The viscosity of CaF_2-CaO-Al_2O_3-MgO-（TiO_2） slag was measured using a rotating crucible viscometer. Raman spectroscopy analysis was performed to correlate the viscosity to slag structure. The viscosity of the sla...The viscosity of CaF_2-CaO-Al_2O_3-MgO-（TiO_2） slag was measured using a rotating crucible viscometer. Raman spectroscopy analysis was performed to correlate the viscosity to slag structure. The viscosity of the slag was found to decrease with increasing TiO_2 content in the slag from 0 to 9.73wt%. The activation energy decreased from 95.16 kJ /mol to 79.40 kJ /mol with increasing TiO_2 content in the slag. The introduction of TiO_2 into the slag played a destructive role in Al-O-Al structural units and Q^4 units by forming simpler structural units of Q^2 and Ti_2O_6^（4-） chain. The amount of Al-O-Al significantly decreased with increasing TiO_2 content. The relative fraction of Q^4 units in the [AlO_4]^（5-）-tetrahedral units shows a decreasing trend, whereas the relative fraction of Q^2 units and Ti_2O_6^（4-） chain increases with increasing TiO_2 content accordingly. Consequently, the polymerization degree of the slag decreases with increasing TiO_2 content. The variation in slag structure is consistent with the change in measured viscosity.展开更多
This study evaluated the application of a continuous-flow photocatalytic reactor for the control of two mobile-derived pollutants, methyl-tertiary butyl ether （MTBE） and naphthalene, present at in-vehicle levels. Va...This study evaluated the application of a continuous-flow photocatalytic reactor for the control of two mobile-derived pollutants, methyl-tertiary butyl ether （MTBE） and naphthalene, present at in-vehicle levels. Variables tested for this study included the hydraulic diameter （HD）, stream flow rate （SFR）, relative humidity （RH）, and feeding type （FT）. The fixed parameters included contaminant concentration, ultraviolet light source, and the weight of TiO2. In all experimental conditions the adsorption process reached equilibrium within 30 to 180 min for the target compounds, and the outlet concentrations of the photocatalytic oxidation （PCO） reactor while operating reached a steady state within 60 to 180 min. The degradation of the target compounds was dependent on RH, HD, FT, or SFR. The PCO system exhibited high degradation （up to nearly 100% for certain conditions） and mineralization efficiencies of target compounds, suggesting that this system can effiectively be employed to improve indoor air quality. Moreover, it was confirmed that trichloroethylene at urban-ambient level also could enhance the degradation efficiency of naphthalene when applying the PCO technology inside vehicles.展开更多
基金financially supported by the Fundamental Research Funds for the Central Universities (Grant No. FRF-TP-15-010A2)China Postdoctoral Science Foundation (Grant No. 2016T90035)
文摘The viscosity of CaF_2-CaO-Al_2O_3-MgO-（TiO_2） slag was measured using a rotating crucible viscometer. Raman spectroscopy analysis was performed to correlate the viscosity to slag structure. The viscosity of the slag was found to decrease with increasing TiO_2 content in the slag from 0 to 9.73wt%. The activation energy decreased from 95.16 kJ /mol to 79.40 kJ /mol with increasing TiO_2 content in the slag. The introduction of TiO_2 into the slag played a destructive role in Al-O-Al structural units and Q^4 units by forming simpler structural units of Q^2 and Ti_2O_6^（4-） chain. The amount of Al-O-Al significantly decreased with increasing TiO_2 content. The relative fraction of Q^4 units in the [AlO_4]^（5-）-tetrahedral units shows a decreasing trend, whereas the relative fraction of Q^2 units and Ti_2O_6^（4-） chain increases with increasing TiO_2 content accordingly. Consequently, the polymerization degree of the slag decreases with increasing TiO_2 content. The variation in slag structure is consistent with the change in measured viscosity.
基金supported by the Regional Industrial Technology Development Project of Kore-an Ministry of Commerce, Industry and Energy (No.10017410: C-11-55)
文摘This study evaluated the application of a continuous-flow photocatalytic reactor for the control of two mobile-derived pollutants, methyl-tertiary butyl ether （MTBE） and naphthalene, present at in-vehicle levels. Variables tested for this study included the hydraulic diameter （HD）, stream flow rate （SFR）, relative humidity （RH）, and feeding type （FT）. The fixed parameters included contaminant concentration, ultraviolet light source, and the weight of TiO2. In all experimental conditions the adsorption process reached equilibrium within 30 to 180 min for the target compounds, and the outlet concentrations of the photocatalytic oxidation （PCO） reactor while operating reached a steady state within 60 to 180 min. The degradation of the target compounds was dependent on RH, HD, FT, or SFR. The PCO system exhibited high degradation （up to nearly 100% for certain conditions） and mineralization efficiencies of target compounds, suggesting that this system can effiectively be employed to improve indoor air quality. Moreover, it was confirmed that trichloroethylene at urban-ambient level also could enhance the degradation efficiency of naphthalene when applying the PCO technology inside vehicles.
