Microstructure control and hot cracking behavior of the new Ni-Co based superalloy prepared by electron beam smelting layered solidification technology

The prevention of hot cracking formation is of utmost importance in the production of the new Ni-Co based superalloys through the utilization of the electron beam smelting layered solidification technique(EBSL),as it ensures exceptional homogeneity and dependable consistency of the specimens.In contrast to previous studies that focused on minimizing the liquid film and solidification range,our methodology adopts a distinct approach.In this research,a novel methodology was employed to mitigate internal stresses through the implementation of equiaxed grain layers via an alternately reduced cooling method.This ultimately resulted in the elimination of hot cracking.To be more specific,the transition from a columnar to an equiaxed structure was observed during the layer-by-layer construction process in the fabrication of the new Ni-Co based superalloy in EBSL.The EBSL-Ni-Co superalloy,when subjected to the alternating reduction cooling method,exhibited an internal stress of 49 MPa.This value represents a significant reduction of 83.8%compared to the internal stress observed when employing the linear reduction cooling method.Additionally,the solvus temperature of theγ-γ’eutectic phases in EBSL-Ni-Co superalloys produced by the alternating reduction cooling method is significantly higher.Intriguingly,the Nth layer of the EBSL-Ni-Co based superalloys produced by EBSL simultaneously heats treated with the preceding layers.And the low melting point phase gradually dissolved back into the matrix.The implementation of an alternating reduced cooling method successfully mitigated the formation of the liquid film in theγ-γ’eutectic phase and the buildup of internal stresses in the EBSL-Ni-Co superalloy during its manufacturing process.These discoveries open up a novel preparation procedure pathway for the manufacture of crack-free superalloys with superior mechanical characteristics using EBSL.

Recrystallization Behavior of the New Ni-Co-Based Superalloy with Fusion Structure Produced by Electron Beam Smelting Layered Solidification Technology

The new Ni-Co-based superalloy featuring a"fusion structure"was produced utilizing electron beam smelting layered solidification technology(EBSL).Experimental examination of hot compression deformation with varied settings for EBSL and conventional duplex process melting Ni-Co superalloys was performed.As per the study,EBSL-Ni-Co superalloys exhibited enhanced recrystallization susceptibility during hot deformation.Furthermore,elevating deformation temperature,lowering strain rate,and augmenting strain collectively contribute to enlarging the volume fraction of dynamically recrystallized grains.Aberrant growth of grains occurred when the deformation temperature equaledγ′sub-solvus temperature and the strain rate was slower.Moreover,exceeding theγ′solvus temperature during deformation significantly increases the particle size of dynamic recrystallization(DRX)grains.Theγ′phase can effectively modulate the DRX grain size through the pegging effect.Additionally,it was revealed that the presence of the fusion structure aids in the generation of continuous dynamic recrystallization,discontinuous dynamic recrystallization,and twinning-induced dynamic recrystallization while the alloy undergoes hot deformation.This mechanism promotes DRX granule formation and permits complete recrystallization.Ultimately,the fusion structure was identified as playing a catalytic role in the dynamic recrystallization process of the new Ni-Co superalloy.