Measurement of surface shear stress vector distribution using shear-sensitive liquid crystal coatings

The global wall shear stress measurement tech- nique using shear-sensitive liquid crystal （SSLC） is extended to wind tunnel measurements. Simple and common every- day equipment is used in the measurement; in particular a tungsten-halogen light bulb provides illumination and a saturation of SSLC coating color change with time is found. Spatial wall shear stress distributions of several typical flows are obtained using this technique, including wall-jet flow, vortex flow generated by a delta wing and junction flow behind a thin cylinder, although the magnitudes are not fully calibrated. The results demonstrate that SSLC technique can be extended to wind tunnel measurements with no complicated facilities used.

Process Design for Hybrid Sheet Metal Components

The global trends towards improving fuel efficiency and reducing CO;emissions are the key drivers for lightweight solutions. In sheet metal processing, this can be achieved by the use of materials with a supreme strength-toweight and stiffness-to-weight ratio. Besides monolithic materials such as high-strength or light metals, in particular metal–plastic composite sheets are able to provide outstanding mechanical properties. Thus, the adaption of conventional, wellestablished forming methods for the processing of hybrid sheet metals is a current challenge for the sheet metal working industry. In this work, the planning phase for a conventional sheet metal forming process is studied aiming at the forming of metal–plastic composite sheets. The single process steps like material characterization, FE analysis, tool design and development of robust process parameters are studied in detail and adapted to the specific properties of metal–plastic composites. In material characterization, the model of the hybrid laminate needs to represent not only the mechanical properties of the individual combined materials, but also needs to reflect the behaviour of the interface zone between them.Based on experience, there is a strong dependency on temperature as well as strain rate. While monolithic materials show a moderate anisotropic behaviour, loads on laminates in different directions generate different strain states and completely different failure modes. During the FE analysis, thermo-mechanic and thermo-dynamic effects influence the temperature distribution within tool and work pieces and subsequently the forming behaviour. During try out and production phase,those additional influencing factors are limiting the process window even more and therefore need to be considered for the design of a robust forming process. A roadmap for sheet metal forming adjusted to metal–plastic composites is presented in this paper.