Effect of overburden pressure on determination of reservoir rock types using RQI/FZI,FZI^* and Winland methods in carbonate rocks

Rock typing is an important tool in evaluation and performance prediction of reservoirs.Different techniques such as flow zone indicator(FZI),FZI~*and Winland methods are used to categorize reservoir rocks into distinct rock types.Generally,these methods are applied to petrophysical data that are measured at a pressure other than reservoir pressure.Since the pressure changes the pore structure of rock,the effect of overburden pressure on rock typing should be considered.In this study,porosity and permeability of 113 core samples were measured at five different pressures.To investigate the effect of pressure on determination of rock types,FZI,FZI~*and Winland methods were applied.Results indicated that although most of the samples remain in the same rock type when pressure changes,some of them show different trends.These are related to the mineralogy and changes in pore system of the samples due to pressure change.Additionally,the number of rock types increases with increasing pressure.Furthermore,the effect of overburden pressure on determination of rock types is more clearly observed in the Winland and FZI~*methods.Also,results revealed that a more precise reservoir dynamic simulation can be obtained by considering the reservoir rock typing process at reservoir conditions.

Pore-scale study of the effects of DTPA chelating agent flooding on oil recovery utilizing a clay-coated micromodel

The use of diethylenetriaminepentaacetic acid(DTPA)chelating agent has shown promising results for enhanced oil recovery(EOR)in prior research.Several mechanisms,mainly resulting from rock-fluid interaction,have been proposed for chelating agent flooding;however,little attention has been paid to fluid-fluid interaction thus far.The assessment of these mechanisms has primarily relied on macroscopic techniques such as core flooding.This paper aims to investigate the injection of DTPA brine and its dominant mechanisms at the pore scale using a clay-coated micromodel.The micromodel tests were performed under oil-wet and water-wet states.For a more precise examination of fluid/fluid interactions,the dynamic interfacial tension(IFT)and Zeta potential were measured.It was observed that the injection of DTPA brine in water-wet state changed the saturation distribution and increased oil recovery.Based on visual inspections,this change in saturation distribution could potentially be linked to the formation of micro-dispersions and viscoelastic interfacial phenomena.Micro-dispersions facilitate flow to unswept areas,and viscoelastic interface formation reshapes the interface between oil and brine,causing disconnected oil droplets to coalesce and thus increase recovery.Under the oil-wet state,the micro-dispersion formation and wettability alteration can be the dominant mechanisms,and the amount of recovered oil was higher than that observed in the water-wet state.Furthermore,Zeta potential measurements at the interface between brine and oil showed a more negative value for DTPA brine,which is effective in wettability alteration and micro-dispersions stability.The results indicate that IFT reduction was not significant enough to be considered the dominant mechanism,although it assists in DTPA brine penetration into the crude oil and subsequent micro-dispersion formation.