well Pillar Study to evaluate the coal barrier surrounding gas wells.The study included 77 gas well failure cases that occurred in the Pittsburgh and Freeport coal seams...Many states rely upon the Pennsylvania 1957 Gas Well Pillar Study to evaluate the coal barrier surrounding gas wells.The study included 77 gas well failure cases that occurred in the Pittsburgh and Freeport coal seams over a 25-year span.At the time,coal was mined using the room-and-pillar mining method with full or partial pillar recovery,and square or rectangle pillars surrounding the gas wells were left to protect the wells.The study provided guidelines for pillar sizes under different overburden depths up to 213 m(700 ft).The 1957 study has also been used to determine gas well pillar sizes in longwall mines since longwall mining began in the 1970 s.The original study was developed for room-and-pillar mining and could be applied to gas wells in longwall chain pillars under shallow cover.However,under deep cover,severe deformations in gas wells have occurred in longwall chain pillars.Presently,with a better understanding of coal pillar mechanics,new insight into subsidence movements induced by retreat mining,and advances in numerical modeling,it has become both critically important and feasible to evaluate the adequacy of the 1957 study for longwall gas well pillars.In this paper,the data from the 1957 study is analyzed from a new perspective by considering various factors,including overburden depth,failure location,failure time,pillar safety factor(SF),and floor pressure.The pillar SF and floor pressure are calculated by considering abutment pressure induced by full pillar recovery.A statistical analysis is performed to find correlations between various factors and helps identify the most significant factors for the stability of gas wells influenced by retreat mining.Through analyzing the data from the 1957 study,the guidelines for gas well pillars in the 1957 study are evaluated for their adequacy for roomand-pillar mining and their applicability to longwall mining.Numerical modeling is used to model the stability of gas wells by quantifying the mining-induced stresses in gas well casings.Results of this study indicate that the guidelines in the 1957 study may be appropriate for pillars protecting conventional gas wells in both room-and-pillar mining and longwall mining under overburden depths up to 213m(700 ft),but may not be sufficient for protective pillars under deep cover.The current evaluation of the 1957 study provides not only insights about potential gas well failures caused by retreat mining but also implications for what critical considerations should be taken into account to protect gas wells in longwall mining.展开更多
Background:The Retinal Function Imager(RFI)provides in vivo and noninvasive imaging of both the retinal structure and function.Review:The RFI can create capillary perfusion maps,measure blood flow velocity,and determi...Background:The Retinal Function Imager(RFI)provides in vivo and noninvasive imaging of both the retinal structure and function.Review:The RFI can create capillary perfusion maps,measure blood flow velocity,and determine metabolic function including blood oximetry.It can aid clinical diagnosis as well as assess treatment response in several retinal vascular diseases including diabetic retinopathy.Blood flow velocity abnormalities have also been implicated in disease such as age-related macular degeneration and require further investigation.Compared with optical coherence tomography angiography,the RFI produces capillary maps of comparable image quality and wider field of view but it is unable to provide depth-resolved information and has longer image acquisition time.Currently,functional imaging using blood oximetry has limited applications and additional research is required.Conclusion:The RFI offers noninvasive,high-resolution imaging of retinal microvasculature by creating capillary perfusion maps.In addition,it is capable of measuring retinal blood velocity directly and performs functional imaging with retinal blood oximetry.Its clinical applications are broad and additional research with functional imaging may potentially lead to diagnosis of diseases and their progression before anatomic abnormalities become evident,but longer image acquisition times may limit its clinical adoption.展开更多
文摘Roof falls in longwall headgate can occur when weak roof and high horizontal stress are present. To prevent roof falls in the headgate under high horizontal stress, it is important to understand the ground response to high horizontal stress in the longwall headgate and the requirements for supplemental roof support. In this study, a longwall headgate under high horizontal stress was instrumented to monitor stress change in the pillars, deformations in the roof, and load in the cable bolts. The conditions in the headgate were monitored for about six months as the longwall face passed by the instrumented site.The roof behavior in the headgate near the face was carefully observed during longwall retreat.Numerical modeling was performed to correlate the modeling results with underground observation and instrumentation data and to quantify the effect of high horizontal stress on roof stability in the longwall headgate. This paper discusses roof support requirements in the longwall headgate under high horizontal stress in regard to the pattern of supplemental cable bolts and the critical locations where additional supplemental support is necessary.
