Control and Implementation of Single-Inverter Microgrid

In this paper, simulation and implementation way for practical control of Single Inverter Microgrid (SIMG) is presented. This system is equipped by solar system, wind energy conversion system (WECS), and microturbine system. Each DG’s has controlled independently. This is a kind of decentralize control because each DG’s has difference controller. Control of Microgrid (MG) during both grid tie and islanding modes is presented. Solar system and WECS are modeled based on santerno products. This system is compared with three inverter MGs with Centralize control strategy. Controlled signals show that SIMG is more reliable and economical. THD is improved and strategy is simplified for SIMG.

Design a Collector with More Reliability against Defects during Manufacturing in Nanometer Technology, QCA

Nowadays Quantum Cellular Automata (QCA) as the leading technology in design of microelectronic systems has been raised. With respect to high velocity and density in low power and also simple concepts, this technology is a viable alternative to CMOS technology. In collector design, the primary component of each processor is very important. Due to the small elements in this technology, failure rate in manufacturing process technology is very high. In the other hand, the simulation shows that the intersection point of two wires is one of the critical points in QCA circuits. This means that defects in the manufacturing process around these points can cause malfunction in the circuit performance. In this paper, a collector in cross sections of wire in his new method used higher reliability against defects during manufacturing has been developed. QCA Designer software is used to simulate the case study system.

Modeling, Control &Fault Management of Microgrids

In this paper, modeling and decentralize control principles of a MicroGrid (MG) whom equipped with three Distributed Generation (DG) systems (consist of: Solar Cell System (SCS), MicroTurbine System (MTS) and Wind Energy Conversion System (WECS)) is simulated. Three arrangement of load changing have investigated for the system. In first one the system doesn’t have transfer of power between MG and grid. In other two arrangements system have transfer of power between MG and utility grid. Of course in third case transfer of power between DG resources is considerable. Case study system is equipped by energy storage devices (battery bank) for each DG’s separately by means of increasing the MG reliability. For WECS and SCS, MPPT control and for MTS, voltage and frequency (V&F) controller has designed. The purpose of this paper is load respond in MG and storage process of surplus energy by consider of load changing. MATLAB/Simulink and its libraries (mainly the Sim Power Systems toolbox) were employed in order to develop a simulation platform suitable for identifying MG control requirements. This paper reported a control and op- eration of MG in network tension by applying a three phase fault.