Lithium ferrite nanoparticles were synthesized by a sol-gel auto-combustion method. For prepared samples, the nanograins were increased with increasing the annealing temperature. Positron annihilation lifetime spectro...Lithium ferrite nanoparticles were synthesized by a sol-gel auto-combustion method. For prepared samples, the nanograins were increased with increasing the annealing temperature. Positron annihilation lifetime spectroscopy (PALS) was used to study defects at different sites for nanograins Li-ferrites. The analysis of the PAL spectrum indicated two lifetime components τ1 and τ2 for the annihilation of the positrons, and their corresponding relative intensities I1% and I2%. For nanoparticles Li-ferrite there are correlations between: 1) I2, τ2, annealing temperature and the total porosity (Pt) with the grain size;2) I1, μi, Ms and the homogeneity with grain size.展开更多
In this study, the main objective is to develop a good chelation and ion exchange hydrogel. This hydrogel is obtained by polymerization of dimethyl amino ethyl methacrylate (DMAEMA) and acrylic acid (AAc) by gamma irr...In this study, the main objective is to develop a good chelation and ion exchange hydrogel. This hydrogel is obtained by polymerization of dimethyl amino ethyl methacrylate (DMAEMA) and acrylic acid (AAc) by gamma irradiation, for the purpose of separation of some heavy and toxic metals from water. UV spectroscopy is applied to determine the metal ion concentration before and after treatment. The FTIR spectral analysis has identified the bond structure of PAAc, DMAEMA and P (DMAEMA/AAc) hydrogels. Microstructure and nanostructure are investigated by means of SEM and positron annihilation lifetime spectroscopy (PALS) respectively. A maximum swelling percent is found for 80/20 DMAEMA/AAc at free-volume hole size and fraction of 97?3 and 3.4% respectively. The P (DMAEMA/AAc) and PAAc hydrogels have been applied for Cu+2, Co+2 and Ni+2 removals from aqueous solutions, and the factors affecting the adsorption capacity are determined. The adsorption capacity of P (DMAEMA/AAc) is found to be higher than the corresponding ones PAAc. Its experimental results showed that, the maximum adsorption of P (DMAEMA/AAc) after 24 h occurs at pH 7 with concentration of 250 ppm for Ni+2 ions and at pH 5 with concentration of 40 ppm for Cu+2 and Co+2 ions. The adsorption affinity of P (DMAEMA/AAc) hydrogel at different treatment contact times is in the following order Ni > Cu > Co. However, the order becomes Co > Ni > Cu by the variation of the pH of the metal ion solution;the variation of its concentration leads to a different order of Cu > Co > Ni.展开更多
文摘Lithium ferrite nanoparticles were synthesized by a sol-gel auto-combustion method. For prepared samples, the nanograins were increased with increasing the annealing temperature. Positron annihilation lifetime spectroscopy (PALS) was used to study defects at different sites for nanograins Li-ferrites. The analysis of the PAL spectrum indicated two lifetime components τ1 and τ2 for the annihilation of the positrons, and their corresponding relative intensities I1% and I2%. For nanoparticles Li-ferrite there are correlations between: 1) I2, τ2, annealing temperature and the total porosity (Pt) with the grain size;2) I1, μi, Ms and the homogeneity with grain size.
文摘In this study, the main objective is to develop a good chelation and ion exchange hydrogel. This hydrogel is obtained by polymerization of dimethyl amino ethyl methacrylate (DMAEMA) and acrylic acid (AAc) by gamma irradiation, for the purpose of separation of some heavy and toxic metals from water. UV spectroscopy is applied to determine the metal ion concentration before and after treatment. The FTIR spectral analysis has identified the bond structure of PAAc, DMAEMA and P (DMAEMA/AAc) hydrogels. Microstructure and nanostructure are investigated by means of SEM and positron annihilation lifetime spectroscopy (PALS) respectively. A maximum swelling percent is found for 80/20 DMAEMA/AAc at free-volume hole size and fraction of 97?3 and 3.4% respectively. The P (DMAEMA/AAc) and PAAc hydrogels have been applied for Cu+2, Co+2 and Ni+2 removals from aqueous solutions, and the factors affecting the adsorption capacity are determined. The adsorption capacity of P (DMAEMA/AAc) is found to be higher than the corresponding ones PAAc. Its experimental results showed that, the maximum adsorption of P (DMAEMA/AAc) after 24 h occurs at pH 7 with concentration of 250 ppm for Ni+2 ions and at pH 5 with concentration of 40 ppm for Cu+2 and Co+2 ions. The adsorption affinity of P (DMAEMA/AAc) hydrogel at different treatment contact times is in the following order Ni > Cu > Co. However, the order becomes Co > Ni > Cu by the variation of the pH of the metal ion solution;the variation of its concentration leads to a different order of Cu > Co > Ni.