Performance and mechanism of CO_(2) absorption during the simultaneous removal of SO_(2) and NO_(x) by wet scrubbing process

The co-removal of CO_(2)while removing SO_(2)and NOxfrom industrial flue gas has great potential of carbon emission reduction but related research is lacking.In this study,a wet scrubbing process with various urea solutions for desulfurization and denitrification was explored for the possibility of CO_(2)absorption.The results showed that the urea-additive solutions were efficient for NOxand SO_(2)abatement,but delivered<10%CO_(2)absorption efficiency.The addition of Ca(OH)_(2)dramatically enhanced the CO_(2)absorption,remained the desulfurization efficiency,unfortunately restricted the denitrification efficiency.Among various operating parameters,pH of solution played a determining role during the absorption.The contradictory pH demands of CO_(2)absorption and denitrification were observed and discussed in detail.A higher pH of solution than 10 was favorable for CO_(2)absorption,while the oxidizing of NO to NO_(2),NO_(2)^(-)or NO_(3)^(-)by NaClO_(2)was inhibited in this condition.When7<pH<10,it was favorable for the conversion and absorption of NO and NOx.However,the conversion of HCO_(3)^(-)to CO_(3)^(2-)was significantly inhibited,hence preventing the absorption of CO_(2).Large part of Ca(OH)_(2)became CaCO_(3)with a finer particle size,which covered the unreacted Ca(OH)_(2)surface after the reaction.Kinetic analysis showed that the CO_(2)absorption in urea-NaClO_(2)-Ca(OH)_(2)absorbent was controlled by chemical reaction in early stage,then by ash layer diffusion in later stage.

Low-cost and high safe manganese-based aqueous battery for grid energy storage and conversion

As an effective energy storage technology, rechargeable batteries have long been considered as a promising solution for grid integration of intermittent renewables(such as solar and wind energy). However,their wide application is still limited by safety issue and high cost. Herein, a new battery chemistry is proposed to satisfy the requirements of grid energy storage. We report a simple Cu-Mn battery, which is composed of two separated current collectors in an H2SO4-CuSO4-MnSO4 electrolyte without using any membrane. The Cu-Mn battery shows an energy density of 40.8 Wh L-1, a super-long life of 10,000 cycles(without obvious capacity decay) and negligible self-discharge. And the capital cost of US$ 11.9 kWh-1 based on electrolyte is lower than any previous batteries. More importantly, the battery can still work smoothly during thermal abuse test and drill-through test, showing high safe nature. Furthermore, a combination system integrating the Cu-Mn battery and hydrogen evolution is also proposed, which is able to avoid the generation of explosive H2/O2 mixture, and presents an efficient approach for grid energy storage and conversion.