In this paper a preliminary investigation of a novel optoelectronic polymer, poly (p-phenylene N-4-n-butylphenyl-N,N-bis- 4-vinylenephenylamine) (PNB), is reported. A single layer structure of ITO/PNB/Al was prepared ...In this paper a preliminary investigation of a novel optoelectronic polymer, poly (p-phenylene N-4-n-butylphenyl-N,N-bis- 4-vinylenephenylamine) (PNB), is reported. A single layer structure of ITO/PNB/Al was prepared via spin-coating of PNB solution as a thin film on the top of an ITO substrate, while aluminum top electrode was vacuum evaporated. Dark current- voltage characteristics of this device showed a typical rectifying behaviour. Photovoltaic response under a monochromatic illumination at 420 nm was observed, with an open circuit voltage of 0.3 V and fill factor of 0.21. Spectral response and optical absorption were found to be matched well. It was also discovered that the device showed a green electroluminescent emission at a forward bias. Turn-on voltage of the device was about 6 V and light output about 22.6 nW at a forward bias of 10 V. The work demonstrated that the PNB material might possess dual exciton sites resulting in a competition for excitons to be either separated or recombined. Both effects were associated with each other, which limited the photovoltaic or electroluminescence to some degrees.展开更多
This paper reports an investigation on the electrical properties of thin film devices made by Copper(II) phthalocyanine derivative and polycarbonate (PC) composite. The conducting and injection mechanism are further d...This paper reports an investigation on the electrical properties of thin film devices made by Copper(II) phthalocyanine derivative and polycarbonate (PC) composite. The conducting and injection mechanism are further discussed. Materials of a variety composition were prepared into the thin film via spin-coating. ITO and aluminum were used as the bottom and top electrode respectively. J-V characteristic was measured and the result demonstrates that at a small bias region an Ohmic contact was achieved. As the forward bias increased, the current became space charge limited. The result of AC impedance measurement indicates the device could be equivalent to a parallel RC system. The introduction of PC into the CuPc possibly reduces the charge overlapping between the aromatic rings and led to a reduction in the molecular interaction. Hence, the ac conductivity decreases sharply as PC composition increases. But no change in the transport mechanism is found.展开更多
基金This work is supported by National Natural Science Foundationof China(20344002,10434030) State Key Program forBasic research of China (2003CB314707)
文摘In this paper a preliminary investigation of a novel optoelectronic polymer, poly (p-phenylene N-4-n-butylphenyl-N,N-bis- 4-vinylenephenylamine) (PNB), is reported. A single layer structure of ITO/PNB/Al was prepared via spin-coating of PNB solution as a thin film on the top of an ITO substrate, while aluminum top electrode was vacuum evaporated. Dark current- voltage characteristics of this device showed a typical rectifying behaviour. Photovoltaic response under a monochromatic illumination at 420 nm was observed, with an open circuit voltage of 0.3 V and fill factor of 0.21. Spectral response and optical absorption were found to be matched well. It was also discovered that the device showed a green electroluminescent emission at a forward bias. Turn-on voltage of the device was about 6 V and light output about 22.6 nW at a forward bias of 10 V. The work demonstrated that the PNB material might possess dual exciton sites resulting in a competition for excitons to be either separated or recombined. Both effects were associated with each other, which limited the photovoltaic or electroluminescence to some degrees.
基金National Natural Science Foundation ofChina (20674004 and 10434030), State Key Program for BasicResearch of China (2003CB314707), and Lab of Printing & Pack-aging Material & Technology - Beijing Area Major Laboratory, Openproject (KF060303).
文摘This paper reports an investigation on the electrical properties of thin film devices made by Copper(II) phthalocyanine derivative and polycarbonate (PC) composite. The conducting and injection mechanism are further discussed. Materials of a variety composition were prepared into the thin film via spin-coating. ITO and aluminum were used as the bottom and top electrode respectively. J-V characteristic was measured and the result demonstrates that at a small bias region an Ohmic contact was achieved. As the forward bias increased, the current became space charge limited. The result of AC impedance measurement indicates the device could be equivalent to a parallel RC system. The introduction of PC into the CuPc possibly reduces the charge overlapping between the aromatic rings and led to a reduction in the molecular interaction. Hence, the ac conductivity decreases sharply as PC composition increases. But no change in the transport mechanism is found.