文摘The introduction of transconjunctival sutureless microincision vitrectomy surgery(MIVS)with 23-and25-gauge(23 and 25 G)instrumentation has virtually replaced the more antiquated 20-gauge equivalents,resulting in shorter operation time,reduced
文摘Longwall mining has a significant influence on gas wells located within longwall chain pillars.Subsurface subsidence and abutment pressure induced by longwall mining can cause excessive stresses and deformations in gas well casings.If the gas well casings are compromised or ruptured,natural gas could migrate into the mine workings,potentially causing a fire or explosion.By the current safety regulations,the gas wells in the chain pillars have to be either plugged or protected by adequate coal pillars.The current regulations for gas well pillar design are based on the 1957 Pennsylvania gas well pillar study.The study provided guidelines for gas well pillars by considering their support area and overburden depth as well as the location of the gas wells within the pillars.As the guidelines were developed for room-andpillar mining under shallow cover,they are no longer applicable to modern longwall coal mining,particularly,under deep cover.Gas well casing of failures have occurred even though the chain pillars for the gas wells met the requirements by the 1957 study.This study,conducted by the National Institute for Occupational Safety and Health(NIOSH),presents seven cases of conventional gas wells penetrating through longwall chain pillars in the Pittsburgh Coal Seam.The study results indicate that overburden depth and pillar size are not the only determining factors for gas well stability.The other important factors include subsurface ground movement,overburden geology,weak floor,as well as the type of the construction of gas wells.Numerical modeling was used to model abutment pressure,subsurface deformations,and the response of gas well casings.The study demonstrated that numerical models are able to predict with reasonable accuracy the subsurface deformations in the overburden above,within,and below the chain pillars,and the potential location and modes of gas well failures,thereby providing a more quantifiable approach to assess the stability of the gas wells in longwall chain pillars.
文摘Many states rely upon the Pennsylvania 1957 Gas Well Pillar Study to evaluate the coal barrier surrounding gas wells.The study included 77 gas well failure cases that occurred in the Pittsburgh and Freeport coal seams over a 25-year span.At the time,coal was mined using the room-and-pillar mining method with full or partial pillar recovery,and square or rectangle pillars surrounding the gas wells were left to protect the wells.The study provided guidelines for pillar sizes under different overburden depths up to 213 m(700 ft).The 1957 study has also been used to determine gas well pillar sizes in longwall mines since longwall mining began in the 1970 s.The original study was developed for room-and-pillar mining and could be applied to gas wells in longwall chain pillars under shallow cover.However,under deep cover,severe deformations in gas wells have occurred in longwall chain pillars.Presently,with a better understanding of coal pillar mechanics,new insight into subsidence movements induced by retreat mining,and advances in numerical modeling,it has become both critically important and feasible to evaluate the adequacy of the 1957 study for longwall gas well pillars.In this paper,the data from the 1957 study is analyzed from a new perspective by considering various factors,including overburden depth,failure location,failure time,pillar safety factor(SF),and floor pressure.The pillar SF and floor pressure are calculated by considering abutment pressure induced by full pillar recovery.A statistical analysis is performed to find correlations between various factors and helps identify the most significant factors for the stability of gas wells influenced by retreat mining.Through analyzing the data from the 1957 study,the guidelines for gas well pillars in the 1957 study are evaluated for their adequacy for roomand-pillar mining and their applicability to longwall mining.Numerical modeling is used to model the stability of gas wells by quantifying the mining-induced stresses in gas well casings.Results of this study indicate that the guidelines in the 1957 study may be appropriate for pillars protecting conventional gas wells in both room-and-pillar mining and longwall mining under overburden depths up to 213m(700 ft),but may not be sufficient for protective pillars under deep cover.The current evaluation of the 1957 study provides not only insights about potential gas well failures caused by retreat mining but also implications for what critical considerations should be taken into account to protect gas wells in longwall mining.
文摘Background:The Retinal Function Imager(RFI)provides in vivo and noninvasive imaging of both the retinal structure and function.Review:The RFI can create capillary perfusion maps,measure blood flow velocity,and determine metabolic function including blood oximetry.It can aid clinical diagnosis as well as assess treatment response in several retinal vascular diseases including diabetic retinopathy.Blood flow velocity abnormalities have also been implicated in disease such as age-related macular degeneration and require further investigation.Compared with optical coherence tomography angiography,the RFI produces capillary maps of comparable image quality and wider field of view but it is unable to provide depth-resolved information and has longer image acquisition time.Currently,functional imaging using blood oximetry has limited applications and additional research is required.Conclusion:The RFI offers noninvasive,high-resolution imaging of retinal microvasculature by creating capillary perfusion maps.In addition,it is capable of measuring retinal blood velocity directly and performs functional imaging with retinal blood oximetry.Its clinical applications are broad and additional research with functional imaging may potentially lead to diagnosis of diseases and their progression before anatomic abnormalities become evident,but longer image acquisition times may limit its clinical adoption.
